USGS Science⌕ Search

Geology topics

M. Logan

Publications and source records attributed to M. Logan.

3 recordsLinked to original sources
USGS2020

Reconstructing the velocity and deformation of a rapid landslide using multiview video

Noncontact measurements of spatially varied ground surface deformation during landslide motion can provide important constraints on landslide mechanics. Here, we present and test a new method for extracting measurements of rapid landslide surface displacement and velocity (accelerations of approximately 1 m/s 2 ) using sequences of stereo images obtained from a pair of inexpensive, stationary 4K video cameras with nominal frame rates of 29.97 Hz. The method combines elements of Structure from Motion with those of optical flow to extract data on 3‐D evolution of the ground surface during slope failure. We apply the method to an experiment at the U.S. Geological Survey debris‐flow flume in which a high‐speed, liquefying landslide was triggered by gradually adding water to a 6‐m 3 prism of loosely packed sediment on a 31° slope. Strip‐scanning lidar measurements made during the experiment corroborate our video‐based measurements, but the latter encompassed the entire landslide surface and were much lower in cost. Our video‐based measurements enabled computation of depth‐integrated landslide dilation/contraction rates. The range of computed rates was within the ranges inferred from independent measurements of evolving pore water pressures and reasonable estimates of the hydraulic permeability of the sediment. Dilation and contraction rates play a crucial role in landslide mechanics. The dilation and contraction we observe contradict the incompressible flow assumption used in many studies that have employed noncontact methods to infer landslide properties.

Oregon↗
USGS2012

Grain-size segregation and levee formation in geophysical mass flows

Data from large-scale debris-flow experiments are combined with modeling of particle-size segregation to explain the formation of lateral levees enriched in coarse grains. The experimental flows consisted of 10 m 3 of water-saturated sand and gravel, which traveled ∼80 m down a steeply inclined flume before forming an elongated leveed deposit 10 m long on a nearly horizontal runout surface. We measured the surface velocity field and observed the sequence of deposition by seeding tracers onto the flow surface and tracking them in video footage. Levees formed by progressive downslope accretion approximately 3.5 m behind the flow front, which advanced steadily at ∼2 m s −1 during most of the runout. Segregation was measured by placing ∼600 coarse tracer pebbles on the bed, which, when entrained into the flow, segregated upwards at ∼6–7.5 cm s −1 . When excavated from the deposit these were distributed in a horseshoe-shaped pattern that became increasingly elevated closer to the deposit termination. Although there was clear evidence for inverse grading during the flow, transect sampling revealed that the resulting leveed deposit was strongly graded laterally, with only weak vertical grading. We construct an empirical, three-dimensional velocity field resembling the experimental observations, and use this with a particle-size segregation model to predict the segregation and transport of material through the flow. We infer that coarse material segregates to the flow surface and is transported to the flow front by shear. Within the flow head, coarse material is overridden, then recirculates in spiral trajectories due to size-segregation, before being advected to the flow edges and deposited to form coarse-particle-enriched levees.

Journal of Geophysical Research↗