USGS ScienceSearch

Geology topics

J.R. Nuckols

Publications and source records attributed to J.R. Nuckols.

4 recordsLinked to original sources

Estimating water supply arsenic levels in the New England bladder cancer study

Background: Ingestion of inorganic arsenic in drinking water is recognized as a cause of bladder cancer when levels are relatively high (≥ 150 μg/L). The epidemiologic evidence is less clear at the low-to-moderate concentrations typically observed in the United States. Accurate retrospective exposure assessment over a long time period is a major challenge in conducting epidemiologic studies of environmental factors and diseases with long latency, such as cancer. Objective: We estimated arsenic concentrations in the water supplies of 2,611 participants in a population-based case–control study in northern New England. Methods: Estimates covered the lifetimes of most study participants and were based on a combination of arsenic measurements at the homes of the participants and statistical modeling of arsenic concentrations in the water supply of both past and current homes. We assigned a residential water supply arsenic concentration for 165,138 (95%) of the total 173,361 lifetime exposure years (EYs) and a workplace water supply arsenic level for 85,195 EYs (86% of reported occupational years). Results: Three methods accounted for 93% of the residential estimates of arsenic concentration: direct measurement of water samples (27%; median, 0.3 μg/L; range, 0.1–11.5), statistical models of water utility measurement data (49%; median, 0.4 μg/L; range, 0.3–3.3), and statistical models of arsenic concentrations in wells using aquifers in New England (17%; median, 1.6 μg/L; range, 0.6–22.4). Conclusions: We used a different validation procedure for each of the three methods, and found our estimated levels to be comparable with available measured concentrations. This methodology allowed us to calculate potential drinking water exposure over long periods.

Environmental Health Perspectives

Modeling the probability of arsenic in groundwater in New England as a tool for exposure assessment

We developed a process-based model to predict the probability of arsenic exceeding 5 ??g/L in drinking water wells in New England bedrock aquifers. The model is being used for exposure assessment in an epidemiologic study of bladder cancer. One important study hypothesis that may explain increased bladder cancer risk is elevated concentrations of inorganic arsenic in drinking water. In eastern New England, 20-30% of private wells exceed the arsenic drinking water standard of 10 micrograms per liter. Our predictive model significantly improves the understanding of factors associated with arsenic contamination in New England. Specific rock types, high arsenic concentrations in stream sediments, geochemical factors related to areas of Pleistocene marine inundation and proximity to intrusive granitic plutons, and hydrologic and landscape variables relating to groundwater residence time increase the probability of arsenic occurrence in groundwater. Previous studies suggest that arsenic in bedrock groundwater may be partly from past arsenical pesticide use. Variables representing historic agricultural inputs do not improve the model, indicating that this source does not significantly contribute to current arsenic concentrations. Due to the complexity of the fractured bedrock aquifers in the region, well depth and related variables also are not significant predictors. ?? 2006 American Chemical Society.

Environmental Science & Technology

Proximity to crops and residential to agricultural herbicides in Iowa

Rural residents can be exposed to agricultural pesticides through the proximity of their homes to crop fields. Previously, we developed a method to create historical crop maps using a geographic information system. The aim of the present study was to determine whether crop maps are useful for predicting levels of crop herbicides in carpet dust samples from residences. From homes of participants in a case-control study of non-Hodgkin lymphoma in Iowa (1998-2000), we collected vacuum cleaner dust and measured 14 herbicides with high use on corn and soybeans in Iowa. Of 112 homes, 58% of residences had crops within 500 m of their home, an intermediate distance for primary drift from aerial and ground applications. Detection rates for herbicides ranged from 0% for metribuzin and cyanazine to 95% for 2,4-dichlorophenoxyacetic acid. Six herbicides used almost exclusively in agriculture were detected in 28% of homes. Detections and concentrations were highest in homes with an active farmer. Increasing acreage of corn and soybean fields within 750 m of homes was associated with significantly elevated odds of detecting agricultural herbicides compared with homes with no crops within 750 m (adjusted odds ratio per 10 acres = 1.06; 95% confidence interval, 1.02-1.11). Herbicide concentrations also increased significantly with increasing acreage within 750 m. We evaluated the distance of crop fields from the home at < 100, 101-250, 251-500, and 501-750 m. Including the crop buffer distance parameters in the model did not significantly improve the fit compared with a model with total acres within 750 m. Our results indicate that crop maps may be a useful method for estimating levels of herbicides in homes from nearby crop fields.

Environmental Health Perspectives

An automated approach to mapping corn from Landsat imagery

Most land cover maps generated from Landsat imagery involve classification of a wide variety of land cover types, whereas some studies may only need spatial information on a single cover type. For example, we required a map of corn in order to estimate exposure to agricultural chemicals for an environmental epidemiology study. Traditional classification techniques, which require the collection and processing of costly ground reference data, were not feasible for our application because of the large number of images to be analyzed. We present a new method that has the potential to automate the classification of corn from Landsat satellite imagery, resulting in a more timely product for applications covering large geographical regions. Our approach uses readily available agricultural areal estimates to enable automation of the classification process resulting in a map identifying land cover as ‘highly likely corn,’ ‘likely corn’ or ‘unlikely corn.’ To demonstrate the feasibility of this approach, we produced a map consisting of the three corn likelihood classes using a Landsat image in south central Nebraska. Overall classification accuracy of the map was 92.2% when compared to ground reference data.

Computers and Electronics in Agriculture