USGS Science⌕ Search

USGS · 70014801

Mineralogy and petrology of the Cretaceous- Tertiary boundary clay bed and adjacent clay-rich rocks, Raton Basin, New Mexico and Colorado.

Abstract

The Cretaceous-Tertiary (K-T) boundary is preserved in a sequence of coal-bearing, fluvial rocks in the lower part of the Raton Formation (Late Cretaceous and Paleocene) at several sites in the east-central part of the Raton Basin. The K-T boundary occurs at the top of a kaolinitic claystone layer, commonly referred to as the "boundary clay layer," in an interval of coal and carbonaceous shale. The boundary is defined by the disappearance of certain fossil-pollen taxa. The boundary clay layer also contains shocked quartz grains and abundance anomalies of iridium, chromium, and other elements. Each of these characteristics support the hypothesis of an asteroid impact at the end of the Cretaceous. Small goyazite spheres were also found in the boundary clay bed; however, their origin is uncertain. X-ray powder diffraction (XRD), scanning electron microscopy (SEM), and thin-section petrography have shown that the boundary clay bed exhibits unique mineralogic and petrologic characteristics not possessed by other clay-rich beds in coal-bearing rocks of the Raton Basin. The boundary clay bed is composed primarily of well-crystallized kaolinite but also contains subordinate, randomly interstratified, mixed-layer illite/smectite, both of which appear to have been formed by the alteration of vitreous material in a coal-swamp environment. The bulk mineralogy of the boundary clay bed is similar to that of other kaolinite-rich clay beds (tonsteins) that altered in coal swamps from airfall volcanic ash. The alteration process and diagenetic products of the host material in the boundary clay bed, however, differed from those of the tonsteins, resulting in a unique petrographic fabric. The boundary clay bed is characterized by an overall imbricate fabric that may reflect an original vitreous material that included shards, bubbles, and spheres. The original fallout material of the boundary clay bed first altered to "cabbage-like" microspherules, indicating a halloysite or allophane precursor, and then to well-crystallized kaolinite; the well-crystallized kaolinite is the diagenetic stable phase for these rocks at their maximum burial conditions. In comparison, the vitreous components of the tonsteins were altered directly to coarse vermicular and platey kaolinite. Alteration of the original fallout material in the boundary bed was probably rapid, leading to hydrated, disordered, fine-grained clay minerals that formed into curled spherical or tubular shapes. The factors that produced these unique fabrics in the boundary clay bed existed at all K-T sites in the Raton Basin and were much different from those that formed the coarse platey and vermicular fabrics of ordinary tonsteins. The distinctive character of the boundary clay may be due to the unique nature and chemistry of the fallout material and (or) physical or chemical conditions existing shortly after its deposition.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

R. M. Pollastro, C. L. Pillmore. 1987. Mineralogy and petrology of the Cretaceous- Tertiary boundary clay bed and adjacent clay-rich rocks, Raton Basin, New Mexico and Colorado.. https://doi.org/10.1306/212f8b61-2b24-11d7-8648000102c1865d

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Role of microbial processes in linking sandstone diagenesis with organic-rich clays

Numerous chemical reactions within clay sequences have been proposed to produce dissolved material for diagenesis of deeply-buried sands. However, reactions responsible for solubilizing inorganic and organic constituents in clays at intermediate depths, and their importance to sandstone diagenesis, have not been evaluated. Results from this study show that the processes of microbial organic-acid production (via fermentation) in clays and microbial organic-acid consumption (via sulfate reduction) in sands effectively link organic-rich clays to sandstone diagenesis in the Black Creek Formation of South Carolina. Diagenetic processes have resulted in the formation of 10 volume percent calcite cement, 0.1 volume percent authigenic pyrite, and 1.5 volume percent secondary porosity in Black Creek sands. However, the distribution of these diagenetic processes is not uniform, resulting in net destruction of porosity in some parts of the sand and net porosity enhancement in other parts. Mass balance-derived rates of microbial organic-acid production (10 (super -5) mmole carbon 1 (super -1) yr (super -1) ) and microbial CO 2 production (4 x 10 (super -5) mmole l (super -1) yr (super -1) ) show that microbial processes can account for all organic carbon in the calcite cements (at least 11% of carbonate carbon based on isotope-balance calculations), all observed authigenic pyrite, and all observed secondary porosity. These findings show that microbial processes can serve to link organic-rich clays with sandstone diagenesis at intermediate depths.

Journal of Sedimentary Petrology↗

Lithofacies analysis of colluvial sediments - an aid in interpreting the recent history of Quaternary normal faults in the Basin and Range Province, western United States

Inferring the frequency and magnitude of past earthquakes from the stratigraphy in exposures of normal-faulted sediments is difficult because colluvial lithofacies assemblages adjacent to faults are complex. Similarities in facies assemblages adjacent to young fault scarps in arid to semiarid areas, such as the Basin and Range province, allow lithofacies to be grouped into two genetic architectural elements: debris and wash elements. Upper and lower facies associations can commonly be recognized within each element. A lithofacies code scheme, similar to those used in the analysis of fluvial and glacial lithofacies sequences, provides a concise way of illustrating lithofacies relations in fault exposures. The source lithology of colluvial lithofacies is shown in the code, and soil-horizon symbols can be included. The architecture of lithofacies assemblages near fault scarps in semiarid areas is explained by a model of colluvial sedimentation in response to a single surface faulting event. Analysis of lithofacies assemblages exposed in three trenches across normal faults in the eastern Basin and Range shows how the model can be used to interpret fault histories. Similar facies analysis methods may be useful in interpreting colluvial sequences formed by non-tectonic processes.

Journal of Sedimentary Petrology↗

Mineralogy of the silt fraction in surficial sediments from the outer continental shelf off southeastern New England

The silt-sized heavy mineral assemblage, which is predominantly detrital, has been concentrated in this fraction by hydraulic factors and ranges between 11.8 wt. % of the silt fraction in the sandy sediments near Georges Bank to 3.4% in the clayey silt deposit south of Martha's Vineyard. By contrast, the sand fraction averages only 1.5% heavy minerals. Lateral variability within the silt-sized heavy mineral assemblage is considerable. Zircon and ilmenite abundances progressively decrease from east to west on the continental shelf off southeastern New England. Conversely, abundances within the amphibole and the epidote groups increase from east to west.

Journal of Sedimentary Petrology↗