Robert G. M. Spencer — Page 2

USGS2010

Measurement of dissolved organic matter fluorescense in aquatic environments: An interlaboratory comparison

The fluorescent properties of dissolved organic matter (DOM) are often studied in order to infer DOM characteristics in aquatic environments, including source, quantity, composition, and behavior. While a potentially powerful technique, a single widely implemented standard method for correcting and presenting fluorescence measurements is lacking, leading to difficulties when comparing data collected by different research groups. This paper reports on a large-scale interlaboratory comparison in which natural samples and well-characterized fluorophores were analyzed in 20 laboratories in the U.S., Europe, and Australia. Shortcomings were evident in several areas, including data quality-assurance, the accuracy of spectral correction factors used to correct EEMs, and the treatment of optically dense samples. Data corrected by participants according to individual laboratory procedures were more variable than when corrected under a standard protocol. Wavelength dependency in measurement precision and accuracy were observed within and between instruments, even in corrected data. In an effort to reduce future occurrences of similar problems, algorithms for correcting and calibrating EEMs are described in detail, and MATLAB scripts for implementing the study's protocol are provided. Combined with the recent expansion of spectral fluorescence standards, this approach will serve to increase the intercomparability of DOM fluorescence studies.

Environmental Science & Technology↗

USGS2010

Comparison of XAD with other dissolved lignin isolation techniques and a compilation of analytical improvements for the analysis of lignin in aquatic settings

This manuscript highlights numerous incremental improvements in dissolved lignin measurements over the nearly three decades since CuO oxidation of lignin phenols was first adapted for environmental samples. Intercomparison of the recovery efficiency of three common lignin phenol concentration and isolation techniques, namely XAD, C 18 with both CH 3 OH (C 18 M) and CH 3 CN (C 18 A) used independently for priming and elution steps, and tangential flow filtration (TFF) for a range of aquatic samples including fresh, estuarine and marine waters, was undertaken. With freshwater samples XAD8-1, C 18 M and TFF were all observed to recover ca. 80–90% of the lignin phenols and showed no fractionation effects with respect to diagnostic lignin parameters. With estuarine and marine samples more lignin phenols were recovered with C 18 M and XAD8-1 than TFF because of the increased prevalence of low molecular weight lignin phenols in marine influenced samples. For marine systems, differences were also observed between diagnostic lignin parameters isolated via TFF vs. C 18 M and XAD8-1 as a result of the high molecular weight lignin phenols being less degraded than the bulk. Therefore, it is recommended for future studies of marine systems that only one technique is utilized for ease of intercomparison within studies. It is suggested that for studies solely aimed at recovering bulk dissolved lignin in marine environments that C 18 M and XAD8-1 appear to be more suitable than TFF as they recover more lignin. Our results highlight that, for freshwater samples, all three common lignin phenol concentration and isolation techniques are comparable to whole water concentrated by rotary evaporation (i.e. not isolated) but, that for marine systems, the choice of concentration and isolation techniques needs to be taken into consideration with respect to both lignin concentration and diagnostic parameters. Finally, as the study highlights XAD8-1 to be a suitable method for the isolation of dissolved lignin phenols from aquatic systems (statistically indistinguishable from C 18 M, P < 0.1), lignin data representative of whole waters can be produced for IHSS reference materials or other XAD sample archives.

Organic Geochemistry↗