USGS Science⌕ Search

Geology topics

T. E. Reilly

Publications and source records attributed to T. E. Reilly.

27 records · Page 2Linked to original sources
USGS1987

Analysis of saltwater upconing beneath a pumping well

Aquifer systems that contain freshwater and saltwater are usually stratified, with the more dense saltwater underlying the freshwater. A groundwater well discharging from the freshwater zone causes the saltwater to move upwards towards the well. This phenomenon is known as saltwater upconing. Two methods of analysis, the sharp-interface method and the fluid-density-dependent solute-transport method, are used to simulate saltwater upconing. Numerical experiments including comparisons of the two methods indicate: (1) for low to moderate pumpages the 50% isochlor and sharp interface correlate well; (2) the well can discharge significant concentrations of saltwater, even though a stable cone (according to the sharp-interface method) exists below the well screen; (3) an almost linear relationship exists between the well discharge rate and the concentration of the discharge at low pumping rates that maintain a stable cone; and (4) upconing is sensitive to transverse dispersivity, whereas it is insensitive to longitudinal dispersivity. A simulation of upconing at Test Site No. 4, Truro, Cape Cod, Massachusetts, indicates that the appropriate field value of transverse dispersivity is very small. This supports the validity of the sharp-interface assumption for analyzing the behavior of systems with thin saltwater-freshwater transition zones.

Journal of Hydrology↗
USGS1985

Quantitative analysis of saltwater-freshwater relationships in groundwater systems-A historical perspective

Although much progress has been made toward the mathematical description of saltwater-freshwater relationships in groundwater systems since the late 19th century, the advective and dispersive mechanisms involved are still incompletely understood. This article documents the major historical advances in this subject and summarizes the major direction of current studies. From the time of Badon Ghyben and Herzberg, it has been recognized that density is important in mathematically describing saltwater-freshwater systems. Other mechanisms, such as hydrodynamic dispersion, were identified later and are still not fully understood. Quantitative analysis of a saltwater-freshwater system attempts to mathematically describe the physical system and the important mechanisms using reasonable simplifications and assumptions. This paper, in developing the history of quantitative analysis discusses many of these simplifications and assumptions and their effect on describing and understanding the phenomenon.

Journal of Hydrology↗
USGS1985

Effects of sanitary sewers on ground-water levels and streams in Nassau and Suffolk Counties, New York; part 2: Development and application of southwest Suffolk County model

By 1990, sanitary sewers in Nassau County Sewage Disposal Districts 2 and 3 and Suffolk County Southwest Sewer District will discharge to the ocean 140 cu ft of water/sec that would otherwise be returned to the groundwater system through septic tanks and similar systems. To evaluate the effects of this loss on groundwater levels and streamflow, the U.S. Geological Survey developed a groundwater flow model that couples a fine-scale subregional model to a regional model of larger scale. The regional model generates flux boundary conditions for the subregional model, and the subregional model provides detail in the area of concern. Results indicate that the water table will decline by as much as 8 ft along the Suffolk-Nassau county line, with effects decreasing eastward. Base flow is predicted to decrease by as much as 73% in a stream along the county line, but this effect will decrease to zero just east of the sewered area. This report is one of a series describing the predicted hydrologic effects of sewers in southern Nassau and southwest Suffolk Counties. (USGS)

New York↗
USGS1985

Effects of sanitary sewers on ground-water levels and streams in Nassau and Suffolk Counties, New York; part 3: Development and application of southern Nassau County model

By 1990, sanitary sewers in Nassau County Sewage Disposal Districts 2 and 3 and Suffolk County Southwest Sewer District will discharge to the ocean 140 cu ft of water per second that would otherwise be returned to the groundwater system through septic tanks and similar systems. To evaluate the effects of this loss on groundwater levels and streamflow, the U.S. Geological Survey developed a groundwater flow model that couples a fine-scale subregional model to a regional model of a larger scale. The regional model generates flux boundary conditions for the subregional model, and the subregional model provides detail in the area of concern. Results indicate that the water table will decline by as much as 90% from conditions in the early 1970's. This report is one of a three-part series describing the predicted hydrologic effects of sewers in southern Nassau and southwestern Suffolk Counties.

New York↗
USGS1984

Definition of boundary and initial conditions in the analysis of saturated ground-water flow systems; an introduction

Accurate definition of boundary and initial conditions is an essential part of conceptualizing and modeling ground-water flow systems. This report explains the properties of the seven most common boundary conditions encountered in ground-water systems and discusses major aspects of their application. It also discusses the significance and specification of initial conditions and evaluates some common errors in applying this concept to ground-water system models. (USGS)

Open-File Report↗
USGS1984

The principle of superposition and its application in ground-water hydraulics

The principle of superposition, a powerful methematical technique for analyzing certain types of complex problems in many areas of science and technology, has important application in ground-water hydraulics and modeling of ground-water systems. The principle of superposition states that solutions to individual problems can be added together to obtain solutions to complex problems. This principle applies to linear systems governed by linear differential equations. This report introduces the principle of superposition as it applies to groundwater hydrology and provides background information, discussion, illustrative problems with solutions, and problems to be solved by the reader. (USGS)

Open-File Report↗
USGS1983

Effects of sanitary sewers on ground-water levels and streams in Nassau and Suffolk Counties, New York, part 1: Geohydrology, modeling strategy, and regional evaluation

A computer simulation of Long Island 's regional groundwater system has been used to evaluate the effects that new-installed sewers will have on ground-water levels. Results indicate maximum water-table decliners of as much as up to 18 feet in central Nassau County and about 9 feet in Suffolk County. Total stream base flows and freshwater outflow to the south shore bay system will decrease by 22%. The regional scale of the model does not permit detailed predictions for individual streams. To quantify the effects of lowered ground-water levels on individual streams, two fine-scale sub-regional models have been designed. This report, the first in a three-part series describing the simulated effects of sewers in southern Nassau and southwestern Suffolk Counties, presents the hydrogeologic setting, pertinent literature, modeling strategy, subregional model design, and the results obtained to date from the regional ground-water model. The regional model results described will be used in the later reports to generate flux boundary conditions for the subregional models.

New York↗
USGS1982

Analysis of three tests of the unconfined aquifer in southern Nassau County, Long Island, New York

Drawdown and recovery data from three 2-day aquifer tests (OF) the unconfined (water-table) aquifer in southern Nassau County, N.Y., during the fall of 1979, were analyzed. Several simple analytical solutions, a typecurve-matching procedure, and a Galerkin finite-element radial-flow model were used to determine hydraulic conductivity, ratio of horizontal to vertical hydraulic conductivity, and specific yield. Results of the curve-matching procedure covered a broad range of values that could be narrowed through consideration of data from other sources such as published reports, drillers ' logs, or values determined by analytical solutions. Analysis by the radial-flow model was preferred because it allows for vertical variability in aquifer properties and solves the system for all observation points simultaneously, whereas the other techniques treat the aquifer as homogeneous and must treat each observation well separately. All methods produced fairly consistent results. The ranges of aquifer values at the three sites were: horizontal hydraulic conductivity, 140 to 380 feet per day; transmissivity 11,200 to 17,100 feet squared per day; ratio of horizontal to vertical hydraulic conductivity 2.4:1 to 7:1, and specific yield , 0.13 to 0.23. (USGS)

Water-Resources Investigations Report↗