USGS ScienceSearch

Geology topics

Research about Latah County, Idaho

Source-linked reports with geographic coverage including Latah County, Idaho.

3 recordsLinked to original sources

Detection of deer at remote camera sites in relation to snow conditions

In the rain-snow transition zone of the Pacific Northwest, climate change is expected to alter the incidence of rain-on-snow and freeze-thaw events, which will change snow density and hardness dynamics. In winter, the ability of economically and ecologically important wildlife species, such as deer ( Odocoileus spp.), to efficiently move through the landscape and access forage is mediated by snow conditions. Therefore, snow properties such as density and hardness can directly affect how energetically costly it is for these animals to survive. However, little is known about whether and how ungulates use habitats based on snow density and hardness. We deployed a stratified network of remote camera stations in complex forested terrain in Latah County, Idaho, USA, to remotely measure snow depth and detect deer. We also collected snow density and hardness measurements throughout the winter. We used these data to determine the degree to which the probability of deer presence at cameras could be explained by snow conditions and air temperature. Snow depth and density had negative relationships with the probability of deer presence, while ram resistance (a proxy for snow hardness) had a marginal positive effect. We were able to estimate snow conditions important to deer in winter 2020–2021 primarily using data obtained from cameras. This provides an important proof-of-concept that can be applied at different sites and climate conditions to gain a deeper understanding of how deer are affected by snowpack properties. These methods can be used by managers to determine how ungulates are affected by snow depth, density, and hardness collectively and subsequently inform ungulate management in a changing climate.

Idaho

Virtual snow stakes: a new method for snow depth measurement at remote camera stations

Remote cameras are used to study demographics, ecological processes, and behavior of wildlife populations. Cameras have also been used to measure snow depth with physical snow stakes. However, concerns that physical instruments at camera sites may influence animal behavior limit installation of instruments to facilitate collecting such data. Given that snow depth data are inherently contained within images, potential insights that could be made using these data are lost. To facilitate camera-based snow depth observations without additional equipment installation, we developed a method implemented in an R package called edger to superimpose virtual measurement devices onto images. The virtual snow stakes can be used to derive snow depth measurements. We validated the method for snow depth estimation using camera data from Latah County, Idaho, USA in winter 2020–2021. Mean bias error between the virtual snow stake and a physical snow stake was 5.8 cm; the mean absolute bias error was 8.8 cm. The mean Nash Sutcliffe Efficiency score comparing the fit of the 2 sets of measurements within each camera was 0.748, indicating good agreement. The edger package provides researchers with a means to take critical measurements for ecological studies without the use of physical objects that could alter animal behavior, and snow data at finer scales can complement other snow data sources that have coarser spatial and temporal resolution.

Idaho

Stanford clay deposit, Latah County, Idaho

The Stanford clay deposit, Latah County, Idaho, is about 4 miles northwest of Deary, Idaho. During World War II, the area was studied by the U. S. Geological Survey in cooperation with the U. S. Bureau of Mines. The Bureau of Mines hand-augered 10 holes and made chemical analyses on the samples for available alumina and available ferric oxide, and also measured the ignition loss. The deposit contains three types of clay: granitic residual clay derived from the weathering of Cretaceous granodiorite in place; basaltic residual clay derived from the weathering of Tertiary Columbia River basalts in place; and transported clays of the Latah formation derived from the weathered debris of the granodiorite and older rocks. Only the transported clays are considered as a potential source of available alumina and ceramic-grade clay in the Stanford deposit. The Stanford deposit averages 24.8 percent available alumina and 2 percent available ferric oxide. Transported clays containing more than 15 percent available alumina and less than 5% percent available ferric oxide would be suitable for many ceramic products and some may meet the requirements of high-heat or super-heat duties. Therefore, the clays are usable for ceramic structural ware such as bricks, terra cotta, and drain tile.

Idaho