Geology topics
Publications and source records attributed to J.D. Byerlee.
Frictional sliding on sawcuts and faults in laboratory samples of granite and gabbro is markedly temperature-dependent. At pressures from 1 to 5 kilobars, stick-slip gave way to stable sliding as temperature was increased from 200 to 500 degrees Celsius. Increased temperature with depth could thus cause the abrupt disappearance of earthquakes noted at shallow depths in California.
At a confining pressure of a few kilobars, deformation of many sedimentary rocks, altered mafic rocks, porous volcanic rocks, and sand is ductile, in that instabilities leading to audible elastic shocks are absent. At pressures of 7 to 10 kilobars, however, unstable faulting and stick-slip in certain of these rocks was observed. This high pressure-low temperature instability might be responsible for earthquakes in deeply buried sedimentary or volcanic sequences.
A theory of friction is presented that may be more applicable to geologic materials than the classic Bowden and Tabor theory. In the model, surfaces touch at the peaks of asperities and sliding occurs when the asperities fail by brittle fracture. The coefficient of friction, μ, was calculated from the strength of asperities of certain ideal shapes; for cone‐shaped asperities, μ is about 0.1 and for wedge‐shaped asperities, μ is about 0.15. For actual situations which seem close to the ideal model, observed μ was found to be very close to 0.1, even for materials such as quartz and calcite with widely differing strengths. If surface forces are present, the theory predicts that μ should decrease with load and that it should be higher in a vacuum than in air. In the presence of a fluid film between sliding surfaces, μ should depend on the area of the surfaces in contact. Both effects are observed. The character of wear particles produced during sliding and the way in which μ depends on normal load, roughness, and environment lend further support to the model of friction presented here.