USGS Science⌕ Search

USGS · 70015709

Seismic reflection images of the crust of the northern part of the Chugach terrane, Alaska: Results of a survey for the Trans-Alaska Crustal Transect (TACT)

Abstract

Deep crustal seismic reflection data show strong reflections from the middle and lower crust of the convergent continental margin near the eastern end of the Aleutian trench. These data were collected across the Border Ranges fault system, a major suture zone that separates the Peninsular and Chugach tectonostratigraphic terranes. The Chugach terrane consists of metamorphosed, strongly deformed flysch, subduction melange as well as blueschist- and greenschist-facies rocks. Even so, highly reflective rocks lie at great depth within or beneath this terrane. The shallow part of the seismic section (0–5 s) reveals only a few reflections, which undulate and interweave, indicating that some of them originate outside of the plane of the seismic section. Other undulating events could reveal early Cenozoic granitic plutons or antiformal stacks of rock imbricated along thrust faults. In contrast to this shallow reflection pattern, three reflection bands contain most of the events on the middle part of the seismic section (5–12 s or 12–34 km). We interpret divergent reflections within the uppermost band (5–5.5 s) as gently north dipping thrust faults, and subparallel reflections truncated at the boundaries of the upper and middle bands may image a metamorphic foliation or thrust faults. If the truncated reflections represent thrust faults, then the reflection geometry suggests that subparallel roof and floor thrust faults bound imbricated rocks, forming duplex structures. The upper and middle bands are separated by an area on the seismic section that reveals few reflections. This area correlates approximately in depth with a high velocity (7.5 km/s) layer evident in refraction models. The poorly reflective, high velocity unit might be volcanic rocks like those exposed in the structurally lowest part of the Chugach terrane. If so, then the bottom of the poorly reflective rocks indicates the base of the Chugach terrane. Rocks that cause the upper and middle reflection bands and the intervening, poorly reflective volcanic rocks may form a midcrustal shear zone that is about 10 km thick. The deepest band of subparallel reflections (30–35 km) correlates closely in depth with the top of the Wadati-Benioff zone associated with the underthrusting Pacific plate. The reflections probably stem from the decollement that separates lithospheric plates within the subduction zone. This reflection band increases abruptly in thickness, possibly indicating local underplating of subducted sediment. No events from the oceanic Moho have been recognized. Neither the Border Ranges fault system, the suture between the Chugach and Peninsular terranes, nor deep crustal layers of the Peninsular terrane are evident in these seismic reflection data.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

M. A. Fisher, T.M. Brocher, W. J. Nokleberg, George Plafker, G.L. Smith. 2012-09-20. Seismic reflection images of the crust of the northern part of the Chugach terrane, Alaska: Results of a survey for the Trans-Alaska Crustal Transect (TACT). https://doi.org/10.1029/jb094ib04p04424

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Timescales of surface faulting preservation in low-strain intraplate regions from landscape evolution modeling and the geomorphic and historical record

Large surface-rupturing intraplate earthquakes in stable continental regions (SCRs) are uncommon globally and have recurrence intervals of thousands to hundreds of thousands of years based on the paleoseismic and geomorphic record, challenging accurate active fault identification in these regions. To constrain the timescales of preservation for scarps created by surface ruptures from dip-slip earthquakes, we use a two-dimensional scarp diffusion model for typical intraplate settings and explore which parameters influence fault scarp preservation. These parameters include the coseismic vertical surface offset, the recurrence interval of similar magnitude earthquakes, diffusivity (as a proxy for mean annual precipitation rate), and the erodibility of the surficial material. We constrain parameter ranges from a compilation of historical surface ruptures in intraplate settings in a variety of climates, including the Central and Eastern United States, Australia, Europe, Central Asia (Mongolia, China), India, and West Africa. The timescales of scarp preservation from landscape evolution modeling agree well with observations of scarp preservation in low-strain SCR and intraplate tectonic settings, with some notable exceptions for Australian scarps. We find that the erodibility of the surficial material and earthquake recurrence interval have a stronger effect on the timescales of scarp preservation than diffusivity or coseismic vertical surface offset. Our model results may aid in identifying and characterizing subtle, slow-moving active faults in low-strain SCR and intraplate tectonic settings for different tectonic, geomorphic, and climatic characteristics. Accurate fault locations and characterization from the landscape record has implications for both probabilistic seismic and fault displacement hazard analyses.

Journal of Geophysical Research Solid Earth↗

Exploring the dynamic interactions between the Southern San Andreas Fault and a normal fault under the Salton Sea

We investigate the dynamic interactions between the Southern San Andreas Fault (SSAF) and a proximal normal fault (NF) beneath the Salton Sea in southern California. The NF, positioned near the SSAF terminus at Bombay Beach, exhibits 11–15 displacement events across 14 stratigraphic sequences, with a range of 0.2–1.4 m of vertical offset since ∼2–3 ka. Notably, four of these events may align temporally with SSAF earthquakes, raising questions about the possible interplay between the two faults. Utilizing dynamic rupture models, we analyze the coseismic interactions between the SSAF and NF, addressing under what conditions the SSAF induces slip on the NF. Our findings reveal that a suite of SSAF ruptures, particularly those propagating from north to south, can trigger slip on the normal fault and replicate observed vertical offsets. If the SSAF extends beneath the Salton Sea, earthquakes originating south of the NF intersection are less likely to trigger normal fault slip, although we cannot exclude this possibility. Some SSAF ruptures do not trigger discernible slip on the NF, rendering such events undetectable in the stratigraphic record. Our research contributes toward discussions regarding the seismic hazard in southern California, shedding light on the interplay between the SSAF and NF.

California↗

Quantifying site effects and their influence on earthquake source parameter estimations using a dense array in Oklahoma

We investigate the effects of site response on source parameter estimates using earthquakes recorded by the LArge-n Seismic Survey in Oklahoma (LASSO). While it is well known that near-surface unconsolidated sediments can cause an apparent breakdown of earthquake self-similarity, the influence of laterally varying site conditions remains unclear. We analyze site conditions across the 1825-station array on a river plain within an area of 40 km by 23 km using vertical ground motions from 14 regional earthquakes. While the source radiation pattern controls P-wave ground motions below 8 Hz, the surface geology correlates with P-wave ground motions above 8 Hz and S-wave ground motions at 2–21 Hz. Stations installed in alluvial sediments have vertical ground motions that can exceed three times the array median. We use the variation of ground motion of regional earthquakes across the array as a proxy for site effects. The corner frequencies and stress drops of local earthquakes ( M L = 0.01–3) estimated using a standard single-spectra approach show negative correlations with the site-effect proxy, while the seismic moments show positive correlations. In contrast, the spectral-ratio approach effectively shows no correlation. The overall bias is small as expected for this relatively homogeneous structure; accurate estimation of site-related biases requires at least 30 stations. Correcting for site-related biases reduces the standard deviations of the source parameters by less than 13% of the total variations. Remaining variations are partially associated with source directivity and model misfits— as small earthquakes can have complex ruptures.

Oklahoma↗