USGS Science⌕ Search
Home/Archive/USGS

USGS · 70021558

Reaeration equations derived from U.S. geological survey database

Charles S. Melching·H.E. Flores
View original source ↗Export metadata ↓

Abstract

Accurate estimation of the reaeration-rate coefficient (K2) is extremely important for waste-load allocation. Currently, available K2 estimation equations generally yield poor estimates when applied to stream conditions different from those for which the equations were derived because they were derived from small databases composed of potentially highly inaccurate measurements. A large data set of K2 measurements made with tracer-gas methods was compiled from U.S. Geological Survey studies. This compilation included 493 reaches on 166 streams in 23 states. Careful screening to detect and eliminate erroneous measurements reduced the date set to 371 measurements. These measurements were divided into four subgroups on the basis of flow regime (channel control or pool and riffle) and stream scale (discharge greater than or less than 0.556 m3/s). Multiple linear regression in logarithms was applied to relate K2 to 12 stream hydraulic and water-quality characteristics. The resulting best-estimation equations had the form of semiempirical equations that included the rate of energy dissipation and discharge or depth and width as variables. For equation verification, a data set of K2 measurements made with tracer-gas procedures by other agencies was compiled from the literature. This compilation included 127 reaches on at least 24 streams in at least seven states. The standard error of estimate obtained when applying the developed equations to the U.S. Geological Survey data set ranged from 44 to 61%, whereas the standard error of estimate was 78% when applied to the verification data set.Accurate estimation of the reaeration-rate coefficient (K2) is extremely important for waste-load allocation. Currently, available K2 estimation equations generally yield poor estimates when applied to stream conditions different from those for which the equations were derived because they were derived from small databases composed of potentially highly inaccurate measurements. A large data set of K2 measurements made with tracer-gas methods was compiled from U.S. Geological Survey studies. This compilation included 493 reaches on 166 streams in 23 states. Careful screening to detect and eliminate erroneous measurements reduced the data set to 371 measurements. These measurements were divided into four subgroups on the basis of flow regime (channel control or pool and riffle) and stream scale (discharge greater than or less than 0.556 m3/s). Multiple linear regression in logarithms was applied to relate K2 to 12 stream hydraulic and water-quality characteristics. The resulting best-estimation equations had the form of semiempirical equations that included the rate of energy dissipation and discharge or depth and width as variables. For equation verification, a data set of K2 measurements made with tracer-gas procedures by other agencies was compiled from the literature. This compilation included 127 reaches on at least 24 streams in at least seven states. The standard error of estimate obtained when applying the developed equations to the U.S. Geological Survey data set ranged from 44 to 61%, whereas the standard error of estimate was 78% when applied to the verification data set.

Explore related subjects

Journal of Environmental EngineeringArticle

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Charles S. Melching, H.E. Flores. 1999. Reaeration equations derived from U.S. geological survey database. https://doi.org/10.1061/(asce)0733-9372(1999)125%3A5(407)

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS2023

Evaluation of hydrodynamic mixing in an afterbay reservoir

This study focused on the mixing of a solute, assumed to be conservative, introduced to one arm of an afterbay reservoir, between Keswick and Shasta Dams on the Sacramento River near Redding, California. Rhodamine water tracer (WT) dye served as the solute in a field experiment, and was introduced over 4.5 h and monitored for 4 days by sondes moored in the reservoir. The scenario was modeled numerically using the Delft3D flexible mesh (FM) hydrodynamic and mixing model, with measured inflows, outflows, water level, water temperatures, and bathymetry as input. Manning’s n "> n and horizontal eddy viscosity served as the (constant) model calibration parameters, and each was adjusted an order of magnitude below the default values to force observed and modeled dye hydrographs to match in arrival time and duration. The low friction factor was concluded to be due to a combination of low flow speeds coupled with energy dissipation inherent to the model. The model and surface drifters equipped with dual-frequency Global Navigation Satellite System equipment revealed velocities in the 1 – 5    cm / s "> 1 – 5 cm / s range in much of the domain during the experiment. Simple analytical expressions were shown to be useful for estimating distance to full cross-sectional mixing, steady-state concentrations, and time to reach them, but the numerical model is required for investigation of the approach to steady state, and at locations where flows intersect. Time to steady-state concentrations was 1.5–13 days for 10 simulations that spanned a wide range of inflow conditions. Model sensitivity tests suggest that wind and heat fluxes were not important during the field study, but simulations of a summer scenario with small inflows of cold water upstream in warm weather should consider water temperature. Both field observations and numerical model results showed inflow to one arm of the reservoir reaching full cross-sectional mixing before plunging below the water surface near the intersection of this arm with the reservoir’s main stem. Model results are being used to guide management decisions related to inflows to the reservoir from a relic mining site that is also a USEPA Superfund site.

California↗
USGS2022

Performance of a carbon dioxide injection system at a navigation lock to control the spread of aquatic invasive species

Natural resource agencies need effective strategies to control the spread of aquatic invasive species (AIS) such as invasive fish, which can expand their range using rivers as hydrological pathways to access new areas. Lock and dam structures within major rivers are prospective locations to deploy techniques, such as carbon dioxide ( CO 2 ) infusion into lock water, that could impede upstream AIS migration without disrupting vessel passage and lock operation. The current pesticide label for CO 2 in the United States allows injections of 100–150 mg/LCO 2 as a behavioral deterrent treatment for invasive carps. This research describes the first operationalizing and testing of a CO 2 injection and manifold distribution system at a 1,548,000-L navigation lock chamber on the Fox River near Kaukauna, Wisconsin, USA. Two chemical distribution manifolds located on the floor and wall of the chamber were independently tested to quantify mixing time, mixing homogeneity, injection efficiency, and operational power requirements under a range of operating parameters. Both manifold configurations were able to meet most performance benchmarks established during previous fish behavior studies. Certain limitations were exhibited and quantified for both manifold configurations in terms of mixing homogeneity and operational power. This research details the design and performance of CO2-to-water infusion systems that could be used to deter the spread of AIS at navigation pinch-points. These results may inform future CO 2 system designs and operating conditions to support natural resource management plans to limit the spread of AIS.

Wisconsin↗
USGS2020

Comparison of SELDM simulated total-phosphorus concentrations with ecological impervious-area criteria

Ecological studies indicate that impervious cover (IC) greater than approximately 5%–20% may have adverse effects on receiving-stream ecology. It is difficult to separate the effects of runoff quality from other effects of urbanization on receiving streams. This study presents the results of a numerical experiment to assess the effects of increasing IC on water quality using the Stochastic Empirical Loading and Dilution Model (SELDM). Hydrologic and physiographic variables representative of southern New England were used to simulate receiving water quality in a basin with IC ranging from 0.1% to 30%. Simulation results mirror the results of ecological studies; event mean concentrations (EMCs) of total phosphorus (TP) increase proportionally to the logarithms of imperviousness for a given risk percentile. Simulation results indicated that commonly used stormwater treatment methods may be insufficient for mitigating the effects of imperviousness. Therefore, disconnection, rather than treatment, may be needed to protect water quality, and efforts to preserve undeveloped stream basins may be more effective than efforts to remediate conditions in highly developed basins. Results also indicate that commonly used water-quality criteria may be too restrictive for stormwater because TP EMCs frequently exceed these criteria, even in minimally developed basins.

Journal of Environmental Engineering↗