Geology topics

P. Hensel

Publications and source records attributed to P. Hensel.

4 recordsLinked to original sources

USGS2024

Incorporating measurements of vertical land motion in wetland surface elevation change analyses

We compared elevation trajectories from 14 rod surface elevation table (RSET) stations and 60 real-time kinematic (RTK) global positioning system (GPS) transects within the Blackwater National Wildlife Refuge (BNWR) from 2010–2013. The results were similar, 7.3 ± 0.9 (mean ± standard error; RSET) versus 6.2 ± 0.6 mm year −1 (RTK) ( P = 0.216), and were greater than relative sea level rise (RSLR) computed at the nearest long-term tide station (3.9 ± 0.29 mm year −1 ). Despite having shown elevation gain, these wetlands continue to drown and convert to open water. Episodic, multi-day GPS measurements on geodetic control marks at BNWR between 2005 and 2023 revealed a substantial vertical land motion (VLM) signal. From 2005 to 2015, three reference marks used to control the 2010–2013 RTK study lost on average 6.0 ± 0.7 mm year −1 , corresponding to 80% and 94% of the elevation gain measured by the RSET and RTK techniques, respectively. The longer 18-year subsidence trend measured on one of these marks was lower, 3.9 ± 0.7 mm year −1 , highlighting important interannual variability. Wetland elevation change measurements need to account for VLM occurring below the reference marks used to measure elevation change. Estimates from the nearest long-term tide station may not be applicable to the wetland if the tide station is in a different geological setting. At BNWR, VLM was higher than the VLM at the Cambridge tide station, which helps explain why wetlands at BNWR are not keeping pace with RSLR despite the measured high rates of elevation gain.

Maryland↗

USGS2003

Mass tree mortality leads to mangrove peat collapse at Bay Islands, Honduras after Hurricane Mitch

We measured sediment elevation and accretion dynamics in mangrove forests on the islands of Guanaja and Roatan, Honduras, impacted by Hurricane Mitch in 1998 to determine if collapse of underlying peat was occurring as a result of mass tree mortality. Little is known about the balance between production and decomposition of soil organic matter in the maintenance of sediment elevation of mangrove forests with biogenic soils. Sediment elevation change measured with the rod surface elevation table from 18 months to 33 months after the storm differed significantly among low, medium and high wind impact sites. Mangrove forests suffering minimal to partial mortality gained elevation at a rate (5 mm yeara??1) greater than vertical accretion (2 mm yeara??1) measured from artificial soil marker horizons, suggesting that root production contributed to sediment elevation. Basin forests that suffered mass tree mortality experienced peat collapse of about 11 mm yeara??1 as a result of decomposition of dead root material and sediment compaction. Low soil shear strength and lack of root growth accompanied elevation decreases. Model simulations using the Relative Elevation Model indicate that peat collapse in the high impact basin mangrove forest would be 37 mm yeara??1 for the 2 years immediately after the storm, as root material decomposed. In the absence of renewed root growth, the model predicts that peat collapse will continue for at least 8 more years at a rate (7 mm yeara??1) similar to that measured (11 mm yeara??1). Mass tree mortality caused rapid elevation loss. Few trees survived and recovery of the high impact forest will thus depend primarily on seedling recruitment. Because seedling establishment is controlled in large part by sediment elevation in relation to tide height, continued peat collapse could further impair recovery rates.

Journal of Ecology↗

USGS2002

High-precision measurements of wetland sediment elevation. I. Recent improvements to the sedimentation--erosion table

The sedimentation-erosion table (SET) developed by Boumans and Day (1993) is herein renamed the surface elevation table (SET) to better reflect the conceptual view of the processes being measured. The SET was designed for making high-resolution measurements of small-scale changes in elevation of loose, unconsolidated sediments in shallow water and mudflat habitats. The SET has undergone three major improvements to increase precision and so that it can be used to measure sediment elevation in vegetated wetlands as well as shallow water habitats. The remote-release 'sliding plate' mechanism has been replaced with a single plate, collars (first 2.5 cm then 7.5 cm in length) have been attached to the plate to reduce play in the placement of the measuring pins, and the brass measuring pins have been replaced with fiberglass pins to reduce bending and consequent loss of precision. Under ideal laboratory conditions, the 95% confidence limit for individual pin measurements averaged about A? 1.4 mm (range A? 0.7 to A? 1.9 mm). These modifications have resulted in a reduction of error by about 50%.

Journal of Sedimentary Research↗

USGS2002

High-precision measurements of wetland sediment elevation. II The rod surface elevation table

A new high-precision device for measuring sediment elevation in emergent and shallow water wetland systems is described. The rod surface-elevation table (RSET) is a balanced, lightweight mechanical leveling device that attaches to both shallow (< 1 m) and deep (driven to refusal) rod bench marks. The RSET was built to complement the surface-elevation table (SET), a larger and heavier mechanical leveling device first described by Boumans and Day (1993). Because of its size and weight, the SET must be attached to a pipe bench mark, which typically must be driven to a depth > 1 m in order to be stable. The pipe is driven to refusal but typically to a depth shallower than the rod bench mark because of greater surface resistance of the pipe. Thus, the RSET makes it possible to partition change in sediment elevation over shallower (e.g., the root zone) and deeper depths of the sediment profile than is possible with the SET. The confidence intervals for the height of an individual pin measured by two different operators with the RSET under laboratory conditions were A? 1.0 and A? 1.5 mm. Under field conditions, confidence intervals for the measured height of an individual pin ranged from A? 1.3 mm in a mangrove forest up to A? 4.3 mm in a salt marsh.

Journal of Sedimentary Research↗