USGS Science⌕ Search

USGS · 70021088

Use of fault striations and dislocation models to infer tectonic shear stress during the 1995 Hyogo-Ken Nanbu (Kobe) earthquake

Abstract

Dislocation models of the 1995 Hyogo-ken Nanbu (Kobe) earthquake derived by Yoshida et al. (1996) show substantial changes in direction of slip with time at specific points on the Nojima and Rokko fault systems, as do striations we observed on exposures of the Nojima fault surface on Awaji Island. Spudich (1992) showed that the initial stress, that is, the shear traction on the fault before the earthquake origin time, can be derived at points on the fault where the slip rake rotates with time if slip velocity and stress change are known at these points. From Yoshida's slip model, we calculated dynamic stress changes on the ruptured fault surfaces. To estimate errors, we compared the slip velocities and dynamic stress changes of several published models of the earthquake. The differences between these models had an exponential distribution, not gaussian. We developed a Bayesian method to estimate the probability density function (PDF) of initial stress from the striations and from Yoshida's slip model. Striations near Toshima and Hirabayashi give initial stresses of about 13 and 7 MPa, respectively. We obtained initial stresses of about 7 to 17 MPa at depths of 2 to 10 km on a subset of points on the Nojima and Rokko fault systems. Our initial stresses and coseismic stress changes agree well with postearthquake stresses measured by hydrofracturing in deep boreholes near Hirabayashi and Ogura on Awaji Island. Our results indicate that the Nojima fault slipped at very low shear stress, and fractional stress drop was complete near the surface and about 32% below depths of 2 km. Our results at depth depend on the accuracy of the rake rotations in Yoshida's model, which are probably correct on the Nojima fault but debatable on the Rokko fault. Our results imply that curved or cross-cutting fault striations can be formed in a single earthquake, contradicting a common assumption of structural geology.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 34.45605646653874° to 34.880736815877626° latitude; 134.38242996352392° to 135.64585769789886° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

P. Spudich, Mariagiovanna Guatteri, K. Otsuki, J. Minagawa. 1998-04-01. Use of fault striations and dislocation models to infer tectonic shear stress during the 1995 Hyogo-Ken Nanbu (Kobe) earthquake. https://doi.org/10.1785/bssa0880020413

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Re-evaluation of shaking, dynamic strain, and the source of the 1886 Charleston, South Carolina, earthquake

As the largest historical event in the eastern United States, the 1886 Charleston, South Carolina, earthquake, plays a prominent role in our nation’s seismological and human history and an outsized role in our probabilistic ground‐motion hazard estimates, affecting building codes, insurance rates, and geophysical monitoring. Thus, constraining the characteristics of the 1886 earthquake source, as well as the nature of its shaking distribution and impacts to the extent possible, is essential. Given its vintage, however, societal, geological, and geophysical datasets are limited compared with those used in modern seismological analyses. Because of these limitations, some characteristics of the rupture model are fundamentally nonunique. Still, by re‐evaluating all available data, I can constrain several key aspects of this earthquake. I show that several interpretations in recent analyses are inconsistent regarding the inferred source; shaking; ground failure; and, particularly, railway impacts. Importantly, I have shown that although dynamic strain caused the ground failure that led to track deformation, without the intermediate liquefaction step, dynamic strain alone was unlikely to be the source of rail deformation, contrary to earlier studies. Had earlier pronouncements that dynamic strain is a real concern for bending railways held true, there would be serious ramifications for railway engineering as well as for other above‐ and below‐ground linear infrastructure.

South Carolina↗

ETAS-positive: Extracting unbiased epidemic-type aftershock models from incomplete earthquake catalogs

Earthquake catalogs are inherently incomplete, and short-term fluctuations in catalog completeness can strongly bias estimates of seismicity parameters. Here, we extend the positive statistics framework recently introduced for estimating Gutenberg–Richter a and b values to the Epidemic-Type Aftershock Sequence (ETAS) model. The approach focuses on complete magnitude–time intervals defined by pairs of earthquakes in which the second event is larger than the first. Comprehensive synthetic tests demonstrate that the proposed ETAS + method retrieves nearly unbiased parameter estimates even from highly incomplete catalogs, whereas parameters obtained using classical estimation approaches are strongly biased. Application to Southern California reveals a similar trend, with the productivity scaling parameter α approaching the b value, consistent with self-similar earthquake triggering within estimation uncertainties. Owing to its robustness against catalog incompleteness and computational efficiency, the ETAS + method provides a powerful new tool for seismicity analysis and earthquake forecasting.

California↗