Geology topics

S.W. McCoy

Publications and source records attributed to S.W. McCoy.

5 recordsLinked to original sources

USGS2017

Hydrologic and geomorphic changes resulting from episodic glacial lake outburst floods: Rio Colonia, Patagonia, Chile

Glacial lake outburst floods (GLOFs) are a prominent but poorly understood cryospheric hazard in a warming climate. We quantify the hydrologic and geomorphic response to 21 episodic GLOFs that began in April 2008 using multitemporal satellite imagery and field observations. Peak discharge exiting the source lake became progressively muted downstream. At ~40–60 km downstream, where the floods entered and traveled down the main stem Rio Baker, peak discharges were generally < 2000 m 3 s −1 , although these flows were still >1–2 times the peak annual discharge of this system, Chile's largest river by volume. As such, caution must be applied to empirical relationships relating lake volume to peak discharge, as the latter is dependent on where this observation is made along the flood path. The GLOFs and subsequent periods of free drainage resulted in > 40 m of incision, the net removal of ~25 × 10 6 m 3 of sediment from the source lake basin, and a nonsteady channel configuration downstream. These results demonstrate that GLOFs sourced from low‐order tributaries can produce significant floods on major main stem rivers, in addition to significantly altering sediment dynamics.

Cachet‐Colonia‐Baker Valley, Patagonia, Rio Coloni↗

USGS2015

Estimating rates of debris flow entrainment from ground vibrations

Debris flows generate seismic waves as they travel downslope and can become more dangerous as they entrain sediment along their path. We present field observations that show a systematic relation between the magnitude of seismic waves and the amount of erodible sediment beneath the flow. Specifically, we observe that a debris flow traveling along a channel filled initially with sediment 0.34m thick generates about 2 orders of magnitude less spectral power than a similar-sized flow over the same channel without sediment fill.We adapt amodel fromfluvial seismology to explain this observation and then invert it to estimate the level of bed sediment (and rate of entrainment) beneath a passing series of surges. Our estimates compare favorably with previous direct measurements of entrainment rates at the site, suggesting the approach may be a new indirect way to obtain rare field constraints needed to test models of debris flow entrainment.

Colorado↗

USGS2013

Field measurement of basal forces generated by erosive debris flows

It has been proposed that debris flows cut bedrock valleys in steeplands worldwide, but field measurements needed to constrain mechanistic models of this process remain sparse due to the difficulty of instrumenting natural flows. Here we present and analyze measurements made using an automated sensor network, erosion bolts, and a 15.24 cm by 15.24 cm force plate installed in the bedrock channel floor of a steep catchment. These measurements allow us to quantify the distribution of basal forces from natural debris‒flow events that incised bedrock. Over the 4 year monitoring period, 11 debris‒flow events scoured the bedrock channel floor. No clear water flows were observed. Measurements of erosion bolts at the beginning and end of the study indicated that the bedrock channel floor was lowered by 36 to 64 mm. The basal force during these erosive debris‒flow events had a large‒magnitude (up to 21 kN, which was approximately 50 times larger than the concurrent time‒averaged mean force), high‒frequency (greater than 1 Hz) fluctuating component. We interpret these fluctuations as flow particles impacting the bed. The resulting variability in force magnitude increased linearly with the time‒averaged mean basal force. Probability density functions of basal normal forces were consistent with a generalized Pareto distribution, rather than the exponential distribution that is commonly found in experimental and simulated monodispersed granular flows and which has a lower probability of large forces. When the bed sediment thickness covering the force plate was greater than ~ 20 times the median bed sediment grain size, no significant fluctuations about the time‒averaged mean force were measured, indicating that a thin layer of sediment (~ 5 cm in the monitored cases) can effectively shield the subjacent bed from erosive impacts. Coarse‒grained granular surges and water‒rich, intersurge flow had very similar basal force distributions despite differences in appearance and bulk‒flow density. These results demonstrate that debris flows can have strong control on rates of steepland evolution and contribute to a foundation needed for modeling debris‒flow incision stochastically.

Journal of Geophysical Research F: Earth Surface↗

USGS2012

Sediment entrainment by debris flows: In situ measurements from the headwaters of a steep catchment

Debris flows can dramatically increase their volume, and hence their destructive potential, by entraining sediment. Yet quantitative constraints on rates and mechanics of sediment entrainment by debris flows are limited. Using an in situ sensor network in the headwaters of a natural catchment we measured flow and bed properties during six erosive debris-flow events. Despite similar flow properties and thicknesses of bed sediment entrained across all events, time-averaged entrainment rates were significantly faster for bed sediment that was saturated prior to flow arrival compared with rates for sediment that was dry. Bed sediment was entrained from the sediment-surface downward in a progressive fashion and occurred during passage of dense granular fronts as well as water-rich, inter-surge flow. En masse failure of bed sediment along the sediment-bedrock interface was never observed. Large-magnitude, high-frequency fluctuations in total normal basal stress were dissipated within the upper 5 cm of bed sediment. Within this near surface layer, concomitant fluctuations in Coulomb frictional resistance are expected, irrespective of the influence of pore fluid pressure or fluctuations in shear stress. If the near-surface sediment was wet as it was overridden by a flow, additional large-magnitude, high-frequency pore pressure fluctuations were measured in the near-surface bed sediment. These pore pressure fluctuations propagated to depth at subsonic rates and in a diffusive manner. The depth to which large excess pore pressures propagated was typically less than 10 cm, but scaled as ( D / f i ) 0.5 , in which D is the hydraulic diffusivity and f i is the frequency of a particular pore pressure fluctuation. Shallow penetration depths of granular-normal-stress fluctuations and excess pore pressures demonstrate that only near-surface bed sediment experiences the full dynamic range of effective-stress fluctuations, and as a result, can be more easily entrained than deeper sediment. These data provide robust tests for mechanical models of entrainment and demonstrate that a debris flow over wet bed sediment will be larger than the same flow over dry bed sediment.

Colorado↗

USGS2010

Evolution of a natural debris flow: In situ measurements of flow dynamics, video imagery, and terrestrial laser scanning

Many theoretical and laboratory studies have been undertaken to understand debris-flow processes and their associated hazards. However, complete and quantitative data sets from natural debris flows needed for confirmation of these results are limited. We used a novel combination of in situ measurements of debris-flow dynamics, video imagery, and pre- and postflow 2-cm-resolution digital terrain models to study a natural debris-flow event. Our field data constrain the initial and final reach morphology and key flow dynamics. The observed event consisted of multiple surges, each with clear variation of flow properties along the length of the surge. Steep, highly resistant, surge fronts of coarse-grained material without measurable pore-fluid pressure were pushed along by relatively fine-grained and water-rich tails that had a wide range of pore-fluid pressures (some two times greater than hydrostatic). Surges with larger nonequilibrium pore-fluid pressures had longer travel distances. A wide range of travel distances from different surges of similar size indicates that dynamic flow properties are of equal or greater importance than channel properties in determining where a particular surge will stop. Progressive vertical accretion of multiple surges generated the total thickness of mapped debris-flow deposits; nevertheless, deposits had massive, vertically unstratified sedimentological textures. ?? 2010 Geological Society of America.

Geology↗