Julie A. LeFever | USGS Science

USGS2015

Unconventional energy resources: 2015 review. Shale gas and liquids

Introduction As the source rocks from which petroleum is generated, organic-rich shales have always been considered an important component of petroleum systems. Over the last few years, it has been realized that in some mudrocks, sufficient hydrocarbons remain in place to allow for commercial development, although advanced drilling and completion technology is typically required to access hydrocarbons from these reservoirs. Tight oil reservoirs (also referred to as continuous oil accumulations) contain hydrocarbons migrated from source rocks that are geologically/stratigraphically interbedded with or occur immediately overlying/underlying them. Migration is minimal in charging these tight oil accumulations (Gaswirth and Marra 2014 ). Companies around the world are now successfully exploiting organic-rich shales and tight rocks for contained hydrocarbons, and the search for these types of unconventional petroleum reservoirs is growing. Unconventional reservoirs range in geologic age from Ordovician to Tertiary (Silverman et al. 2005 ; EIA 2013a ).

Natural Resources Research↗

USGS2001

Diagenesis and fracture development in the Bakken Formation, Williston Basin: Implications for reservoir quality in the middle member

The middle member of the Bakken Formation is an attractive petroleum exploration target in the deeper part of the Williston Basin because it is favorably positioned with respect to source and seal units. Progressive rates of burial and minor uplift and erosion of this member led to a stable thermal regime and, consequently, minor variations in diagenesis across much of the basin. The simple diagenetic history recorded in sandstones and siltstones in the middle member can, in part, be attributed to the closed, low-permeability nature of the Bakken petroleum system during most of its burial history. Most diagenesis ceased in the middle member when oil entered the sandstones and siltstones in the Late Cretaceous. Most oil in the Bakken Formation resides in open, horizontal fractures in the middle member. Core analysis reveals that sandstones and siltstones associated with thick mature shales typically have a greater density of fractures than sandstones and siltstones associated with thin mature shales. Fractures were caused by superlithostatic pressures that formed in response to increased fluid volumes in the source rocks during hydrocarbon generation

North Dakota↗