J. D. Lonn | USGS Science

USGS2004

Early Tertiary Anaconda metamorphic core complex, southwestern Montana

A sinuous zone of gently southeast-dipping low-angle Tertiary normal faults is exposed for 100 km along the eastern margins of the Anaconda and Flint Creek ranges in southwest Montana. Faults in the zone variously place Mesoproterozoic through Paleozoic sedimentary rocks on younger Tertiary granitic rocks or on sedimentary rocks older than the overlying detached rocks. Lower plate rocks are lineated and mylonitic at the main fault and, below the mylonitic front, are cut by mylonitic mesoscopic to microscopic shear zones. The upper plate consists of an imbricate stack of younger-on-older sedimentary rocks that are locally mylonitic at the main, lowermost detachment fault but are characteristically strongly brecciated or broken. Kinematic indicators in the lineated mylonite indicate tectonic transport to the east-southeast. Syntectonic sedimentary breccia and coarse conglomerate derived solely from upper plate rocks were deposited locally on top of hanging-wall rocks in low-lying areas between fault blocks and breccia zones. Muscovite occurs locally as mica fish in mylonitic quartzites at or near the main detachment. The 40Ar/39Ar age spectrum obtained from muscovite in one mylonitic quartzite yielded an age of 47.2 + 0.14 Ma, interpreted to be the age of mylonitization. The fault zone is interpreted as a detachment fault that bounds a metamorphic core complex, here termed the Anaconda metamorphic core complex, similar in age and character to the Bitterroot mylonite that bounds the Bitterroot metamorphic core complex along the Idaho-Montana state line 100 km to the west. The Bitterroot and Anaconda core complexes are likely components of a continuous, tectonically integrated system. Recognition of this core complex expands the region of known early Tertiary brittle-ductile crustal extension eastward into areas of profound Late Cretaceous contractile deformation characterized by complex structural interactions between the overthrust belt and Laramide basement uplifts, overprinted by late Tertiary Basin and Range faulting. ?? 2004 NRC Canada.

Canadian Journal of Earth Sciences↗

USGS2000

Geologic map of the Lima 30’ x 60’ quadrangle, southwest Montana

This geologic map represents a compilation of mostly previously unpublished maps by numerous authors. The map is divided into three areas of responsibility: 1) the Tendoy Mountains and western Centennial Mountains, mapped and compiled by Betty Skipp, Susanne Janecke, and Bill Perry (Part A); 2) the Snowcrest Range, mapped by Edward T. Ruppel (Part B), and 3) the remainder of the area, including the Sage Creek basin, the Red Rock Hills, the Blacktail Range, and the Upper Blacktail Deer Creek valley, compiled and mapped by Jeff Lonn and Jim Sears, with data also contributed by Bill Fritz, Hugh Hurlow, and Rob Thomas (Part C). Figure 1 shows mapping responsibilities. The geologic map (Plate 1) is accompanied by this text pamphlet describing map units for each of the three areas. The same lithologic distinctions among units and the same unit labels were used where possible, usually where formal stratigraphic nomenclature existed, but each area has its own informal Tertiary and Quaternary stratigraphy. References are also given separately in each section. However, correlation diagrams for each of the three areas are shown in a single Correlation Chart for the whole quadrangle (Figure 2). Plate 2, at the same scale, is provided in order to show more readily the names being applied to specific faults and folds, particularly in the Tendoy Mountains and western Centennial Mountains.

Montana↗