Geology topics
Research about Ohio
Source-linked reports with geographic coverage including Ohio.
Preliminary map showing the thickness of glacial deposits in Ohio
This map was compiled as part of a U.S. Geological Survey project to portray the character and thickness of glacial deposits east of the Rocky Mountains. It is a preliminary map, compiled at a scale of 1:250,000 from sources of differing type and quality (fig. I, table 1). County drift-thickness maps produced by the Ohio Geological Survey are the most reliable source of data used. These county maps, either published or in manuscript form, were available for 36 of the 72 counties that contain glacial or glacially related deposits more than 50 ft thick. An earlier, reconnaissance drift-thickness map of northwestern Ohio (Ohio Department of Natural Resources, 1960) provided data for parts of 12 additional counties. Published maps of bedrock topography were utilized for 9 counties and for parts of 6 counties. The computation of drift thickness in these counties is less reliable then the drift-thickness maps published by the Ohio Geological Survey because the bedrock topography maps, most of which are at least 20 years old, were compiled from a more limited set of data. In the remaining counties, only well-log data were available. Drift-thickness data in these counties are the least reliable; the determination of thickness trends was commonly guided by the configuration of preglacial drainage channels (as drawn by Stout and others, 1943) and by topography. Throughout the glaciated areas of Ohio, and especially near the glacial margin, a network of drainage channels is buried by glacial drift. Some of these channels arc of a preglacial age while others were formed during interglacial periods; some were cut into the bedrock by rivers— either preglacial rivers or meltwater streams flowing along the glacial margin—while others, such as the lower Cuyahoga River valley, may have been overdeepened by the erosive power of glacial ice. The thickest deposits of drift in the state occur in the lower Cuyahoga River valley near Lake Erie, and above the buried valley in west-central Ohio that has been historically considered a part of the Teays Valley. The thickest drift reliably measured in Ohio to date is 602 ft in a drill hole near Cleveland. In contrast to the extreme variations in drift thickness encountered in the vicinity of buried channels, drift on the upland arcus is generally thinner and the variations in thickness are much less pronounced. Worthy of note, however, are three large areas where the drift sheet is relatively thick. In northwestern Ohio, a large volume of drift was deposited along the flanks of the Erie ice lobe (fig. 2) near the interlobate position with the Saginaw lobe to the northwest; drift thickness there exceeds 200 ft. Thick drift was also deposited in a roughly cast-west band across the Miami lobe. The mechanism that produced this band of thick drift is not obvious, but it may have been influenced in part by bedrock topography. Bedrock control of drift thickness is more clearly indicated to the cast of Columbus, along the eastern flank of the Scioto lobe, where ice slow was resisted by rocks of the Allegheny plateau. The edge of the plateau, or the Allegheny escarpment, is obscured by glacial deposits but its likely position (Fenneman, 1938; Stout and others, 1913; Dove, 1960; and Root and others, 1961) is shown on the map. Southward from the ice margin's reentrant position in southern Richland County, ice flowing eastward from the Scioto lobe encountered the topographically higher plateau, which constrained the ice and caused drift to accumulate in significant thicknesses just to the west of the escarpment.
Preliminary report on aftershock sequence for earthquake of January 31, 1986, near Painesville, Ohio (time period: 2/1/86-2/10/86)
A ten-station array of broad-band digital instrumentation (GEOS) was deployed by the U. S. Geological Survey with partial support provided by Electric Power Research Institute to record the aftershock sequence of the moderate (mb ~ 4.9) earthquake that occurred on January 31, 1986 (16:46:43 UTC) near Painesville, Ohio. The occurrence of the event has raised questions concerning possible contributory factors to the occurrence of the event and questions concerning the character of earthquake-induced high-frequency ground motions in the area. To aid in the timely resolution of the implications of some of these questions, this preliminary report provides copies of the ground motion time-histories and corresponding spectra for the six identified aftershocks and two events, thought to be quarry blasts, recorded as of February 10, 1986. Recording station locations and epicenter locations based on two preliminary estimates of local seismic velocity structure are provided.
Water resources data for Ohio, water year 1985. Volume 1. Ohio River Basin
No abstract available.
Changes in ground-water quality resulting from surface coal mining of a small watershed in Jefferson County, Ohio
Two samples were collected from each of six wells in a small watershed in Jefferson County, Ohio, in 1984. The watershed was mined and reclamation begun in 1980. Data collected from 1976 through 1982 indicate that ground-water quality was still changing at that time. The purpose of this study was to determine to what extent ground-water quality continued to change 4 years after mining. The upper saturated zone was destroyed by mining and replaced by spoiled material during reclamation. A new saturated zone then formed in the spoils material. The premining median concentrations of sulfate, manganese, and dissolved solids in the upper saturated zone were 84 milligrams per liter (mg/L). 30 micrograms per liter (?g/L), and 335 mg/L, respectively. The postmining median concentrations of these constituents in the upper-zone wells disturbed by mining were 360 mg/L, 595 ?g/L, and 814 mg/L, respectively. Concentrations of these constituents were still increasing in 1984 in the upper saturated zone. In the area not disturbed by mining, concentrations have remained nearly at premining levels. The premining median concentrations of sulfate, manganese, and dissolved solids in the middle saturated zone were 47 mg/L, 10 ?g/L and 405 mg/L, respectively. The postmining median concentrations were 390 mg/L, 490 ?g/L, and 959 mg/L, respectively. In the middle saturated zone, concentrations of these constituents also were still increasing in 1984, probably due to mixing with water if the upper saturated zone.
Influence of size-fractioning techniques on concentrations of selected trace metals in bottom materials from two streams in northeastern Ohio
Identical stream-bottom material samples, when fractioned to the same size by different techniques, may contain significantly different trace-metal concentrations. Precision of techniques also may differ, which could affect the ability to discriminate between size-fractioned bottom-material samples having different metal concentrations. Bottom-material samples fractioned to less than 0.020 millimeters by means of three common techniques (air elutriation, sieving, and settling) were analyzed for six trace metals to determine whether the technique used to obtain the desired particle-size fraction affects the ability to discriminate between bottom materials having different trace-metal concentrations. In addition, this study attempts to assess whether median trace-metal concentrations in size-fractioned bottom materials of identical origin differ depending on the size-fractioning technique used. Finally, this study evaluates the efficiency of the three size-fractioning techniques in terms of time, expense, and effort involved. Bottom-material samples were collected at two sites in northeastern Ohio: One is located in an undeveloped forested basin, and the other is located in a basin having a mixture of industrial and surface-mining land uses. The sites were selected for their close physical proximity, similar contributing drainage areas, and the likelihood that trace-metal concentrations in the bottom materials would be significantly different. Statistically significant differences in the concentrations of trace metals were detected between bottom-material samples collected at the two sites when the samples had been size-fractioned by means of air elutriation or sieving. Statistical analyses of samples that had been size fractioned by settling in native water were not measurably different in any of the six trace metals analyzed. Results of multiple comparison tests suggest that differences related to size-fractioning technique were evident in median copper, lead, and iron concentrations. Technique-related differences in copper concentrations most likely resulted from contamination of air-elutriated samples by a feed tip on the elutriator apparatus. No technique-related differences were observed in chromium, manganese, or zinc concentrations. Although air elutriation was the most expensive sizefractioning technique investigated, samples fractioned by this technique appeared to provide a superior level of discrimination between metal concentrations present in the bottom materials of the two sites. Sieving was an adequate lower-cost but more laborintensive alternative.
Preliminary report on a study to estimate flood volumes of small rural streams in Ohio: Methods, site selection, and data base
In 1981, the U.S. Geological Survey, in cooperation with the Ohio Department of Transportation and the Federal Highway Administration, began a 7-year flood-volume study of small rural basins in Ohio. This report summarizes the methods of study and describes reconnaissance and site-selection procedures, locations and characteristics of the stations, instrumentation, and methods of collecting and storing data. The first phase of this study involved an intensive field reconnaissance of about 7,000 sites, of which 32 basins were selected for detailed analysis. Drainage areas for the basins varied from 0.13 to 6.45 square miles, and main-channel slopes ranged from 7.6 to 276 feet per mile. Five years of 5-minute rainfall-runoff data will be colledted for each study site. These data will be used to calibrate and verify a rainfall-runoff model for each basin. The calibrated model will be used in conjunction with 80 years of National Weather Service 5-minute precipitation data to synthesize a representative 80-year streamflow record at each site. A Log-Pearson Type III frequency distribution will be applied to each record to define the magnitudes and frequencies of flood volumes at each site. These data will be used to develop regionalized multiple regression models for estimating flood-volume magnitudes and frequencies at small rural ungaged sites in Ohio. The report also summarizes rainfall-runoff data collected from July 1981 through September 1983, but does not interpret the data. An average of eleven event periods per site were monitored where maximum 5-minute rainfall intensities varied from 0.02 to .067 inches and maximum peak discharges varied from 1 to 1,130 cubic feet per second.
Water resources data for Ohio, water year 1984. Volume 1. Ohio River Basin
No abstract available.
Chemical and isotopic characteristics of brines from three oil- and gas-producing sandstones in eastern Ohio, with applications to the geochemical tracing of brine sources
Chemical and isotopic characteristics of selected inorganic constituents are reported for brines from the Berea Sandstone of Mississippian age, the Clinton sandstone, Albion Sandstone of Silurian age, and the Rose Run formation of Cambrian and Ordovician age in 24 counties in eastern Ohio. Ionic concentrations of dissolved constituents in brines from these formations generally fall in the following ranges (in millimoles per kilogram of brine): Na, Cl > 1,000; 100 < Ca, Mg < 1,000; 1 < K, Br, Sr, Li, Fe, SO4 < 100; Mn, Zn, Al, I, HCO3, SiO2 < 1. Mean ionic concentrations of Ca, Mg, Na, Cl, K, SO4 and Br, and mean values of density and dissolved solids are significantly different at the 95-percent confidence level in each formation. Only potassium has a unique concentration range in each formation. Selected concentration ratios are identified as potential indicators for geochemical tracing of brines having some history of dilution. The k:Na ratios work best for identifying the source formation of an unidentified brine. Isotopic characteristics of hydrogen and oxygen indicate a meteoric origin for the water matrix of the brines. Sulfur isotopes may have utility for differentiating brines from oxidizing ground water.
Distribution of trace elements in coal from the Powhatan No. 6 mine, Ohio
Size and density separates of low-temperature-ashed coal from the Powhatan No. 6 mine, Ohio, have been used to determine the mode of occurrence of 28 minor and trace elements in coal. The size distribution of the major minerals has been determined, and correlations of trace elements with major minerals have been made. The role of minor minerals in the mode of occurrence of trace elements is also discussed. Instrumental-neutron-activation analysis was used to determine elemental concentrations, and X-ray diffraction and scanning electron microscopy were used for mineral identification.