USGS ScienceSearch

Geology topics

R. Meister

Publications and source records attributed to R. Meister.

4 recordsLinked to original sources

Elastic moduli of rock glasses under pressure to 8 kilobars and geophysical implications

Shear and longitudinal velocities were measured by the ultrasonic phase comparison method as a function of pressure to 8 kbar on synthetic glasses of basalt, andesite, rhyolite, and quartz composition and on natural obsidian. Velocities of most of the glasses decrease anomalously with pressure, but increasingly more-normal behavior occurs with decrease in SiO 2 content. The pressure derivatives of rigidity and bulk modulus increase linearly, from −3.39 to −0.26 and from −5.91 to +2.09, respectively, with decrease in SiO 2 content from 100 to 49%. The change from negative to positive in the pressure derivatives of both moduli and observed at Poisson's ratio of about 0.25 is consistent with the Smyth model for the anomalous elastic behavior of glass. If the temperature in the upper mantle is about 1500°C, tholeiitic basalt would be molten in accordance with the partial melt explanation for the low-velocity zone; at 1300°C and below, basalt would be in the glassy state, especially if more felsic than tholeiite. At a temperature of 1370°C and at 30 kbar, reasonable values for the upper mantle at 100 km depth, the basalt glass of this study would have a viscosity of about 10 13 P. On the basis of the theory of viscoelasticity the glass would support shear wave propagation at frequencies above 0.1 Hz. Under such conditions of PT, 10 to 30% basalt glass in a matrix either of eclogite or olivine would reduce the seismic velocities by 3 to 9% and could also account for the values observed in the low-velocity zone.

Journal of Geophysical Research Solid Earth

Pressure derivatives of elastic moduli of fused quartz to 10 kb

Measurements of the longitudinal and shear moduli were made on fused quartz to 10 kb at 24·5°C. The anomalous behavior of the bulk modulus K at low pressure, &#x2202;K &#x2202;P &lt; 0 "> ∂K∂P< 0 , begins to approach the “normal” behavior of solids, &#x2202;K &#x2202;P &gt; 0 "> ∂K∂P> 0 , at higher pressures. The pressure derivative of the rigidity modulus &#x2202;G &#x2202;P "> ∂G∂P remains constant and negative for the pressure range covered. A 15-kb hydrostatic pressure vessel is described for use with ultrasonic pulse instrumentation for precise measurements of elastic moduli and density changes with pressure. The placing of the transducer outside the pressure medium, and the use of C -ring pressure seals result in ease of operation and simplicity of design.

Journal of Physics and Chemistry of Solids

Variational method of determining effective moduli of polycrystals with tetragonal symmetry

Variational principles have been applied to aggregates of randomly oriented pure‐phase polycrystals having tetragonal symmetry. The bounds of the effective elastic moduli obtained in this way show a substantial improvement over the bounds obtained by means of the Voigt and Reuss assumptions. The Hill average is found to be a good approximation in most cases when compared to the bounds found from the variational method. The new bounds reduce in their limits to the Voigt and Reuss values.

Journal of Applied Physics

Variational method of determining effective moduli of polycrystals: (A) hexagonal symmetry, (B) trigonal symmetry

Variational principles of anisotropic elasticity have been applied to aggregates of randomly oriented pure‐phase polycrystals having hexagonal symmetry and trigonal symmetry. The bounds of the effective elastic moduli obtained in this way show a considerable improvement over the bounds obtained by means of the Voigt and Reuss assumptions. The Hill average is found to be in most cases a good approximation when compared to the bounds found from the variational method. The new bounds reduce in their limits to the Voigt and Reuss values.

Journal of Applied Physics