USGS Science⌕ Search

Geology topics

Russell F. Burmester

Publications and source records attributed to Russell F. Burmester.

5 recordsLinked to original sources
USGS2012

Paleomagnetism of Middle Tertiary volcanic rocks from the Western Cascade Series, northern California

The Western Cascade Series (WCS) is a 3.5‐km‐thick, crudely homoclinal (east dipping) calcalkaline volcanic sequence of mid‐Oligocene to early Miocene age that crops out near the southern tip of the Cascade Range in northern California. The mean direction of remanent magnetization in the WCS is D, 4.9°; I, 57.6° (N, 53; k, 14.4; α 95 , 5.3°). When compared to a reference direction for the North American craton, the WCS direction indicates that the southern Cascade Range has rotated 14.0° ± 9.0° since the WCS accumulated. A difference in mean direction between the lower and upper halves of the WCS suggests that much of this rotation occurred during the late Oligocene. Six other paleomagnetic studies of rock units of an age roughly comparable to the WCS also are available from western Oregon, northwestern California, and southwestern Washington. All show statistically significant clockwise rotation (inclinations of all but one are concordant). Comparison of directions indicates that the Pacific Northwest did not rotate as a rigid body, but neither did it behave as a collection of small, independently rotating domains. The amount of rotation found throughout the area increases to the west or northwest, suggesting a driving force for rotation operating at the continental margin.

California↗
USGS2003

Geologic map of the Bonners Ferry 30' x 60' quadrangle, Idaho and Montana

This data set maps and describes the geology of the Bonners Ferry 30' x 60' quadrangle, Idaho and Montana. The bedrock geology of the Bonners Ferry quadrangle consists of sedimentary, metamorphic, and granitic rocks ranging in age from Middle Proterozoic to Eocene. Bedrock units include rocks of (1) the Middle Proterozoic Belt Supergroup (2) the Middle Proterozoic Deer Trail Group, (3) the Late Proterozoic Windermere Group, (4) miogeoclinal or shelf facies lower Paleozoic rocks, and (5) Mesozoic and Tertiary granitic rocks. The Belt Supergroup, a thick sequence of argillite, siltite, quartzite, and impure carbonate rocks up to 9,000 m thick, occurs in two non-contiguous sequences in the quadrangle: (1) the Clark Fork-Eastport Sequence east of the Purcell trench and (2) the Newport Sequence in the hanging wall of the Newport Fault. Only the two lowest Belt formations of the Newport Sequence are found in the Bonners Ferry quadrangle, but these two units are part of a continuous section, which extends southwestward to the town of Newport. Belt Supergroup rocks of the Clark Fork-Eastport Sequence are separated from those of the Newport Sequence by the Newport Fault, Priest River Complex, and Purcell Trench Fault. Some formations of the Belt Supergroup show differences in thickness and (or) lithofacies from one sequence to the other that are greater than those predicted from an empirical depositional model for the distances currently separating the sequences. These anomalous thickness and facies differences suggest that there has been a net contraction along structures separating the sequences despite Eocene extension associated with emplacement of the Priest River Complex. In addition to these two Belt sequences, probable Belt rocks are present in the Priest River Complex as high metamorphic grade crystalline schist and gneiss. Northwest of the Newport Sequence of Belt Supergroup is the Deer Trail Group, a distinct Middle Proterozoic sequence of argillite, siltite, quartzite, and carbonate rocks lithostratigraphically similar to the Belt Supergroup, but separated from all Belt Supergroup rocks by the Jumpoff Joe Fault. Rocks of the Deer Trail Group are pervasively phyllitic and noticeably more deformed than rocks in the Belt Supergroup sequences. Lithostratigraphically the Deer Trail Group is equivalent to part of the upper part of the Belt Supergroup. Differences in lithostratigraphy and thickness between individual Deer Trail and Belt units and between the Deer Trail and Belt sequences as a whole indicate that they were probably much farther apart when they were deposited. The Windermere Group is a lithologically varied sequence of volcanic rocks and coarse-grained, mostly immature, clastic sedimentary rocks up to 8,000 m thick. It is characterized by extreme differences in thickness and lithofacies over short distances caused by syndepositional faulting associated with initial stages of continental rifting in the Late Proterozoic. Strata of the Windermere Group unconformably overlie only the Deer Trail Group, and are nowhere found in depositional contact with Belt Supergroup rocks. Paleozoic rocks in the Bonners Ferry quadrangle consist of a thin, fault-bounded remnant preserved within the Clark Fork-Eastport Belt Supergroup Sequence. Mesozoic granitic rocks underlie at least 50 percent of the Bonners Ferry quadrangle. They fall into two petrogenetic suites, hornblende-biotite plutons and muscovite-biotite (two-mica) plutons, most of which are Cretaceous in age. Both suites are represented in the mid-crustal Priest River Complex and in the higher level plutons that flank the complex; by far the majority of the Priest River Complex are Cretaceous, two-mica bodies. Tertiary rocks are restricted to a single small stock, numerous hypabyssal dikes that are too small to show at the scale of the map, and to cataclastic rocks related to the Newport Fault. Quaternary deposits include unconsolidated to poorl

Miscellaneous Field Studies Map↗
USGS1999

Digital Geologic Map of the Wallace 1:100,000 Quadrangle, Idaho

The geology of the Wallace 1:100,000 quadrangle, Idaho was compiled by Reed S. Lewis in 1997 primarily from published materials including 1983 data from Foster, Harrison's unpublished mapping done from 1975 to 1985, Hietenan's 1963, 1967, 1968, and 1984 mapping, Hobbs and others 1965 mapping, and Vance's 1981 mapping, supplemented by eight weeks of field mapping by Reed S. Lewis, Russell F. Burmester, and Mark D. McFaddan in 1997 and 1998. This geologic map information was inked onto a 1:100,000-scale greenline mylar of the topographic base map for input into a geographic information system (GIS). The resulting digital geologic map GIS can be queried in many ways to produce a variety of geologic maps. Digital base map data files (topography, roads, towns, rivers and lakes, etc.) are not included: they may be obtained from a variety of commercial and government sources. This database is not meant to be used or displayed at any scale larger than 1:100,000 (e.g., 1:62,500 or 1:24,000). The map area is located in north Idaho. The primary sources of map data are shown in figure 2 and additional sources are shown in figure 3. This open-file report describes the geologic map units, the methods used to convert the geologic map data into a digital format, the Arc/Info GIS file structures and relationships, and explains how to download the digital files from the U.S. Geological Survey public access World Wide Web site on the Internet. Mapping and compilation was completed by the Idaho Geological Survey under contract with the U.S. Geological Survey (USGS) office in Spokane, Washington. The authors would like to acknowledge the help of the following field assistants: Josh Goodman, Yvonne Issak, Jeremy Johnson and Kevin Myer. Don Winston provided help with our ongoing study of Belt stratigraphy, and Tom Frost assisted with logistical problems and sample collection. Manuscript reviews by Steve Box, Tom Frost, and Brian White are greatly appreciated. We wish to thank Karen S. Bolm of the USGS for reviewing the digital files.

Open-File Report↗