USGS Science⌕ Search

Geology topics

Sulo Werner Wiitala

Publications and source records attributed to Sulo Werner Wiitala.

7 recordsLinked to original sources

Floods in the Skunk River basin, Iowa

Evaluation of flood hazards, and the planning, design, and operation of various facilities on flood plains require information on floods. This report provides information on flood stages and discharges, flood magnitudes and frequency, and flood profiles for the Skunk River and some of its tributaries. It covers the Skunk -- South Skunk Rivers to Ames, and the lower reaches of tributaries as flows: Squaw Creek, 8.2 miles; Indian Creek, 11.6 miles; North Skunk River, 83.2 miles; Cedar Creek, 55.8 miles; and Big Creek, 21.7 miles.

Iowa↗

Water resources of the Marquette Iron Range area, Michigan

Large quantities of water are needed in the beneficiation and pelletizing processes by which the ore mined from low-grade iron-formations is upgraded into an excellent raw material for the iron and steel industry. Extensive reserves of low-grade iron-formation available for development herald an intensification of the demands upon the area's water supplies. This study was designed to provide water facts for public and private agencies in planning orderly development and in guiding the management of the water resources to meet existing and new requirements. Inland lakes and streams are the best potential sources of water for immediate development. The natural flow available for 90 percent of the time in the Middle and East Branches of the Escanaba River, the Carp River, and the Michigamme River is about 190 cubic feet per second. Potential storage sites are identified, and their complete development could increase the available supply from the above streams to about 450 cubic feet per second. Outwash deposits are the best potential sources of ground water. Large supplies could be developed from extensive outwash deposits in the eastern part of the area adjacent to Goose Lake Outlet and the East Branch Escanaba River. Other areas of outwash occur in the vicinity of Humboldt, West Branch Creek, and along the stream valleys. Streamflow data were used to make rough approximations of the ground-water potential in some areas. In general, however, the available data were not sufficient to permit quantitative evaluation of the potential ground-water supplies. Chemical quality of the surface and ground waters of the area is generally acceptable for most uses. Suspended sediment in the form of mineral tailings in effluents from ore-processing plants is a potential problem. Existing plants use settling basins to effectively remove most of the suspended material. Available records indicate that suspended-sediment concentrations and loads in the receiving waters have not been significantly increased by these operations. Present water use is about 60 cubic feet per second in the area. Thus, available water supplies are believed to be adequate for existing and foreseeable new uses. Water management, rather than water availability, is of prime consideration in this area. Time distribution of available water supplies, distribution of water to points of use, effect of surface-water development upon ground water and vice versa, and possible conflicts with competing uses are some of the management problems that are discussed. The presence of many inland lakes, favorable storage sites on streams, and several promising acquifers provide flexibility in possible water-management operations. A discussion of the interrelationships between surface and ground water and a ground-water budget are presented to render a better understanding of the hydrologic system with which water management will be concerned.

Michigan↗

Water resources of the Flint area, Michigan

This report describes the water resources of Genesee County, Mich., whose principal city is Flint. The sources of water available to the county are the Flint and Shiawassee Rivers and their tributaries, inland lakes, ground water, and Lake Huron. The withdrawal use of water in the county in 1958 amounted to about 45 mgd. Of this amount, 36 mgd was withdrawn from the Flint River by the Flint public water-supply system. The rest was supplied by wells. At present (1959) the Shiawassee River and its tributaries and the inland lakes are not used for water supply. Flint River water is used for domestic, industrial, and waste-dilution requirements in Flint. About 60 percent of the water supplied by the Flint public water system is used by Flint industry. At least 30 mgd of river water is needed for waste dilution in the Flint River during warm weather. Water from Holloway Reservoir, which has a storage capacity of 5,760 million gallons, is used to supplement low flows in the Flint River to meet water-supply and waste-dilution requirements. About 650 million gallons in Kearsley Reservoir, on a Flint River tributary, is held in reserve for emergency use. Based on records for the lowest flows during the period 1930-52, the Flint River system, with the two reservoirs in operation, is capable of supplying about 60 mgd at Flint, less evaporation and seepage losses. The 1958 water demands exceeded this amount. Development of additional storage in the Flint River basin is unlikely because of lack of suitable storage sites. Plans are underway to supply Flint and most of Genesee County with water from Lake Huron. The principal tributaries of the Flint River in and near Flint could furnish small supplies of water. Butternut Creek, with the largest flow of those studied, has an estimated firm yield of 0.054 mgd per sq mi for 95 percent of the time. The Shiawassee River at Byron is capable of supplying at least 29 mgd for 95 percent of the time. Floods are a serious problem in Flint. The April 1947 flood, the largest on record, caused nearly $4 million flood damage in Flint. A proposed flood-control plan for Flint calls for channel, floodwall, and levee improvements and the removal or modification of some bridges. Analyses of water samples taken from selected streams and lakes in the Flint area indicate that the waters are of the calcium bicarbonate type and generally hard to very hard. Flint River water is relatively uniform in quality although a progressive increase in iron, sodium, and chloride concentrations was noted between Otisville and Montrose. Downstream from Flint, the dissolved oxygen content may be low during low flows. At times, concentrations of iron, manganese, phenols, color, and turbidity in Flint River water exceed the limits recommended in drinking water standards. Water temperatures ranged from freezing to 86°F in a 4-year period. The finished water supplied by the Flint water-treatment plant is fairly uniform in quality, moderately soft, alkaline, and low in color and turbidity. The pH is nearly always above 10. Further softening and removal of iron and related minerals would be desirable for certain industrial uses. The quality of the water sampled in the Flint River tributaries was generally similar to that of the Flint River. However, no phenols or oils and waxes were found. Softening and other treatment dependent upon use would be required if these streams were developed for water supply. Waters sampled in the Shiawassee River and selected lakes were generally less mineralized than Flint River water. Water from the lakes showed the lowest concentrations of dissolved solids. Softening would be required for nearly all uses. Additional treatment would depend upon contemplated use. Shallow deposits of sand and gravel deposited as outwash along glacial meltwater streams and as deltas in the glacial lakes that covered the northwestern part of the county are sources of water to moderate- and large-capacity wells. Thick deposits of sand and gravel also fill some of the valleys in the bedrock surface and yield moderate to large supplies of water. Production from public supply wells tapping the drift aquifers in the area ranges from about 50 to 1,200 gpm. The water from the drift aquifer is hard or very hard and commonly contains objectionable amounts of iron. The Saginaw formation is a source of water to wells supplying some of the small communities and industries in the county. The Saginaw, which is the uppermost bedrock formation in the area, underlies most of the county. It is composed of layers of sandstone, shale, and limestone and some beds of coal. The formation is composed principally of sandstone in some areas of the county, and shale in others. Production from wells tapping the Saginaw ranges from a few to about 500 gpm. The water produced is generally moderately hard or hard and commonly contains objectionable amounts of chloride. The quality of the water limits its development for water supply. Overdrafts from the Saginaw result in a lowering of the piezometric surface and commonly cause an upward migration of water high in chloride. The Michigan and Marshall formations are generally not sources of fresh water where they are overlain by the Saginaw formation. In the southern and eastern parts of the county where they are overlain by glacial deposits, they are a source of water of good quality. The quantity of water obtainable from these formations is not fully known. However, the Marshall may be a source of large supplies of water in the southeastern part of the county. An ample supply of water is available in lakes, ponds, and streams in the metropolitan area of Flint to meet requirements for domestic, sanitary, and firefighting use in civil defense emergencies. The extent of emergency use of water from these sources would depend upon the pumping, distribution, and treatment facilities available. Enough private industrial and commercial, and public wells are present in the area normally supplied by the Flint public water system to meet emergency requirements for domestic and sanitary use. Use of these wells would also depend upon available pumping and distribution facilities. Water from many of these wells contains objectionable amounts of chloride, but it could be used without treatment in an emergency.

Michigan↗

Hydraulic and hydrologic aspects of flood-plain planning

The valid incentives compelling occupation of the flood plain, up to and even into the stream channel, undoubtedly have contributed greatly to the development of the country. But the result has been a heritage of flood disaster, suffering, and enormous costs. Flood destruction awakened a consciousness toward reduction and elimination of flood hazards, originally manifested in the protection of existing developments. More recently, increased information and realization of the problem have shown the impracticability of permitting developments that require costly flood protection. The idea of flood zoning, or flood-plain planning, has received greater impetus as a result of such realization. This study shows how hydraulic and hydrologic data concerning the flood regimen of a stream can be used in appraising its flood potential and the risk inherent in occupation of its flood plain. The approach involves the study of flood magnitudes as recorded or computed; flood frequencies based on the experience shown by many years of gaging-station record; use of existing or computed stage-discharge relations and flood profiles; and, where required, the preparation of flood-zone maps to show the areas inundated by floods of several magnitudes and frequencies. Methods are outlined that will enable the planner to delineate areas subject to inundation by floods of specific recurrence intervals for three conditions; (1) for the immediate vicinity of a gaging station, (2) for a gaged stream at a considerable distance from a gaging station, and (3) for an ungaged stream. Curves have been developed from which the average depth for a flood of specific frequency can be estimated on the basis of the average depth for bankfull flow; this simplified approach should be very useful in the initial stages of flood-plain planning. Brief discussions are included on various types of flood hazards, the effects of urbanization on flood runoff, and zoning considerations.

Pennsylvania↗