Jenni Junger | USGS Science

USGS2019

2D micromodel study of clogging behavior of fine-grained particles associated with gas hydrate production in NGHP-02 gas hydrate reservoir sediments

Fine-grained particles (fines) commonly coexist with coarse-grained sediments that host gas hydrate. These fines can be mobilized by liquid and gas flow during gas hydrate production. Once mobilized, fines can clog pore throats and reduce reservoir permeability. Even where particle sizes are smaller than pore-throat sizes, clogs can form due to clusters of fines. For certain types of fines, particularly swelling clays, cluster sizes depend on pore-fluid chemistry, which changes as pore-fluid freshens during gas hydrate dissociation. Fines can also be concentrated by a moving gas/liquid interface, increasing the chances of pore-throat clogging regardless of fines type. To test the relative significance of these clogging mechanisms, 2D micromodel experiments have been conducted with different pore-throat widths (20, 40, 60 and 100 m), single-phase pore-fluids (deionized water and 2M-sodium-chloride solution), and moving gas/liquid interfaces on specimens from Sites NGHP-02-09 and NGHP-02-16 (NGHP-02: National Gas Hydrate Program Expedition 02) as well as a selection of pure fines (silica silt, mica, calcium carbonate, diatoms, kaolin, and bentonite). Clogging depended on the ratio of particle-to-pore throat size, and also on pore-fluid chemistry because the pore-fluid chemistry changes effectively increased or decreased the fines cluster size relative to the pore-throat width. These interactions can be predicted based on the fines electrical sensitivity (defined by Jang and Santamarina, 2016). The fine-grained sediment component (grain size < 75 m) from the primary gas hydrate reservoir layers at Sites NGHP-02-09 and -16 show clogging via blocking or size exclusion (sieving) due to the large particles. Clogs also formed due to bridging or blocking by clusters of the smaller particles. Clogging generally occurred for pore-water sediment concentrations so low (0.2% by mass or less), that it was difficult to resolve the enhanced clogging in the presence of the gas/liquid meniscus.

Bay of Bengal↗

USGS2014

Laboratory constraints on models of earthquake recurrence

In this study, rock friction ‘stick-slip’ experiments are used to develop constraints on models of earthquake recurrence. Constant-rate loading of bare rock surfaces in high quality experiments produces stick-slip recurrence that is periodic at least to second order. When the loading rate is varied, recurrence is approximately inversely proportional to loading rate. These laboratory events initiate due to a slip rate-dependent process that also determines the size of the stress drop [Dieterich, 1979; Ruina, 1983] and as a consequence, stress drop varies weakly but systematically with loading rate [e.g., Gu and Wong, 1991; Karner and Marone, 2000; McLaskey et al., 2012]. This is especially evident in experiments where the loading rate is changed by orders of magnitude, as is thought to be the loading condition of naturally occurring, small repeating earthquakes driven by afterslip, or low-frequency earthquakes loaded by episodic slip. As follows from the previous studies referred to above, experimentally observed stress drops are well described by a logarithmic dependence on recurrence interval that can be cast as a non-linear slip-predictable model. The fault’s rate dependence of strength is the key physical parameter. Additionally, even at constant loading rate the most reproducible laboratory recurrence is not exactly periodic, unlike existing friction recurrence models. We present example laboratory catalogs that document the variance and show that in large catalogs, even at constant loading rate, stress drop and recurrence co-vary systematically. The origin of this covariance is largely consistent with variability of the dependence of fault strength on slip rate. Laboratory catalogs show aspects of both slip and time predictability and successive stress drops are strongly correlated indicating a ‘memory’ of prior slip history that extends over at least one recurrence cycle.

Journal of Geophysical Research↗