USGS Science⌕ Search

Geology topics

John R. Gray

Publications and source records attributed to John R. Gray.

At least 37 records · Page 2Linked to original sources
USGS2007

Measuring bed load discharge in rivers: Bedload-surrogate monitoring workshop Minneapolis, Minnesota, 11-14 April 2007

The International Bedload-Surrogate Monitoring Workshop (http://www.nced.umn.edu/BRIC_2007.html), organized by the Bedload Research International Cooperative (BRIC; www.bedloadresearch.org), was held to assess and abet progress in continuous, semiautomated, or fully automated (surrogate) technologies for monitoring bed load discharge in gravel-, sand-, and mixed gravel-sand-bedded rivers. Direct bed load measurements, particularly at medium and high flows, during which most bed load occurs, tend to be time-consuming, expensive, and potentially hazardous. Surrogate technologies developed largely over the past decade and used at a number of research sites around the world show considerable promise toward providing relatively dense, robust, and quantifiably reliable bed load data sets. However, information on the efficacy of selected technologies for use in monitoring programs is needed, as is identification of the ways and means for bringing the most promising and practical of the technologies to fruition.

Eos, Transactions, American Geophysical Union↗
USGS2007

Suspended-sediment transport measurement

Of the two operationally defined phases of fluvial-sediment transport – suspended load and bedload – collection of suspended-load data is the more common. This is a reflection of a number of factors including the general predominance of suspended load over bedload in mass transport and the greater difficulty and costs associated with collecting bedload data. Acquisition of suspended-sediment data for sediment-transport computations requires collection of water-sediment samples that represent, or can be reliably adjusted to represent, the mean discharge-weighted concentration and particle-size distribution in a cross section at the time of sample collection. Analytical results from a sufficient number of representative samples obtained with concurrent water-discharge values are needed to compute suspended-sediment discharge for the period of interest.

Book chapter↗
USGS2005

Proceedings of the Federal Interagency Sediment Monitoring Instrument and Analysis Research Workshop, September 9-11, 2003, Flagstaff, Arizona

The Advisory Committee on Water Information's Subcommittee on Sedimentation sponsored the Federal Interagency Sediment Monitoring Instrument and Analysis Research Workshop on September 9-11, 2003, at the U.S. Geological Survey Flagstaff Field Center, Arizona. The workshop brought together a diverse group representing most Federal agencies whose mission includes fluvial-sediment issues; academia; the private sector; and others with interests and expertise in fluvial-sediment monitoring ? suspended sediment, bedload, bed material, and bed topography ? and associated data-analysis techniques. The workshop emphasized technological and theoretical advances related to measurements of suspended sediment, bedload, bed material and bed topography, and data analyses. This workshop followed and expanded upon part of the 2002 Federal Interagency Workshop on Turbidity and Other Sediment Surrogates (http://water.usgs.gov/pubs/circ/2003/circ1250/), which initiated a process to provide national standards for measurement and use of turbidity and other sediment-surrogate data. This report provides a description of the salient attributes of the workshop and related information, major deliberations and findings, and principal recommendations. This information is available for evaluation by the Subcommittee on Sedimentation, which may opt to develop an action plan based on the recommendations that it endorses for consideration by the Advisory Committee on Water Information.

Circular↗
USGS2005

Introduction to suspended-sediment sampling

Knowledge of the amount and timing of sediment transport in streams is important to those directly or indirectly responsible for developing and managing water and land resources. Such data are often used to judge the health of watershed and the success or failure of activities designed to mitigate adverse impacts of sediment on streams and stream habitats. This training class presents an introduction to methods currently used by the U.S. Geological Survey (USGS) to sample suspended-sediment concentrations in streams. The presentation is narrated, but you control the pace of the presentation. If the computer you are using can view 'MPEG' videos you will be able to take advantage of videos interspersed in the presentation. A test, found at the end of the presentation, can be taken to assess how well you understood the training material. The class, which is registered as class SW4416 with the National Training Center of the USGS, should take two or three hours to complete. In order to use the presentation provided via this Web page, you will need to download a large disc images (linked below) and 'burn' it to a blank CD-ROM using a CD-ROM recorder on your computer. The presentation will only run on a Windows-based personal computer (PC). The presentation was developed using Macromedia Director MX 20041 and is contained in the file 'SIR05-5077.exe' which should autolaunch. If it does not, the presentation can be started by double-clicking on the file name. A sound card and speakers are necessary to take advantage of narrations that accompany the presentation. Text of narrations is provided, if you are unable to listen to narrations. Instructions for installing and running the presentation are included in the file 'Tutorial.htm', which is on the CD. 1 Registered Trademark: Macromedia Incorporated

Scientific Investigations Report↗
USGS2004

The LISST-SL streamlined isokinetic suspended-sediment profiler

The new manually deployed Laser In Situ Scattering Transmissometer-StreamLined profiler (LISST-SL) represents a major technological advance for suspended-sediment measurements in rivers. The LISST-SL is being designed to provide real-time data on sediment concentrations and particle-size distributions. A pressure sensor and current meter provide real-time depth and ambient velocity data, respectively. The velocity data are also used to control pumpage across an internal laser so that the intake velocity is constantly adjusted to match the ambient stream velocity. Such isokinetic withdrawal is necessary for obtaining representative sedimentary measurements in streamflow, and ensures compliance with established practices. The velocity and sediment-concentration data are used to compute fluxes for up to 32 particle-size classes at points, verticals, or in the entire stream cross section. All data are stored internally, as well as transmitted via a 2-wire conductor to the operator using a specially developed communication protocol. The LISST-SL's performance will be measured and compared to published sedimentological accuracy criteria, and a performance summary will be placed on-line.

Conference Paper↗
USGS2003

U.S. Geological Survey research on surrogate measurements for suspended sediment

The U.S. Geological Survey is evaluating potentially useful surrogate instruments and methods for inferring the physical characteristics of suspended sediments. Instruments operating on bulk acoustic, bulk and digital optic, laser, and pressure-differential technologies are being tested in riverine and laboratory settings for their usefulness to Federal agencies toward providing quantifiably reliable information on bed-material and bed-topography characteristics, and on concentrations, size distributions and transport rates of sediments in suspension and as bedload. The efficacy of four suspended-sediment surrogate technologies has been demonstrated to varying degrees of success in Kansas, Florida, Arizona, and Puerto Rico.

Arizona;Florida;Kansas↗