USGS Science⌕ Search

Geology topics

Research about west-central Florida

Source-linked reports with geographic coverage including west-central Florida.

5 recordsLinked to original sources

Application of nonlinear least-squares regression to ground-water flow modeling, west-central Florida

A nonlinear least-squares regression technique for estimation of ground-water flow model parameters was applied to an existing model of the regional aquifer system underlying west-central Florida. The regression technique minimizes the differences between measured and simulated water levels. Regression statistics, including parameter sensitivities and correlations, were calculated for reported parameter values in the existing model. Optimal parameter values for selected hydrologic variables of interest are estimated by nonlinear regression. Optimal estimates of parameter values are about 140 times greater than and about 0.01 times less than reported values. Independently estimating all parameters by nonlinear regression was impossible, given the existing zonation structure and number of observations, because of parameter insensitivity and correlation. Although the model yields parameter values similar to those estimated by other methods and reproduces the measured water levels reasonably accurately, a simpler parameter structure should be considered. Some possible ways of improving model calibration are to: (1) modify the defined parameter-zonation structure by omitting and/or combining parameters to be estimated; (2) carefully eliminate observation data based on evidence that they are likely to be biased; (3) collect additional water-level data; (4) assign values to insensitive parameters, and (5) estimate the most sensitive parameters first, then, using the optimized values for these parameters, estimate the entire data set.

Florida↗

The potential for water-quality degradation of interconnected aquifers in west-central Florida

Thousands of deep artesian wells were drilled into the Upper Floridan aquifer in west-central Florida prior to well-drilling regulations adopted in the 1970's. The wells were usually completed with a short length of casing through the unconsolidated sediments and were left open to multiple aquifers containing water of varying quality. These open boreholes serve as a potential source of water-quality degradation within the aquifers when vertical internal borehole flow is induced by hydraulic-head differences. This potential for water-quality degradation exists in west-central Florida where both the intermediate aquifer system and Upper Floridan aquifer exist. Measurements of caliper, temperature, gamma, fluid conductivity, and flow were obtained in 87 wells throughout west-central Florida to determine the occurrence of interaquifer borehole flow between the intermediate aquifer system and the Upper Floridan aquifer. Flow measurements were made using an impeller flowmeter, a heat-pulse flowmeter, and a video camera with an impeller flowmeter attachment. Of the 87 wells measured with the impeller flowmeter, 17 had internal flow which ranged from 10 to 300 gallons per minute. A heat-pulse flowmeter was used in 19 wells in which flow was not detected using the impeller flowmeter. Of these 19 wells, 18 had internal flow which ranged from 0.3 to 10 gallons per minute. Additionally, water-quality samples were collected from specific contributing zones in wells that had internal flow. Analysis of geophysical and water-quality data indicates degradation of water quality has occurred from mineralized ground water flowing upward from the Upper Floridan aquifer into the intermediate aquifer system through both uncased boreholes and corroded black-iron well casings. In areas where there is a downward component of flow, data indicate that potable water from the intermediate aquifer system is artificially recharging the Upper Floridan aquifer through open boreholes. A geographical area was defined where there is a potential for water-quality degradation due to improperly cased wells. This area was delineated based on where there is an upward component of ground-water flow and where there is an occurrence of poor-quality water. The delineated area includes parts of Hillsborough, Manatee, Sarasota, Charlotte, De Soto, and Hardee Counties. To prevent further contamination of the aquifers, the Southwest Florida Water Management District began the Quality of Water Improvement Program in 1974 to restore hydrologic conditions altered by improperly constructed wells or deteriorating casings. As of May 1994, more than 3,000 wells have been inspected and approximately 1,350 have been plugged. To minimize interaquifer contamination, existing wells, especially ones with black-iron casing, should be inspected and, if necessary, repaired with new casing or plugged.

Florida↗

Evaluation and modification of five techniques for estimating stormwater runoff for watersheds in west-central Florida

Several traditional techniques have been used for estimating stormwater runoff from ungaged watersheds. Applying these techniques to watersheds in west-central Florida requires that some of the empirical relations be extrapolated beyond tested ranges. As a result, there is uncertainty as to the accuracy of these estimates. Sixty-six storms occurring in 15 west-central Florida watersheds were initially modeled using the Rational Method, the U.S. Geological Survey Regional Regression Equations, the Natural Resources Conservation Service TR-20 model, the U.S. Army Corps of Engineers HEC-1 model, and the U.S. Environmental Protection Agency Storm Water Management Model. The techniques were applied according to the guidelines specified in the user manuals or standard engineering textbooks as though no field data were available and the selection of input parameters was not influenced by observed data. Computed estimates were compared with observed runoff to evaluate the accuracy of the techniques. One watershed was eliminated from further evaluation when it was determined that the area contributing runoff to the stream varies with the amount and intensity of rainfall. Therefore, further evaluation and modification of the input parameters were made for only 62 storms in 14 watersheds. Runoff ranged from 1.4 to 99.3 percent of rainfall. The average runoff for all watersheds included in this study was about 36 percent of rainfall. The average runoff for the urban, natural, and mixed land use watersheds was about 41, 27, and 29 percent of rainfall, respectively. Initial estimates of peak discharge using the Rational Method produced average watershed errors that ranged from an underestimation of 50.4 percent to an overestimation of 767 percent. The coefficient of runoff ranged from 0.20 to 0.60. Calibration of the technique produced average errors that ranged from an underestimation of 3.3 percent to an over estimation of 1.5 percent. The average calibrated coefficient of runoff for each watershed ranged from 0.02 to 0.72. The average values of the coefficient of runoff necessary to calibrate the urban, natural, and mixed land use watersheds were 0.39, 0.16, and 0.08, respectively. The U.S. Geological Survey regional regression equations for determining peak discharge produced errors that ranged from an underestimation of 87.3 percent to an overestimation of 1,140 percent. The regression equations for determining runoff volume produced errors that ranged from an underestimation of 95.6 percent to an overestimation of 324 percent. Regression equations developed from data used for this study produced errors that ranged between an underestimation of 82.8 percent and an overestimation of 328 percent for peak discharge and from an underestimation of 71.2 percent to an overestimation of 241 percent for runoff volume. Use of the equations developed for west-central Florida streams produced average errors for each type of watershed that were lower than errors associated with use of the U.S. Geological Survey regional equations. Initial estimates of peak discharges and runoff volumes using the Natural Resources Conservation Service TR-20 model, produced average errors of 44.6 and 42.7 percent, respectively, for all the watersheds. Curve numbers and times of concentration were adjusted to match estimated and observed peak discharges and runoff volumes. The average change in the curve number for all the watersheds was a decrease of 2.8 percent. The average change in the time of concentration was an increase of 59.2 percent. The shape of the input dimensionless unit hydrograph also had to be adjusted to match the shape and peak time of the estimated and observed flood hydrographs. Peak rate factors for the modified input dimensionless unit hydrographs ranged from 162 to 454. The mean errors for peak discharges and runoff volumes were reduced to 18.9 and 19.5 percent, respectively, using the average calibrated input parameters for each watershed. Initial estimates of peak discharges and runoff volumes using the U.S. Army Corp of Engineers Hydrologic Engineering Center-1 model, produced average errors of 105 and 26.8 percent respectively, for all the watersheds. Curve numbers and lag times were adjusted to match estimated and observed peak discharges and runoff volumes. The average change in the curve number for all the watersheds was a decrease of 2.5 percent. The average change in the lag time was an increase of 169 percent. The mean errors for peak discharges and runoff volumes were reduced to 5.8 and 1.4 percent, respectively, using the average calibrated input parameters for each watershed. The observed and estimated peak discharges and runoff volumes could be matched by adjusting curve numbers and lag time using the U.S. Army Corp of Engineers Hydrologic Engineering Center-1 model; however, the shape of the estimated flood hydrograph and timing of the peak could not be matched. The input dimensionless unit hydrograph must also be changed to increase the accuracy of the Hydrologic Engineering Center-1 model for watersheds in west-central Florida. The source code has to be modified and recompiled to enter different dimensionless unit hydrographs into the HEC-1 program. During application of the U.S. Environmental Protection Agency Storm Water Management Model, two separate infiltration methods were evaluated. Initial estimates of peak discharges and runoff volumes produced mean errors of 46.5 and 6.8 percent, respectively, for all watersheds using the Green-Ampt infiltration method, and 48.8 and 9.5 percent, respectively, using the Horton infiltration method. The mean errors were reduced to 18 and 0.3 percent for the Green-Ampt method and 20.9 and 7.2 percent for the Horton method using the average calibrated input parameters for each watershed. Estimates of peak discharges and runoff volumes were initially made for watersheds in west-central Florida using recommended procedures, then compared to observed peak discharges and runoff volumes. Subsequently, the procedures were modified to increase accuracy for this area. The same methods used during the study could be used in other parts of the world to evaluate the accuracy of standard methods for estimating stormwater runoff.

Florida↗

Simulated changes in potentiometric levels resulting from groundwater development for phosphate mines, west-central Florida

A digital model of two-dimensional groundwater flow was used to predict changes in the potentiometric surface of the Floridan aquifer resulting from groundwater development for proposed and existing phosphate mines during 1976-2000. The modeled area covers 15,379 km 2 in west-central Florida. In 1975, groundwater withdrawn from the Floridan aquifer for irrigation, phosphate mines, other industries and municipal supplies averaged about 28,500 1/s. Withdrawals for phosphate mines are expected to shift from Polk County to adjacent counties to the south and west, and to decline from about 7,620 1/s in 1975 to about 7,060 1/s in 2000. The model was calibrated under steady-state and transient conditions. Input parameters included aquifer transmissivity and storage coefficient; thickness, vertical hydraulic conductivity, and storage coefficient of the upper confining bed; altitudes of the water table and potentiometric surface; and groundwater withdrawals. Simulation of November 1976 to October 2000, using projected combined pumping rates for existing and proposed phosphate mines, resulted in a rise in the potentiometric surface of about 6 m in Polk County, and a decline of about 4 m in parts of Manatee and Hardee counties.

Florida↗

Water table in the surficial aquifer and potentiometric surface of the Floridan Aquifer in selected well fields, west-central Florida, May 1978

The water table in the surficial aquifer and the potentiometric surface of the Floridan aquifer in a 1,200-square-mile area in west-central Florida are mapped semiannually by the U.S. Geological Survey. Maps are prepared showing water levels measured in wells each May to coincide with seasonal low levels, and each September to coincide with seasonal high levels. The mapped area shows 11 well fields which supplied 144.0 million gallons to municipalities on May 16, 1978. The water is withdrawn from the Floridan aquifer, the major aquifer in Florida. The effect of localized withdrawal of ground water is shown on the maps as depressions in both the potentiometric and water-table surfaces. Water levels were generally lower in May 1978 than in September 1977 because of seasonal rainfall. The maximum decrease determined was more than 17 feet at Sun City well field. Water levels in May 1978 were generally higher than in May 1977 because of heavy rainfall in early May. However, water levels in well fields with significant increases in pumpage were lower.

Florida↗