Geology topics
Publications and source records attributed to Jon W. Raese.
The U.S. Geological Survey National Water Quality Laboratory annual report is designed to recap the important changes, contributions, and successes of the Laboratory over the past 2 fiscal years. The intent is to provide customers with a concise overview of what the Laboratory has accomplished, how it has performed, and how the assests entrusted to NWQL have been used to further the mission of the U.S. Geological Survey.
The U.S. Geological Survey (USGS) National Water Quality Laboratory (NWQL) is a full-service laboratory that specializes in environmental analytical chemistry. The NWQL's primary mission is to support USGS programs requiring environmental analyses that provide consistent methodology for national assessment and trends analysis. The NWQL provides the following: high-quality chemical data; consistent, published, state-of-the-art methodology; extremely low-detection levels; high-volume capability; biological unit for identifying benthic invertebrates; quality assurance for determining long-term water-quality trends; and a professional staff.
This Fact Sheet presents data for analysis of nanogram-per-liter concentrations of methyl tert-butyl ether (MTBE) and three other ether gasoline oxygenates, including methyl tert-pentyl ether (TAME), diisopropyl ether (DIPE), and ethyl tert-butyl ether (ETBE), by purge- and-trap capillary-column gas chromatography. Long-term method detection levels (LT-MDLs) for MTBE, TAME, DIPE, and ETBE ranged from 15 to 83 nanograms per liter (0.015 to 0.083 microgram per liter). Nanogram-per-liter-concentration detections are reported if all of the identification criteria are met, whereas previous methods censored detections at a pre-determined method reporting level. The reporting level for this method is defined as two times the LT-MDL, does not censor detections at less than this concentration, and is referred to as the nondetection value (NDV). Bias and variability data from multiple analyses, analysts, and instruments over a 60-day period show the oxygenate recoveries ranging from 100 to 109 percent, with 6 to 8 percent relative standard deviation. MTBE, TAME, DIPE, and ETBE were not detected in the analysis of 225 laboratory reagent blanks from January to December 1997. A preservation study in ground water and surface water indicates that all the oxygenates are stable at pH 2 for up to 216 days, with recoveries ranging from 94 to 115 percent on day 216, and relative standard deviations ranging from 5 to 9 percent for the duration of the study.
Methyl tert-butyl ether (MTBE) was found in shallow ground-water samples in a study of 8 urban and 20 agricultural areas throughout the United States in 1993 and 1994 (Squillace and others, 1995, p. 1). The compound is added to gasoline either seasonally or year round in many parts of the United States to increase the octane level and to reduce carbon monoxide and ozone levels in the air. The U.S. Geological Survey (USGS) National Water Quality Laboratory (NWQL), near Denver, uses state-of-the-art technology to analyze samples for MTBE as part of the USGS water-quality studies. In addition, the NWQL offers custom analyses to determine two other fuel oxygenates--ethyl tert-butyl ether (ETBE) and tert-amyl methyl ether (TAME). The NWQL was not able to obtain a reference standard for tert-amyl ethyl ether (TAEE), another possible fuel oxygenate (Shelley and Fouhy, 1994, p. 63). The shallow ground-water samples were collected as part of the USGS National Water-Quality Assessment Program. These samples were collected from 211 urban wells or springs and 562 agricultural wells sampled by the USGS in 1993 and 1994. The wells were keyed to specific land-use areas to assess the effects of different uses on ground-water quality (Squillace and others, 1995, p. 2). Ground-water samples were preserved on site to pH less than or equal to 2 with a solution of 1:1 hydrochloric acid. All samples were analyzed at the NWQL within 2 weeks after collection. The purpose of this fact sheet is to explain briefly the analytical method implemented by the USGS for determining MTBE and other fuel oxygenates. The scope is necessarily limited to an overview of the analytical method (instrumentation, sample preparation, calibration and quantitation, identification, and preservation of samples) and method performance (reagent blanks, accuracy, and precision).
All inorganic and organic methods for analyzing samples of water and fluvial sediment, which have been approved for use by the U.S. Geological Survey from 1954 to the present (1994), are listed. Descriptive method names include references to published reports for easy retrieval of methodology. The year each method was approved is listed as well as the year the method was discontinued. Inorganic and organic methods are listed separately by sample type (dissolved, whole water, bottom material, suspended sediment, or fish tissue) and by mode of analysis (manual or automated, or both).
The National Water Quality Laboratory determines organic and inorganic constituents in samples of surface and ground water, river and lake sediment, aquatic plant and animal material, and precipitation collected throughout the United States and its territories by the U.S. Geological Survey. In water year 1994, the Laboratory produced more than 900,000 analytical results for about 65,000 samples. The Laboratory also coordinates an extensive network of contract laboratories for the determination of radiochemical and stable isotopes and work for the U.S. Department of Defense Environmental Contamination Hydrology Program. Heightened concerns about water quality and about the possible effects of toxic chemicals at trace and ultratrace levels have contributed to an increased demand for impartial, objective, and independent data.