USGS Science⌕ Search

Geology topics

T. Cao

Publications and source records attributed to T. Cao.

6 recordsLinked to original sources
USGS2011

Fault displacement hazard for strike-slip faults

In this paper we present a methodology, data, and regression equations for calculating the fault rupture hazard at sites near steeply dipping, strike-slip faults. We collected and digitized on-fault and off-fault displacement data for 9 global strikeslip earthquakes ranging from moment magnitude M 6.5 to M 7.6 and supplemented these with displacements from 13 global earthquakes compiled byWesnousky (2008), who considers events up to M 7.9. Displacements on the primary fault fall off at the rupture ends and are often measured in meters, while displacements on secondary (offfault) or distributed faults may measure a few centimeters up to more than a meter and decay with distance from the rupture. Probability of earthquake rupture is less than 15% for cells 200 m??200 m and is less than 2% for 25 m??25 m cells at distances greater than 200mfrom the primary-fault rupture. Therefore, the hazard for off-fault ruptures is much lower than the hazard near the fault. Our data indicate that rupture displacements up to 35cm can be triggered on adjacent faults at distances out to 10kmor more from the primary-fault rupture. An example calculation shows that, for an active fault which has repeated large earthquakes every few hundred years, fault rupture hazard analysis should be an important consideration in the design of structures or lifelines that are located near the principal fault, within about 150 m of well-mapped active faults with a simple trace and within 300 m of faults with poorly defined or complex traces.

Bulletin of the Seismological Society of America↗
USGS2005

Model uncertainties of the 2002 update of California seismic hazard maps

In this article we present and explore the source and ground-motion model uncertainty and parametric sensitivity for the 2002 update of the California probabilistic seismic hazard maps. Our approach is to implement a Monte Carlo simulation that allows for independent sampling from fault to fault in each simulation. The source-distance dependent characteristics of the uncertainty maps of seismic hazard are explained by the fundamental uncertainty patterns from four basic test cases, in which the uncertainties from one-fault and two-fault systems are studied in detail. The California coefficient of variation (COV, ratio of the standard deviation to the mean) map for peak ground acceleration (10% of exceedance in 50 years) shows lower values (0.1-0.15) along the San Andreas fault system and other class A faults than along class B faults (0.2-0.3). High COV values (0.4-0.6) are found around the Garlock, Anacapa-Dume, and Palos Verdes faults in southern California and around the Maacama fault and Cascadia subduction zone in northern California.

Bulletin of the Seismological Society of America↗
USGS2000

Active Fault Near-Source Zones Within and Bordering the State of California for the 1997 Uniform Building Code

The fault sources in the Project 97 probabilistic seismic hazard maps for the state of California were used to construct maps for defining near-source seismic coefficients, N a and N v , incorporated in the 1997 Uniform Building Code (ICBO 1997). The near-source factors are based on the distance from a known active fault that is classified as either Type A or Type B. To determine the near-source factor, four pieces of geologic information are required: (1) recognizing a fault and determining whether or not the fault has been active during the Holocene, (2) identifying the location of the fault at or beneath the ground surface, (3) estimating the slip rate of the fault, and (4) estimating the maximum earthquake magnitude for each fault segment. This paper describes the information used to produce the fault classifications and distances.

California↗
USGS2000

A time-dependent probabilistic seismic-hazard model for California

For the purpose of sensitivity testing and illuminating nonconsensus components of time-dependent models, the California Department of Conservation, Division of Mines and Geology (CDMG) has assembled a time-dependent version of its statewide probabilistic seismic hazard (PSH) model for California. The model incorporates available consensus information from within the earth-science community, except for a few faults or fault segments where consensus information is not available. For these latter faults, published information has been incorporated into the model. As in the 1996 CDMG/U.S. Geological Survey (USGS) model, the time-dependent models incorporate three multisegment ruptures: a 1906, an 1857, and a southern San Andreas earthquake. Sensitivity tests are presented to show the effect on hazard and expected damage estimates of (1) intrinsic (aleatory) sigma, (2) multisegment (cascade) vs. independent segment (no cascade) ruptures, and (3) time-dependence vs. time-independence. Results indicate that (1) differences in hazard and expected damage estimates between time-dependent and independent models increase with decreasing intrinsic sigma, (2) differences in hazard and expected damage estimates between full cascading and not cascading are insensitive to intrinsic sigma, (3) differences in hazard increase with increasing return period (decreasing probability of occurrence), and (4) differences in moment-rate budgets increase with decreasing intrinsic sigma and with the degree of cascading, but are within the expected uncertainty in PSH time-dependent modeling and do not always significantly affect hazard and expected damage estimates.

California↗