Confocal laser-scanning microscopy (CLSM)-based thermal maturity of Tasmanites and progress in standardization of fluorescence microspectrometry
Evaluation of thermal maturity in vitrinite-free or vitrinite-deficient sediments via fluorescence microspectrometry can provide relevant information related to petroleum exploration and thermal history assessment. However, variation in spectral fluorescence properties of alginite macerals with increasing thermal maturity is largely underexplored. Here, authors of this study have applied confocal laser-scanning microscopy (CLSM) in conjunction with fluorescence microspectrometry to a maturity series of marine Upper Devonian Tasmanites algae from the Ohio Shale (Huron Member) and a single sample from the Marcellus Formation of the Appalachian Basin. Spectral fluorescence properties of Tasmanites were evaluated in relation to orientation, measurement location, and the number of measurements per sample, and were compared to published literature. Emission spectra of Tasmanites from continuous wave laser excitation (405 nm) were acquired from sections perpendicular and parallel to bedding and at different positions within individual Tasmanites bodies. The results showed a progressive red-shift in emission maxima (λ max ) in a large sample sized maturity series ( N = 19), e.g., 493 to 578 nm for the perpendicular section at middle position. Further, blue-shifted apex and mineral-adjacent positions within sections perpendicular to bedding were observed, with the latter being reported here for the first time. While blue-shift at apex positions can be attributed to mechanical deformation-induced reorientation of photoselected fluorophores, the blue-shifted mineral-adjacent positions could result from strain loading and development of a plastic deformation region at the mineral contact zone with Tasmanites . A decrease in standard deviation with increasing number of measured emission maxima is well-observed, and 15 to 20 individual measurements per sample appears sufficient for low standard deviation and coefficient of variance. CLSM-derived thermal maturity parameters indicated that a moderate positive correlation of red/green quotient (Q 650/500 ; R 2 = 0.67) with solid bitumen reflectance (BR o in %) exists. For reproducible results, the determination of λ max and Q 650/500 should be conducted exclusively in the middle position at perpendicular and parallel sections of the polished whole-rock pellets, where the lowest standard deviation in measurement was observed. These results strengthen the suitability and relevance of the CLSM technique in thermal maturity studies of dispersed organic matter (DOM) and contribute to the standardization of fluorescence microspectrometry methods in organic petrology investigation.