Dissolution of barite for the analysis of strontium isotopes and other chemical and isotopic variations using aqueous sodium carbonate

G. N. Breit; E.C. Simmons; M. B. Goldhaber

doi:10.1016/0168-9622(85)90043-0

Home/Archive/USGS

USGS · 70013083

Dissolution of barite for the analysis of strontium isotopes and other chemical and isotopic variations using aqueous sodium carbonate

G. N. Breit·E.C. Simmons·M. B. Goldhaber

View original source ↗Export metadata ↓

Abstract

A simple procedure for preparing barite samples for chemical and isotopic analysis is described. Sulfate ion, in barite, in the presence of high concentrations of aqueous sodium carbonate, is replaced by carbonate. This replacement forms insoluble carbonates with the cations commonly in barite: Ba, Sr, Ca and Pb. Sulfate is released into the solution by the carbonate replacement and is separated by filtration. The aqueous sulfate can then be reprecipitated for analysis of the sulfur and oxygen isotopes. The cations in the carbonate phase can be dissolved by acidifying the solid residue. Sr can be separated from the solution for Sr isotope analysis by ion-exchange chromatography. The sodium carbonate used contains amounts of Sr which will affect almost all barite 87 Sr 86 Sr "> 87Sr86Sr ratios by less than 0.00001 at 1.95θ of the mean. The procedure is preferred over other techniques used for preparing barite samples for the determination of 87 Sr 86 Sr "> 87Sr86Sr ratios because it is simple, rapid and enables simultaneous determination of many compositional parameters on the same material.

Explore related subjects

Chemical Geology: Isotope Geoscience Section Article

Keep this discovery

Explore connections, maps & timelines

BibTeX RIS

G. N. Breit, E.C. Simmons, M. B. Goldhaber. 1985. Dissolution of barite for the analysis of strontium isotopes and other chemical and isotopic variations using aqueous sodium carbonate. https://doi.org/10.1016/0168-9622(85)90043-0

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS1991

Resetting of RbSr ages of volcanic rocks by low-grade burial metamorphism

We report a nine-point RbSr whole-rock isochron age of 70±3 Ma (MSWD 3.97) for Mid-Jurassic volcanic rocks. The same rocks have also been dated by the UThPb method on zircon, giving a crystallization age of 166 ± 11 Ma, over twice as old as the RbSr age. The data demonstrate that whole-rock RbSr ages of volcanic rocks, even lava flows with SiO 2 content as low as 57 wt.%, are susceptible to complete resetting. The rocks range in composition from rhyodacite tuffs to andesite lavas. The complete breakdown of all major minerals that contain Rb and Sr resulted in an alteration mineral assemblage consisting of phengite, albite, secondary quartz, and minor amounts of chlorite and epidote. Phengite is the K-bearing product of the breakdown of biotite and K-feldspar. Pressure during low-grade metamorphism of the volcanic rocks, estimated from phengite composition to have been in the range of 4 to 6 kbar, points to thrust-related burial as the main cause of resetting. Consequently, such reset isochrons may date large-scale events such as regional thrusting and metamorphism. The coherent resetting of the RbSr isochron suggests large-scale pervasive fluid movement during thrust-related burial metamorphism.

Chemical Geology: Isotope Geoscience Section↗

USGS1991

Caution on the use of Viton® or FETFE® O-rings in carbon dioxide sample containers for δ 18 0 analysis

After 10 days, 3-μmol CO 2 samples in containers having glass stopcocks with Viton ® or FETFE O-rings were enriched in 18 O by 1.5% as a result of absorption by the elastomer; this amount of enrichment is &sim;20 times greater than the precision of δ 18 O measurements of most laboratories. No change in 13 C content was observed. Increasing the sample size to 100 μmol resulted in an 18 O enrichment of 0.2% and did not affect the 13 C content. Caution needs to be exercised in selecting sample containers for CO 2 isotope-ratio samples of < 200 μmol. If stopcocks are used in construction of containers for such samples, the use of all-glass stopcocks with Apiezon N ® hydrocarbon-based grease will eliminate the fractionation of oxygen isotopes.

Chemical Geology: Isotope Geoscience Section↗

USGS1990

UPb ages of zircon rims: A new analytical method using the air-abrasion technique

We present a new technique for directly dating, by conventional techniques, the rims of zircons. Several circumstances, such as a xenocrystic or inherited component in igneous zircon and metamorphic overgrowths on igneous cores, can result in grains with physically distinct age components. Pneumatic abrasion has been previously shown by Krogh to remove overgrowths and damaged areas of zircon, leaving more resistant and isotopically less disturbed parts available for analysis. A new abrader design, which is capable of very gently grinding only tips and interfacial edges of even needle-like grains, permits easy collection of abraded material for dating. Five examples demonstrate the utility of the “dust-collecting” technique, including two studies that compare conventional, ion microprobe and abrader data. Common Pb may be strongly concentrated in the outermost zones of many zircons and this Pb is not easily removed by leaching (even in weak HF). Thus, the benefit of removing only the outermost zones (and avoiding mixing of age components) is somewhat compromised by the much higher common Pb contents which result in less precise age determinations. A very brief abrasion to remove the high common Pb zones prior to collection of material for dating is selected.

Chemical Geology: Isotope Geoscience Section↗