Geology topics

T. Fournier

Publications and source records attributed to T. Fournier.

4 recordsLinked to original sources

USGS2010

Rheologic and structural controls on the deformation of Okmok volcano, Alaska: FEMs, InSAR, and ambient noise tomography

Interferometric synthetic aperture radar (InSAR) data indicate that the caldera of Okmok volcano, Alaska, subsided more than a meter during its eruption in 1997. The large deformation suggests a relatively shallow magma reservoir beneath Okmok. Seismic tomography using ambient ocean noise reveals two low‐velocity zones (LVZs). The shallow LVZ corresponds to a region of weak, fluid‐saturated materials within the caldera and extends from the caldera surface to a depth of 2 km. The deep LVZ clearly indicates the presence of the magma reservoir beneath Okmok that is significantly deeper (>4 km depth) compared to previous geodetic‐based estimates (3 km depth). The deep LVZ associated with the magma reservoir suggests magma remains in a molten state between eruptions. We construct finite element models (FEMs) to simulate deformation caused by mass extraction from a magma reservoir that is surrounded by a viscoelastic rind of country rock embedded in an elastic domain that is partitioned to account for the weak caldera materials observed with tomography. This configuration allows us to reduce the estimated magma reservoir depressurization to within lithostatic constraints, while simultaneously maintaining the magnitude of deformation required to predict the InSAR data. More precisely, the InSAR data are best predicted by an FEM simulating a rind viscosity of 7.5 × 10 16 Pa s and a mass flux of −4.2 × 10 9 kg/d from the magma reservoir. The shallow weak layer within the caldera provides a coeruption stress regime and neutral buoyancy horizon that support lateral magma propagation from the central magma reservoir to extrusion near the rim of the caldera.

Alaska↗

USGS2010

Magma flux at Okmok Volcano, Alaska, from a joint inversion of continuous GPS, campaign GPS, and interferometric synthetic aperture radar

Volcano deformation is usually measured using satellite geodetic techniques including interferometric synthetic aperture radar (InSAR), campaign GPS, and continuous GPS. Differences in the spatial and temporal sampling of each system mean that most appropriate inversion scheme to determine the source parameters from each data set is different. Most studies either compare results from independent inversions or subsample the data sets to the lowest common factor. It is unclear whether differences in the solution reflect differences in source behavior, differences in measurement bias, or differences in inversion technique. Here we develop a single inversion procedure that captures the benefits of each system, especially the daily sampling of continuous GPS and the high spatial resolution of InSAR. Okmok Volcano, Alaska, is an ideal target for such a test because a long series (<15 years) of InSAR and continuous GPS measurement exists and the source is almost continuously active and in a stable location.

Alaska↗

USGS2009

Tracking magma volume recovery at Okmok Volcano using GPS and an unscented kalman filter

Changes beneath a volcano can be observed through position changes in a GPS network, but distinguishing the source of site motion is not always straightforward. The records of continuous GPS sites provide a favorable data set for tracking magma migration. Dense campaign observations usually provide a better spatial picture of the overall deformation field, at the expense of an episodic temporal record. Combining these observations provides the best of both worlds. A Kalman filter provides a means for integrating discrete and continuous measurements and for interpreting subtle signals. The unscented Kalman filter (UKF) is a nonlinear method for time‐dependent observations. We demonstrate the application of this technique to deformation data by applying it to GPS data collected at Okmok volcano. Seven years of GPS observations at Okmok are analyzed using a Mogi source model and the UKF. The deformation source at Okmok is relatively stable at 2.5 km depth below sea level, located beneath the center of the caldera, which means the surface deformation is caused by changes in the strength of the source. During the 7 years of GPS observations more than 0.5 m of uplift has occurred, a majority of that during the time period January 2003 to July 2004. The total volume recovery at Okmok since the last eruption in 1997 is ∼60–80%. The UKF allows us to solve simultaneously for the time‐dependence of the source strength and for the location without a priori information about the source. 2009 by the American Geophysical Union.

Alaska↗

USGS2006

Ground deformation associated with the precursory unrest and early phases of the January 2006 eruption of Augustine volcano, Alaska

On January 11, 2006 Augustine Volcano erupted after nearly 20 years of quiescence. Global Positioning System (GPS) instrumentation at Augustine, consisting of six continuously recording, telemetered receivers, measured clear precursory deformation consistent with a source of inflation or pressurization beneath the volcano's summit at a depth of around sea level. Deformation began in early summer 2005, and was preceded by a subtle, but distinct, increase in seismicity, which began in May 2005. After remaining more or less constant, deformation rates accelerated on at least three stations beginning in late November 2005. After this date, GPS data suggest the upward propagation of a small dike into the edifice, which, based on the style of deformation and high levels of gas emission, appears to have ascended to shallow levels by mid-December 2005, about four weeks before the eruption began.

Alaska↗