T. Liu | USGS Science

USGS2023

Guidance for parameterizing post-fire hydrologic models with in situ infiltration measurements

Wildfire can alter soil-hydraulic properties, often resulting in an increased prevalence of infiltration-excess overland flow and greater potential for debris-flow hazards. Mini disk tension infiltrometers (MDIs) can be used to estimate soil hydraulic properties, such as field-saturated hydraulic conductivity ( K fs ) and wetting front potential ( H f ), and their spatial variability following wildfire. However, the small (point-scale) footprint of MDI measurements makes it challenging to use these data to parameterize hydrologic models at the hillslope and watershed scales where hydrologic hazards, such as debris flows, initiate. Here, we designed numerical experiments to estimate spatially constant or watershed-scale effective hydrologic parameters (EHPs) that approximate the response of spatially variable hydrologic parameters with distributions derived from MDI measurements at five sites in the southwestern United States. We found that it is possible to define EHPs for both K fs and H f based on the MDI measurements that lead to reasonable approximations of run-off hydrographs at the outlets of small watersheds (<1 km 2 ). We found that watershed EHPs are functions of rainfall characteristics, although they are most sensitive to rainfall intensity and relatively less sensitive to the temporal distribution of rainfall. EHPs are lower than the arithmetic mean of the MDI measurements and are better approximated by the median or geometric mean of the MDI measurements, particularly for storms with recurrence intervals of approximately 1 year or less that commonly initiate post-fire debris flows. This work demonstrated that using the proposed upscaling method to estimate watershed-scale EHPs, as opposed to approximating EHPs based on the arithmetic mean of the MDI measurements, improved the ability of a hydrologic model to identify storms that are likely to produce debris flows. Results improved our ability to link point-scale MDI measurements and watershed-scale EHPs in post-fire settings and helped guide our ability to use MDI data to parameterize post-fire hydrologic models.

Arizona, New Mexico↗

USGS1999

Composition and origin of Early Cambrian Tiantaishan phosphorite-Mn carbonate ores, Shaanxi Province, China

The Tiantaishan phosphorite-Mn carbonate ores occur in the Early Cambrian Tananpo Formation in complexly folded and faulted rocks located in southern Shaanxi Province. About 65 x 106 tonnes of 17% P2O5 ore reserves exist and Mn-ore reserves are about 8.3 x 106 tonnes of +18% Mn. The stratigraphic sequence in ascending order consists of black phyllite, black to gray phosphorite ore, black phyllite, rhodochrostone ore, Mn mixed-carbonates, and dolostone. Data are presented from microprobe mineral chemistry, whole-rock chemistry, stable isotopes of carbonates, X-ray mineralogy, petrographic and SEM observations, and statistical analysis of chemical data. The dominant ore-forming minerals are hydroxy- and carbonate fluorapatite and Ca rhodochrosite, with Mg kutnahorite and dolomite comprising the Mn mixed-carbonate section. Pyrite occurs in all rock types and alabandite (MnS) occurs throughout the rhodochrostone section. The mean P2O5 content of phosphorite is 31% and argillaceous phosphorite is 16%, while the mean MnO content of rhodochrostone ore is 37%. Phosphorite ores are massive, spheroidal, laminated, and banded, while rhodochrostone ores have oolitic, spheroidal, and granular fabrics. The most distinguishing characteristics of the ores are high total organic carbon (TOC) contents (mean 8.4%) in the phosphorite and high P2O5 contents (mean 2.7%) in the rhodochrostone ore. The atypically high TOC contents in the Tiantaishan phosphorite probably result from very strong productivity leading to high sedimentation rates accompanied by weak reworking of sediments; poor utilization of the organic matter by bacteria; and/or partial replacement of bacterial or algal mats by the apatite. The depositional setting of the ores was the margin of an epicontinental seaway created as a direct consequence of global processes that included break-up of a supercontinent, formation of narrow seaways, creation of extensive continental shelves, overturn of stagnant, metal-rich deep-ocean waters, and marine transgression. Water depth increased from deposition of the black phyllite sequence through deposition of the Mn mixed-carbonate sequence, then shallowed again during deposition of the overlying dolostone sequence. Bottom waters were mostly dysoxic to suboxic, but fluctuated from oxic to anoxic. Productivity was high during deposition of the black phyllite sequence, increased during precipitation of phosphorite, and then decreased to moderate levels during precipitation of rhodochrostone ores. Biosilica contributions occur in each lithology, but are greatest in rhodochrostone. Changes in sedimentation were determined by changes in water depth, productivity, upwelling, sea-level change, and ventilation of the depositional basin. The source of the phosphorus was organic matter produced in great quantities during deposition of the black phyllite and phosphorite sequences in a zone of coastal upwelling. Organic matter accumulation was rapid. Globally, Mn was supplied by overturn of stagnant, metal-rich deep-ocean waters, which were redistributed to areas of coastal upwelling and seaways; that process may have been initiated by latest Proterozoic glaciations which would have promoted density stratification and accumulation and storage of metals. Regionally, Mn was supplied by terrigenous input into the shallow seaway and hydrothermal input into the deeper water parts of that seaway. Locally, Mn sources included leaching and transport of metals from the sediment column. Manganese was stored locally in low-oxygen (not anoxic) seawater prior to Mn-ore formation. The source of the carbon in the Mn carbonates and dolostones was predominantly seawater bicarbonate and secondarily CO2 derived from the oxidation of organic matter in the bacterially mediated diagenetic zone of sulfate reduction.

Ore Geology Reviews↗

USGS1998

Dating previously balanced rocks in seismically active parts of California and Nevada

Precariously balanced boulders that could be knocked down by strong earthquake ground motion are found in some seismically active areas of southern California and Nevada. In this study we used two independent surface-exposure dating techniques—rock-varnish microlamination and cosmogenic 36 Cl dating methodologies—to estimate minimum- and maximum-limiting ages, respectively, of the precarious boulders and by inference the elapsed time since the sites were shaken down. The results of the exposure dating indicate that all of the precarious rocks are >10.5 ka and that some may be significantly older. At Victorville and Jacumba, California, these results show that the precarious rocks have not been knocked down for at least 10.5 k.y., a conclusion in apparent conflict with some commonly used probabilistic seismic hazard maps. At Yucca Mountain, Nevada, the ages of the precarious rocks are >10.5 to >27.0 ka, providing an independent measure of the minimum time elapsed since faulting occurred on the Solitario Canyon fault.

Geology↗