USGS Science⌕ Search

Geology topics

T.A. Moore

Publications and source records attributed to T.A. Moore.

10 recordsLinked to original sources
USGS2001

Crocoite: An unusual mode of occurrence for lead in coal

What is believed to be a very unusual mode of occurrence for lead in coal has been identified as crocoite (PbCrO4). As part of a larger study on trace elements and mineralogy in the Cretaceous Main Seam in New Zealand, crocoite was found in raw coal samples within the lower part of the coal seam. X-ray diffraction (XRD) and bulk chemical data from a SEM equipped with an energy dispersive X-ray analyser (EDXA) have confirmed the identity of this mineral. This is apparently the first time that crocoite has been reported in coal. Crocoite usually occurs only in the oxidised zone of lead mineral deposits. The occurrence of this mineral in the Main Seam coal implies that the deposit was exposed to an oxidising environment at some stage, most likely after coalification. Published by Elsevier Science B.V.

International Journal of Coal Geology↗
USGS1993

Differentiation of volcanic ash-fall and water-borne detrital layers in the Eocene Senakin coal bed, Tanjung Formation, Indonesia

The Sangsang deposit of the Eocene Senakin coal bed, Tanjung Formation, southeastern Kalimantan, Indonesia, contains 11 layers, which are thin (<5 cm) and high in ash (> 70%). These layers are characterized by their pelitic macroscopic texture. Examination of eight of the layers by scanning-electron microscopy, energy-dispersive X-ray, and X-ray diffraction analyses show that they are composed primarily of fairly well-crystallized kaolinite, much of which is vermicular. Accessory minerals include abundant Ti oxide, rare-earth element-rich Ca and A1 phosphates, quartz that luminescences in the blue color range, and euhedral to subhedral pyroxene, hornblende, zircon, and sanidine. Although this mineral suite is suggestive of volcanic ash-fall material, only the four pelitic layers in the middle of the bed are thought to be solely derived from volcanic ash-falls on the basis of diagnostic minerals, replaced glass shards, and lithostratigraphic relationships observed in core and outcrop. The three uppermost pelitic layers contain octahedral chromites, some quartz grains that luminesce in teh orange color range, and some quartz grains that contain two-phase fluid inclusions. These layers are interpreted to be derived from a combination of volcanic ash-fall material and hydrologic transport of volcaniclastic sediment. In contrast, the lowermost pelitic layer, which contains large, rounded FeMg-rich chromites, is thought to have been dominantly deposited by water. The source of the volcanic ash-fall material may have been middle Tertiary volcanism related to plate tectonic activity between Kalimantan and Sulawesi. The volcanic ash was deposited in sufficient amounts to be preserved as layers within the coal only in the northern portions of the Senakin region: the southern coal beds in the region do not contain pelitic layers.

southeastern Kalimantan↗
USGS1993

Factors affecting the geochemistry of a thick, subbituminous coal bed in the Powder River Basin: Volcanic, detrital, and peat-forming processes

The inorganic geochemistry and mineralogy of three cores from the Anderson-Dietz 1 coal bed, a 15.2-m-thick subbituminous coal bed in the Tongue River Member (Paleocene) of the Fort Union Formation, were examined (1) to determine if the cores could be correlated by geochemical composition alone over a total distance of 2 km and (2) to identify the major factors that influenced the geochemistry of the coal bed. Chemical data (46 elements on a coal-ash basis) for 81 coal samples and 4 carbonaceous rock samples, with most samples representing a 0.6-m-thick (2-ft) interval of core, were grouped into compositional clusters by means of cluster analysis. Seven major clusters were produced; two of these clusters can be used to correlate the coal bed throughout the study area. Data from scanning electron and optical microscope analyses indicate that several factors influenced the geochemistry of the Anderson-Dietz 1 coal bed. The majority of mineral grains in the coal bed are interpreted to be detrital (water borne); evidence includes the presence of rounded to subrounded quartz grains having two-phase, aqueous fluid inclusions characteristic of hydrothermal or low-to-moderate grade metamorphic quartz. These quartz grains are found throughout the coal bed but are most abundant in samples from the midpart of the bed, which was influenced by detrital input associated with the deposition of the clastic rocks that form the split between the Anderson and Dietz 1 coal beds 900 m to the east of the study area. In addition to the detrital minerals mentioned above, volcanic ash that was fluvially transported to the sites of peat deposition or possibly deposited as air-fall volcanic ash also affected the geochemistry of the coal bed. For example, crandallite(?), a mineral reported to form as an alteration product of volcanic ash, is found in seven samples from the coal bed. The presence of quartz grains containing silicate-melt inclusions in eight samples from the coal bed.provides further support for a volcanic ash component. Other factors that probably affected the geochemistry of the coal bed include (1) detrital input associated with the deposition of the roof rocks of the coal bed, (2) peat-forming processes and plant material, and (3) epigenetic ground-water flow.

Montana, Wyoming↗
USGS1992

Petrographic and anatomical characteristics of plant material from two peat deposits of Holocene and Miocene age, Kalimantan, Indonesia

Samples from two peat-forming environments of Holocene and Miocene age in Kalimantan (Borneo), Indonesia, were studied petrographically using nearly identical sample preparation and microscopic methodologies. Both deposits consist of two basic types of organic material: plant organs/tissues and fine-grained matrix. There are seven predominant types of plant organs and tissues: roots possessing only primary growth, stems possessing only primary growth, leaves, stems/roots with secondary growth, secondary xylem fragments, fragments of cork cells, and macerated tissue of undetermined origin. The fine-grained matrix consists of fragments of cell walls and cell fillings, fungal remains, spores and pollen grains, and resin. Some of the matrix material does not have distinct grain boundaries (at ??500) and this material is designated amorphous matrix. The major difference between the Holocene peat and Miocene lignite in reflected light, oil immersion is a loss of red coloration in the cell walls of tissue in the lignite, presumably due to loss of cellulosic compounds. In addition, cortex and phloem tissue (hence primary roots and stems) are difficult to recognize in the lignite, probably because these large, thin-walled tissues are more susceptible to microbial degradation and compaction. Particle size in both peat and lignite samples display a bimodal distribution when measurements are transformed to a - log2 or phi (??), scale. Most plant parts have modes of 2-3?? (0.25 - 0.125 mm), whereas the finer-grained particulate matrix has modes of 7-9?? (0.008-0.002 mm). This similarity suggest certain degradative processes. The 2-3?? range may be a "stable" size for plant parts (regardless of origin) because this is a characteristics of a substrate which is most suitable for plant growth in peat. The finer-grained matrix material (7-9??) probably results from fungal decay which causes plant material to weaken and with slight physical pressure to shatter into its component parts, i.e. fragments of cell walls and fillings. The absence of differences in particle size between the peat and lignite also indicate little compaction of organic components; rather an extreme loss in water content and pore space has occurred from between the particles of organic material. ?? 1992.

Review of Palaeobotany and Palynology↗
USGS1990

Maceral and palynomorph facies from two tertiary peat-forming environments in the Powder River Basin, U.S.A.

The differences between the depositional settings of the Smith and Anderson subbituminous coal beds (Paleocene, central Powder River Basin, U.S.A.) are interpreted on the basis of their petrographic composition and palynologic assemblages. The Smith coal bed is relatively thin (&lt; 5 m ) "> (< 5m) and has a high degree of thickness variation (0–5 m) over short distances (&lt; 8 km ) "> (< 8km) , the result of deposition in an anastomosed fluvial environment where numerous lakes and small channels limited the extent of peat deposits. Although plants related to the living genus Glyptostrobus dominated the swamp, peat-forming plant communities contained mixes of ancestral species of Platanus and Ulmus as well as vegetation of lower stature such as Spagnum . Some intervals within the coal bed contain anomalously high concentrations of cell walls (humotelinite) and cell fillings (corpohuminite), some of which came from locally abundant, decay-resistant Pinaceae (or pinaceous) vegetation. Raised areas of the peat swamp characterized by Sphagnum were also favorable for the accumulation of carbonized plant components (inertinites). Because the peat of the Anderson coal bed formed on top of thick (&gt; 50 m ) "> (> 50m) sandstone bodies of an abandoned meander-belt complex, the coal bed is generally thicker (&gt; 7 m ) "> (> 7m) and more widespread (&gt; 15 km ) "> (> 15km) in extent than the Smith coal bed. The sands provided a relatively stable, poorly compactable platform that was favorable to the growth of large, arborescent vegetation, such as the dominant ancestral Glyptostrobus , as well as ancestral Nyssa, Carya , and Betulaceae in a well-drained but moist swamp environment. The stability of the peat-forming environment resulted in a raised peat deposit of relatively uniform paleoflora and peat composition. In the thicker areas of the Anderson coal bed, the upward increase in carbonized plant components indicates a progressively drier or better-drained swamp environment. Intervals within the coal bed that overlie or are lateral to crevasse-splay deposits contain a high concentration of pollen attributable to Pterocarya and an absence of carbonized plant remains, an indication that ancestral Pterocarya preferred a water-saturated environment close to the edge of the swamp where detrial influx occurred.

International Journal of Coal Geology↗
USGS1982

Use of geophysical logs in recognizing depositional environments in the Tongue River Member of the Fort Union Formation, Powder River area, Wyoming and Montana

The environmental conditions under which rocks in the Paleocene Tongue River Member of the Fort Union Formation were deposited in the Powder River area, Wyoming and Montana, can be determined using geophysical logs with some limitations. It is widely recognized that gamma ray and density logs are useful in identifying thickness and stratigraphic position of coal beds. In addition, gamma ray and electrical resistivity logs can be used to infer conditions of transportation and deposition of sandstones, siltstones, and other rock types. In particular, intensity responses of the gamma ray and resistance logs provide a clue to variations of grain size such as fining-upward and coarsening-upward characteristics of fluvial channel and crevasse splay deposits, respectively. These signatures in the geophysical logs are readily observed for some beds; for other beds however, the depositional conditions are difficult to determine because the beds do not produce clear-cut log-response patterns. Thus,. analysis of the environments of deposition of detrital rocks in drill holes can be made more accurate by a study of stratigraphically equivalent intervals in outcrops near drill-hole sites.

Open-File Report↗