USGS ScienceSearch

Geology topics

Research about Illapel

Source-linked reports with geographic coverage including Illapel.

2 recordsLinked to original sources

Integrated geophysical characteristics of the 2015 Illapel, Chile, earthquake

On 16 September 2015, a Mw 8.3 earthquake ruptured the subduction zone offshore of Illapel, Chile, generating an aftershock sequence with 14 Mw 6.0–7.0 events. A double source W phase moment tensor inversion consists of a Mw 7.2 subevent and the main Mw 8.2 phase. We determine two slip models for the mainshock, one using teleseismic broadband waveforms and the other using static GPS and InSAR surface displacements, which indicate high slip north of the epicenter and west-northwest of the epicenter near the oceanic trench. These models and slip distributions published in other studies suggest spatial slip uncertainties of ~25 km and have peak slip values that vary by a factor of 2. We relocate aftershock hypocenters using a Bayesian multiple-event relocation algorithm, revealing a cluster of aftershocks under the Chilean coast associated with deep (20–45 km depth) mainshock slip. Less vigorous aftershock activity also occurred near the trench and along strike of the main aftershock region. Most aftershocks are thrust-faulting events, except for normal-faulting events near the trench. Coulomb failure stress change amplitudes and signs are uncertain for aftershocks collocated with deeper mainshock slip; other aftershocks are more clearly associated with loading from the mainshock. These observations reveal a frictionally heterogeneous interface that ruptured in patches at seismogenic depths (associated with many aftershocks) and with homogeneous slip (and few aftershocks) up to the trench. This event likely triggered seismicity separate from the main slip region, including along-strike events on the megathrust and intraplate extensional events.

Illapel

A study of the 2015 Mw 8.3 Illapel earthquake and tsunami: Numerical and analytical approaches

The September 16, 2015 Illapel, Chile earthquake triggered a large tsunami, causing both economic losses and fatalities. To study the coastal effects of this earthquake, and to understand how such hazards might be accurately modeled in the future, different finite fault models of the Illapel rupture are used to define the initial condition for tsunami simulation. The numerical code Non-hydrostatic Evolution of Ocean WAVEs (NEOWAVE) is employed to model the tsunami evolution through the Pacific Ocean. Because only a short time is available for emergency response, and since the earthquake and tsunami sources are close to the coast, gaining a rapid understanding of the near-field run-up behavior is highly relevant to Chile. Therefore, an analytical solution of the 2 ? 1 D shallow water wave equations is considered. With this solution, we show that we can quickly estimate the run-up distribution along the coastline, to first order. After the earthquake and tsunami, field observations were measured in the surrounded coastal region, where the tsunami resulted in significant run-up. First, we compare the analytical and numerical solutions to test the accuracy of the analytical approach and the field observations, implying the analytic approach can accurately model tsunami run-up after an earthquake, without sacrificing the time necessary for a full numerical inversion. Then, we compare both with field run-up measurements. We observe the consistency between the two approaches. To complete the analysis, a tsunami source inversion is performed using run-up field measurements only. These inversion results are compared with seismic models, and are shown to capture the broad-scale details of those models, without the necessity of the detailed data sets they invert.

Illapel