USGS Science⌕ Search

USGS · 70018913

Properties and variability of soil and trench fill at an arid waste-burial site

Abstract

Arid sites commonly are assumed to be ideal for long-term isolation of wastes. Information on properties and variability of desert soils is limited, however, and little is known about how the natural site environment is altered by installation of a waste facility. During fall construction of two test trenches next to the waste facility on the Amargosa Desert near Beatty, NV, samples were collected to: (i) characterize physical and hydraulic properties of native soil (upper 5 m) and trench fill, (ii) determine effects of trench construction on selected properties and vertical variability of these properties, and (iii) develop conceptual models of vertical variation within the soil profile and trench fill. Water retention was measured to air dryness (ψ = 2 × 10 6 cm water suction). The 15 300-cm pressure-plate data were omitted from the analysis because water-activity measurements showed the actual suction values were significantly less than the expected 15 300-cm value (avg. difference = 8550 ± 2460 cm water). Trench construction significantly altered properties and variability of the natural site environment. For example, water content ranged from 0.029 to 0.041 m 3 m -3 for fill vs. 0.030 to 0.095 m 3 m -3 for soil; saturated hydraulic conductivity was ≈ 10 -4 cm s -1 for fill vs. 10 -2 to ≈ 10 -4 cm s -1 for soil. Statistical analyses showed that the native soil may be represented by three major horizontal components and the fill by a single component. Under initial conditions, calculated liquid conductivity ( K l ) plus isothermal vapor conductivity ( K v ) for the upper two soil layers and the trench fill was ≈ 10 -13 cm s -1 , and K l was ≤ K v . For the deeper (2–5 m) soil, total conductivity was ≈ 10 -10 cm s -1 , and K l was > K v . This study quantitatively describes hydraulic characteristics of a site using data measured across a water-content range that is representative of arid conditions, but is seldom studied.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Brian J. Andraski. 1996. Properties and variability of soil and trench fill at an arid waste-burial site. https://doi.org/10.2136/sssaj1996.03615995006000010011x

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Forming regional soil carbon networks to support effective climate change solutions

Sequestration and storage of organic carbon (C) in soil is an essential component of climate change mitigation and fundamental in promoting the health and climate resilience of soils. Sources of available soil C data are increasing, which complicates efforts to consolidate the data in forms that can be readily used by stakeholders. Spatial and temporal gaps in data availability also limit the quantification of changes in soil C through space and time. Improved coordination among producers and users of soil C data would provide data compatibility at the spatial and temporal resolution required for C monitoring, accounting, and verification of policy implementation. These challenges can be addressed by forming regional-scale networks to coordinate the collection and use of soil C data by promoting consistency in methods, collecting new data to fill critical gaps, integrating existing data from multiple sources, and providing data interpretation to stakeholders in readily usable forms. Forming networks in regions such as the Northeastern United States would require close coordinationwith existing programs that are involved in collecting or aggregating soil C within that region. Network formation could be accomplished by (1) producing a planning document, (2) designing a network structure tailored to the region, and (3) acquiring the institutional support to establish and operate the network. Increasing the availability and usage of soil C data through regional networks would support the development of climate change solutions and increased ecosystem services through land management efforts that increase soil C storage.

Soil Science Society of America Journal↗

The processes of preferential flow in the unsaturated zone

Preferential flow, a major influence in unsaturated soil and rock almost everywhere, occurs by multiple phenomenologically distinct hydraulic processes. For the mode known as funneled flow, concentrated in particularly conductive portions of the medium, the surface-tension/viscous-flow processes of traditional unsaturated flow theory predominate. Fingered flow, through conductive paths of higher water content than surrounding material, requires amendments to traditional theory concerning instabilities and dynamic flow-regime boundaries. Macropore flow, the most recognized preferential flow mode, poses unanswered questions and major difficulties in practice. Accumulated evidence shows that water flows preferentially mostly through macropores that are (a) only partially filled with water, and (b) surrounded by matrix material that is drier, sometimes much drier, than saturation. With partial filling, geometric characteristics such as aperture have much less influence than was previously thought, and the intra-macropore configuration of the flowing water phase, about which little is conclusively known, is then a dominant controlling influence. With unsaturated surroundings, macropore/matrix exchange interactions control, for given input and medium, the initiating circumstances, conveyed flux, and duration of macropore flow. The multiple processes in play during such interactions have different sensitivities to the matrix water state and different directions of influence. The net influence of matrix water content on macropore flow is thus highly complex and a major research need. Additional high-priority topics are: flowpath connectivity, for watersheds as well as small scales; intra-macropore processes, to discern their importance and possible means of quantification; and the identification of measurable soil and rock properties that can be utilized predictively.

Soil Science Society of America Journal↗

A hybrid approach for predictive soil property mapping using conventional soil survey data

Soil property maps are important for land management and earth systems modeling. A new hybrid point-disaggregation predictive soil property mapping strategy improved mapping in the Colorado River Basin, and can be applied to other areas with similar data (e.g. conterminous United States). This new approach increased sample size ~6-fold over past efforts. Random forests related environmental raster layers representing soil forming factors to samples to predict 15 soil properties (pH, texture fractions, rock, electrical conductivity, gypsum, CaCO3, sodium adsorption ratio, available water capacity, bulk density, erodibility, organic matter) at 7 depths, depth to restrictive layer, and surface rock size and cover. Cross-validations resulted in coefficient of determinations averaging 0.52, with a range of 0.20 to 0.76; and mean absolute errors ranged from 3% to 98% of training data averages with a mean of 41%. Uncertainty estimates were also developed by creating relative prediction intervals (RPIs) for the entire study area, which allow end users to evaluate uncertainty relative to original data distributions. Average error increased with higher RPI values (higher uncertainty), and areas with the highest RPI are consistently under-sampled, suggesting that additional sampling in these areas may improve prediction accuracy. Greater uncertainty was also observed in areas with shale parent materials and physiographic settings uncommon relative to the broader study area.

New Mexico, Colorado, Wyoming, Utah, Nevada, Arizo↗