USGS ScienceSearch

Geology topics

L. Ramirez-Guzman

Publications and source records attributed to L. Ramirez-Guzman.

3 recordsLinked to original sources

Ground motion-simulations of 1811-1812 New Madrid earthquakes, central United States

We performed a suite of numerical simulations based on the 1811–1812 New Madrid seismic zone (NMSZ) earthquakes, which demonstrate the importance of 3D geologic structure and rupture directivity on the ground‐motion response throughout a broad region of the central United States (CUS) for these events. Our simulation set consists of 20 hypothetical earthquakes located along two faults associated with the current seismicity trends in the NMSZ. The hypothetical scenarios range in magnitude from M 7.0 to 7.7 and consider various epicenters, slip distributions, and rupture characterization approaches. The low‐frequency component of our simulations was computed deterministically up to a frequency of 1 Hz using a regional 3D seismic velocity model and was combined with higher‐frequency motions calculated for a 1D medium to generate broadband synthetics (0–40 Hz in some cases). For strike‐slip earthquakes located on the southwest–northeast‐striking NMSZ axial arm of seismicity, our simulations show 2–10 s period energy channeling along the trend of the Reelfoot rift and focusing strong shaking northeast toward Paducah, Kentucky, and Evansville, Indiana, and southwest toward Little Rock, Arkansas. These waveguide effects are further accentuated by rupture directivity such that an event with a western epicenter creates strong amplification toward the northeast, whereas an eastern epicenter creates strong amplification toward the southwest. These effects are not as prevalent for simulations on the reverse‐mechanism Reelfoot fault, and large peak ground velocities (>40  cm/s) are typically confined to the near‐source region along the up‐dip projection of the fault. Nonetheless, these basin response and rupture directivity effects have a significant impact on the pattern and level of the estimated intensities, which leads to additional uncertainty not previously considered in magnitude estimates of the 1811–1812 sequence based only on historical reports. The region covered by our simulation domain encompasses a large portion of the CUS centered on the NMSZ, including several major metropolitan areas. Based on our simulations, more than eight million people living and working near the NMSZ would experience potentially damaging ground motion and modified Mercalli intensities ranging from VI to VIII if a repeat of the 1811–1812 earthquakes occurred today. Moreover, the duration of strong ground shaking in the greater Memphis metropolitan area could last from 30 to more than 60 s, depending on the magnitude and epicenter.

Arkansas, Illinois, Kentucky, Missouri, Tennessee

Relation of landslides triggered by the Kiholo Bay earthquake to modeled ground motion

The 2006 Kiholo Bay, Hawaii, earthquake triggered high concentrations of rock falls and slides in the steep canyons of the Kohala Mountains along the north coast of Hawaii. Within these mountains and canyons a complex distribution of landslides was triggered by the earthquake shaking. In parts of the area, landslides were preferentially located on east‐facing slopes, whereas in other parts of the canyons no systematic pattern prevailed with respect to slope aspect or vertical position on the slopes. The geology within the canyons is homogeneous, so we hypothesize that the variable landslide distribution is the result of localized variation in ground shaking; therefore, we used a state‐of‐the‐art, high‐resolution ground‐motion simulation model to see if it could reproduce the landslide‐distribution patterns. We used a 3D finite‐element analysis to model earthquake shaking using a 10 m digital elevation model and slip on a finite‐fault model constructed from teleseismic records of the mainshock. Ground velocity time histories were calculated up to a frequency of 5 Hz. Dynamic shear strain also was calculated and compared with the landslide distribution. Results were mixed for the velocity simulations, with some areas showing correlation of landslide locations with peak modeled ground motions but many other areas showing no such correlation. Results were much improved for the comparison with dynamic shear strain. This suggests that (1) rock falls and slides are possibly triggered by higher frequency ground motions (velocities) than those in our simulations, (2) the ground‐motion velocity model needs more refinement, or (3) dynamic shear strain may be a more fundamental measurement of the decoupling process of slope materials during seismic shaking.

Hawai'i

Short baseline variations in site response and wave-propagation effects and their structural causes: Four examples in and around the santa clara valley, California

Ground motion records of local and regional events from a portable array are used to investigate the structural causes of variations in ground motion over distances of a few hundred meters to a few kilometers in the sedimentary basin environment of the Santa Clara Valley, California, and its margins. Arrays of portable seismic stations are used to target four study areas with different ground motion patterns: (1) an edge of the alluvial basin extending up onto a marginal ridge (Blossom Hill), (2) a Cenozoic basin with a nearly flat bottom (Cupertino Basin), (3) a long, narrow Cenozoic basin with a steep V profile (Evergreen Basin), and (4) a line perpendicular to the trace of the Hayward fault. Average peak velocities on Blossom Hill from local earthquakes are a factor of 2.5 times higher than nearby valley sites. Three-dimensional (3D) modeling is used to conclude that the majority of the amplification is due to lower shear-wave velocities along a local fault zone (Shannon–Berrocal). Site amplification over the Cupertino Basin in the frequency band 0.5–4 Hz is generally low (less than 2.0 relative to a Mesozoic rock site) and spatially uniform. This response is attributed to the shallow, flat-bottomed shape of the basin and the uniform, flat-laying sedimentary fill. In contrast, site amplification in the Evergreen Basin generally exceeds 3.0 and is attributed to the deep, V-shaped geometry of the basin and younger sedimentary fill. 3D waveform modeling shows the elongated shape of the Evergreen Basin causes more efficient trapping of long-period waves for sources along the long axis of the basin. A low-velocity zone is postulated along the Hayward fault with a width between 100 and 200 m, based on elevated site response along the fault trace and 4.5-Hz fault zone guided waves on the horizontal components of stations near the fault.

California