Research about Mt. Ruapehu

USGS2022

Rock alteration mapping in and around fossil shallow intrusions at Mt. Ruapehu New Zealand with laboratory and aerial hyperspectral imaging

Diagnostic absorption features in hyperspectral data can be used to identify a specific mineral or mineral associations. However, it is unknown how accurate hyperspectral mapping can be for identifying alteration mineral compositions at the resolution required to describe structures such as fossil intrusions, or whether it can accurately quantify the alteration present. This study compared petrographic observation with visible, near-infrared (VNIR), and shortwave infrared (SWIR) hyperspectral remote sensing at laboratory- (centimetre-scale) and aerial- (metre-scale) scales to characterise the abundance of surface hydrothermal rock alteration in and around a shallow fossil intrusion on Pinnacle Ridge, Mt. Ruapehu, New Zealand. We classified a high-resolution aerial hyperspectral image to develop a new surface alteration map using Spectral Angle Mapper (SAM) algorithm. The petrographic thin-section and the laboratory and aerial hyperspectral imaging revealed a spectrum of hydrous alteration phases as indicated by the presence of an absorption feature at 2207 nm. Moderate correlation exists between the depth of the absorption feature at 2207 nm and the point counting-derived alteration percent values, indicating reliability of laboratory-based hyperspectral analytical methods. In contrast, aerial hyperspectral data failed to provide any clear correlations to field-mapped alteration using a band-depth approach, and we interpret this due to ‘oversampling’ of surface (supergene) alteration, spectral mixing, and sensor limitations (e.g., bandwidth, signal-to-noise ratio). The hyperspectral image-derived alteration map, created using supervised image classification, can loosely be translated to a geotechnical map where porosity and permeability play a major role in localizing hydrothermal fluid flow and the formation of alteration mineral associations.

Mt. Ruapehu↗

USGS2014

Pyroclast textural variation as an indicator of eruption column steadiness in andesitic Plinian eruptions at Mt. Ruapehu

Between 27 and 11 cal. ka BP, a transition is observed in Plinian eruptions at Mt. Ruapehu, indicating evolution from non-collapsing (steady and oscillatory) eruption columns to partially collapsing columns (both wet and dry). To determine the causes of these variations over this eruptive interval, we examined lapilli fall deposits from four eruptions representing the climactic phases of each column type. All eruptions involve andesite to basaltic andesite magmas containing plagioclase, clinopyroxene, orthopyroxene and magnetite phenocrysts. Differences occur in the dominant pumice texture, the degree of bulk chemistry and textural variability, the average microcrystallinity and the composition of groundmass glass. In order to investigate the role of ascent and degassing processes on column stability, vesicle textures were quantified by gas volume pycnometry (porosity), X-ray synchrotron and computed microtomography (μ-CT) imagery from representative clasts from each eruption. These data were linked to groundmass crystallinity and glass geochemistry. Pumice textures were classified into six types (foamy, sheared, fibrous, microvesicular, microsheared and dense) according to the vesicle content, size and shape and microlite content. Bulk porosities vary from 19 to 95 % among all textural types. Melt-referenced vesicle number density ranges between 1.8 × 10 2 and 8.9 × 10 2 mm −3 , except in fibrous textures, where it spans from 0.3 × 10 2 to 53 × 10 2 mm −3 . Vesicle-free magnetite number density varies within an order of magnitude from 0.4 × 10 2 to 4.5 × 10 2 mm −3 in samples with dacitic groundmass glass and between 0.0 and 2.3 × 10 2 mm −3 in samples with rhyolitic groundmass. The data indicate that columns that collapsed to produce pyroclastic flows contained pumice with the greatest variation in bulk composition (which overlaps with but extends to slightly more silicic compositions than other eruptive products); textures indicating heterogeneous bubble nucleation, progressively more complex growth history and shear-localization; and the highest degrees of microlite crystallization, most evolved melt compositions and lowest relative temperatures. These findings suggest that collapsing columns in Ruapehu have been produced when strain localization is prominent, early bubble nucleation occurs and variation in decompression rate across the conduit is greatest. This study shows that examination of pumice from steady phases that precede column collapse may be used to predict subsequent column behaviour.

Mt. Ruapehu↗