Geology topics

T. Matsuzawa

Publications and source records attributed to T. Matsuzawa.

3 recordsLinked to original sources

USGS2007

Source parameters of a M4.8 and its accompanying repeating earthquakes off Kamaishi, NE Japan: Implications for the hierarchical structure of asperities and earthquake cycle

We determine the source parameters of a M4.9 ?? 0.1 'characteristic earthquake' sequence and its accompanying microearthquakes at ???50 km depth on the subduction plate boundary offshore of Kamaishi, NE Japan. The microearthquakes tend to occur more frequently in the latter half of the recurrence intervals of the M4.9 ?? 0.1 events. Our results show that the microearthquakes are repeating events and they are located not only around but also within the slip area for the 2001 M4.8 event. From the hierarchical structure of slip areas and smaller stress drops for the microearthquakes compared to the M4.8 event, we infer the small repeating earthquakes rupture relatively weak patches in and around the slip area for the M4.8 event and their activity reflects a stress concentration process and/or change in frictional property (healing) at the area. We also infer the patches for the M4.9 ?? 0.1 and other repeating earthquakes undergo aseismic slip during their interseismic period. Copyright 2007 by the American Geophysical Union.

Geophysical Research Letters↗

USGS2007

Anomalous deepening of a belt of intraslab earthquakes in the Pacific slab crust under Kanto, central Japan: Possible anomalous thermal shielding, dehydration reactions, and seismicity caused by shallower cold slab material

[1] A belt of intraslab seismicity in the Pacific slab crust parallel to iso-depth contours of the plate interface has been found beneath Hokkaido and Tohoku. Hypocenter relocations have shown that this seismic belt does not run parallel to but obliquely to the iso-depth contours beneath Kanto, deepening toward the north from ∼100 km to ∼140 km depth. The depth limit of the contact zone with the overlying Philippine Sea slab is located close to and parallel to this obliquely oriented seismic belt, suggesting that the deepening of the seismic belt there is caused by the contact with the overlying slab. The contact with this cold slab hinders the heating of the Pacific slab crust by hot mantle wedge, which would cause delay of eclogite-forming phase transformations and hence deepening of the seismic belt there. The depth limit of the subducting low-velocity crust also deepens toward the north, supporting this idea.

Geophysical Research Letters↗

USGS2004

Source parameters and rupture velocities of microearthquakes in western Nagano, Japan, determined using stopping phases

We use an inversion method based on stopping phases (Imanishi and Takeo, 2002) to estimate the source dimension, ellipticity, and rupture velocity of microearthquakes and investigate the scaling relationships between source parameters. We studied 25 earthquakes, ranging in size from M 1.3 to M 2.7, that occurred between May and August 1999 at the western Nagano prefecture, Japan, which is characterized by a high rate of shallow earthquakes. The data consist of seismograms recorded in an 800-m borehole and at 46 surface and 2 shallow borehole seismic stations whose spacing is a few kilometers. These data were recorded with a sampling frequency of 10 kHz. In particular, the 800-m-borehole data provide a wide frequency bandwidth with greatly reduced ground noise and coda wave amplitudes compared with surface recordings. High-frequency stopping phases appear in the body waves in Hilbert transform pairs and are readily detected on seismograms recorded in the 800-m borehole. After correcting both borehole and surface data for attenuation, we also measure the rise time, which is defined as the interval from the arrival time of the direct wave to the timing of the maximum amplitude in the displacement pulse. The differential time of the stopping phases and the rise times were used to obtain source parameters. We found that several microearthquakes propagated unilaterally, suggesting that all microearthquakes cannot be modeled as a simple circular crack model. Static stress drops range from approximately 0.1 to 2 MPa and do not vary with seismic moment. It seems that the breakdown in stress drop scaling seen in previous studies using surface data is simply an artifact of attenuation in the crust. The average value of rupture velocity does not depend on earthquake size and is similar to those reported for moderate and large earthquakes. It is likely that earthquakes are self-similar over a wide range of earthquake size and that the dynamics of small and large earthquakes are similar.

Bulletin of the Seismological Society of America↗