EXPLORE THE ARCHIVE

Nicholas M. Beeler

Publications and source records attributed to Nicholas M. Beeler.

4 recordsLinked to original sources

USGS2025

Rapid fault healing from cementation controls the dynamics of deep slow slip and tremor

Despite its status as one of the most important discoveries in geophysics, the physical mechanism(s) responsible for slow slip events (SSEs) are not well understood. Here, we synthesize observations of deep SSEs in the Cascadia Subduction Zone and argue that rapid, cohesive fault strengthening may control the dynamics of deep SSEs. Cohesive strength is frequently ignored in constitutive laws used to describe fault rheology in numerical simulations of earthquakes and SSEs alike. To demonstrate its importance, we perform and analyze a suite of petrological experiments that simulate fault healing under representative pressure and temperature conditions. We show that significant cohesive strength recovery caused by dissolution-precipitation processes occurs on timescales of just a few hours. Together, our experimental and observational results support the idea that cohesion is a key component of fault strength under SSE conditions and highlight the need for its inclusion in both future experiments and numerical models of fault slip.

British Columbia, Washington↗

USGS2025

To heal or not to heal?: 1. The effect of pore fluid pressure on the frictional healing behavior of lithologies in Oklahoma

The competition between fault healing (i.e., re-strengthening) and fault loading determines the timing and magnitude of fault failure within the seismic cycle. Repeating earthquakes can give observational estimates of fault healing rates, however, it is difficult to link laboratory studies of frictional healing and observed healing rates from repeating earthquakes in part because of uncertainty in lithology at depth. Due to well-constrained and relatively simple geology, earthquakes in Oklahoma can be linked to the granitic basement rock and to the Arbuckle Group, which is primarily composed of dolomite at earthquake depths. Here, we conduct friction experiments to measure healing rates of the two earthquake-bearing lithologies at confining pressures representative of earthquake depths and pore pressures ranging from 0% to 80% of the confining pressure. We measure frictional healing by executing slide-hold-slide tests with hold times ranging from 3 s to 3000 s. The friction experiments on the Troy Granite indicate that pore fluid pressure does not greatly affect healing rate. On the other hand, the dolomite of the Arbuckle Group exhibits decreased healing with increased pore fluid pressure, with weakening at the highest pore pressure. We hypothesize that this is due to an increase in dissolution of dolomite at high pore pressures/low effective normal stress. These healing rates are used in the companion paper to understand the moment-recurrence time behavior of repeating earthquakes in Prague, Oklahoma. This work has implications for possible enhanced dissolution and weakening behavior of the Arbuckle Group during wastewater injection activities.

Oklahoma↗

USGS2025

Earthquake stress drop, source spectra from laboratory experiments, and the apparent unsteadiness of frictional slip

Over a range of co-seismic total energy release, high sample rate slip, stress, and slip velocity measurements were made during frictional failure to determine seismic source properties. The near-field measurements were used to estimate stress drops using spectral approaches that are analogous to the standard seismological moment-corner determined Δσ and acceleration amplitude Δσ arms stress drops. Rapid frictional sliding produces slip velocity amplitude spectra that vary with frequency -1 so long as the energy dissipated by friction approaches the total energy release. Under these conditions Δσ and Δσ arms are similar in size. Since these are nearly direct measurements of fault slip velocity and because they produce flat acceleration spectra between the corner and an apparent fmax, friction in these experiments seems to produce dynamic acceleration and deceleration at all resolved frequencies. The physical origin of this unsteady motion is not known exactly but likely reflects rapid dynamic variations in fault strength or applied stress. On the other hand, when the total energy stored prior to failure is artificially made somewhat larger relative to that which can be dissipated by friction the velocity spectra vary with frequency -2 immediately below the corner. At these conditions Δσ and Δσ arms diverge. The excess stored energy is preferentially partitioned into radiated energy upon failure. Collectively the experiments imply that to produce unsteady, white noise accelerations that are observed for natural earthquakes, requires that at least 95% of the energy released does not escape the source region to be radiated to the far-field.

Bulletin of the Seismological Society of America↗

USGS2025

Probing lower-crustal fault properties with frequency-dependent tidal tremor triggering

The way seismicity responds to periodic stress perturbations offers crucial insights into the processes that can trigger an earthquake. Laboratory and theoretical analyses have shown that the period of imposed forcing and source properties affect the sensitivity to triggering, but frequency-dependent triggering of tectonic faults is poorly understood. The rate of low-frequency earthquakes (LFEs) near Parkfield, California has been found to be strongly correlated with solid earth tides. Tidal forcing acts over multiple frequencies, and the sensitivity to tidal triggering of LFEs therefore provides a unique opportunity to probe the physics of earthquake triggering and underlying fault properties. Here, we find that the response of LFEs to solid earth tides at diurnal and semi-diurnal frequencies is highly variable but spatially coherent along the San Andreas Fault. Using rate-state friction modeling, we find that the variation of the amplitude of tidal modulation is mainly affected by the spatial variation of the background effective normal stress, whereas the spatially varied tidal modulation at diurnal and semi-diurnal frequencies is mainly affected by the fault frictional property. The spatial variations of the LFE response reveal a heterogeneous lower-crustal geologic structure and complex physical faulting processes below the rupture zone of eventual great earthquakes.

California↗