USGS Science⌕ Search

Geology topics

H.I. Essaid

Publications and source records attributed to H.I. Essaid.

9 recordsLinked to original sources
USGS2010

Simulation of fluid distributions observed at a crude oil spill site incorporating hysteresis, oil entrapment, and spatial variability of hydraulic properties

Subsurface oil, water, and air saturation distributions were determined using 146 samples collected from seven boreholes along a 120-m transect at a crude oil spill site near Bemidji, Minnesota. The field data, collected 10 years after the spill, show a clearly defined oil body that has an oil saturation distribution that appears to be influenced by sediment heterogeneities and water table fluctuations. The center of the oil body has depressed the water-saturated zone boundary and the oil appears to have migrated laterally within the capillary fringe. A multiphase cross-sectional flow model was developed and used to simulate the movement of oil and water at the spill site. Comparisons between observed and simulated oil saturation distributions serve as an indicator of the appropriateness of using such models to predict the actual spread of organic immiscible liquids at spill sites. Sediment hydraulic properties used in the model were estimated from particle size data. The general large-scale features of the observed oil body were reproduced only when hysteresis with oil entrapment and representations of observed spatial variability of hydraulic properties were incorporated into the model. The small-scale details of the observed subsurface oil distribution were not reproduced in the simulations. The discrepancy between observed and simulated oil distributions reflects the considerable uncertainty in model parameter estimates and boundary conditions, three-phase capillary pressure-saturation-relative permeability functions, representations of spatial variability of hydraulic properties, and hydrodynamics of the groundwater flow system at the study site.

Water Resources Research↗
USGS2009

Benthic nutrient sources to hypereutrophic Upper Klamath Lake, Oregon, USA

Three collecting trips were coordinated in April, May, and August 2006 to sample the water column and benthos of hypereutrophic Upper Klamath Lake (OR, USA) through the annual cyanophyte bloom of Aphanizomenon flos‐aquae . A pore‐water profiler was designed and fabricated to obtain the first high‐resolution (centimeter‐scale) estimates of the vertical concentration gradients of macro‐ and micronutrients for diffusive‐flux determinations. A consistently positive benthic flux for soluble reactive phosphorus (SRP) was observed with solute release from the sediment, ranging between 0.4 and 6.1 mg/m 2 /d. The mass flux over an approximate 200‐km 2 lake area was comparable in magnitude to riverine inputs. An additional concern related to fish toxicity was identified when dissolved ammonium also displayed consistently positive benthic fluxes of 4 to 134 mg/m 2 /d, again comparable to riverine inputs. Although phosphorus was a logical initial choice by water quality managers for the limiting nutrient when nitrogen‐fixing cyanophytes dominate, initial trace‐element results from the lake and major inflowing tributaries suggested that the role of iron limitation on primary productivity should be investigated. Dissolved iron became depleted in the lake water column during the course of the algal bloom, while dissolved ammonium and SRP increased. Elevated macroinvertebrate densities, at least of the order of 10 4 individuals/m 2 , suggested that the diffusive‐flux estimates may be significantly enhanced by bioturbation. In addition, heat‐flux modeling indicated that groundwater advection of nutrients could also significantly contribute to internal nutrient loading. Accurate environmental assessments of lentic systems and reasonable expectations for point‐source management require quantitative consideration of internal solute sources.

Environmental Toxicology and Chemistry↗
USGS2003

Inverse modeling of BTEX dissolution and biodegradation at the Bemidji, MN crude-oil spill site

The U.S. Geological Survey (USGS) solute transport and biodegradation code BIOMOC was used in conjunction with the USGS universal inverse modeling code UCODE to quantify field-scale hydrocarbon dissolution and biodegradation at the USGS Toxic Substances Hydrology Program crude-oil spill research site located near Bemidji, MN. This inverse modeling effort used the extensive historical data compiled at the Bemidji site from 1986 to 1997 and incorporated a multicomponent transport and biodegradation model. Inverse modeling was successful when coupled transport and degradation processes were incorporated into the model and a single dissolution rate coefficient was used for all BTEX components. Assuming a stationary oil body, we simulated benzene, toluene, ethylbenzene, m , p -xylene, and o -xylene (BTEX) concentrations in the oil and ground water, respectively, as well as dissolved oxygen. Dissolution from the oil phase and aerobic and anaerobic degradation processes were represented. The parameters estimated were the recharge rate, hydraulic conductivity, dissolution rate coefficient, individual first-order BTEX anaerobic degradation rates, and transverse dispersivity. Results were similar for simulations obtained using several alternative conceptual models of the hydrologic system and biodegradation processes. The dissolved BTEX concentration data were not sufficient to discriminate between these conceptual models. The calibrated simulations reproduced the general large-scale evolution of the plume, but did not reproduce the observed small-scale spatial and temporal variability in concentrations. The estimated anaerobic biodegradation rates for toluene and o -xylene were greater than the dissolution rate coefficient. However, the estimated anaerobic biodegradation rates for benzene, ethylbenzene, and m , p -xylene were less than the dissolution rate coefficient. The calibrated model was used to determine the BTEX mass balance in the oil body and groundwater plume. Dissolution from the oil body was greatest for compounds with large effective solubilities (benzene) and with large degradation rates (toluene and o -xylene). Anaerobic degradation removed 77% of the BTEX that dissolved into the water phase and aerobic degradation removed 17%. Although goodness-of-fit measures for the alternative conceptual models were not significantly different, predictions made with the models were quite variable.

Minnesota↗
USGS2001

Progression of natural attenuation processes at a crude oil spill site: II. Controls on spatial distribution of microbial populations

A multidisciplinary study of a crude-oil contaminated aquifer shows that the distribution of microbial physiologic types is strongly controlled by the aquifer properties and crude oil location. The microbial populations of four physiologic types were analyzed together with permeability, pore-water chemistry, nonaqueous oil content, and extractable sediment iron. Microbial data from three vertical profiles through the anaerobic portion of the contaminated aquifer clearly show areas that have progressed from iron-reduction to methanogenesis. These locations contain lower numbers of iron reducers, and increased numbers of fermenters with detectable methanogens. Methanogenic conditions exist both in the area contaminated by nonaqueous oil and also below the oil where high hydrocarbon concentrations correspond to local increases in aquifer permeability. The results indicate that high contaminant flux either from local dissolution or by advective transport plays a key role in determining which areas first become methanogenic. Other factors besides flux that are important include the sediment Fe(II) content and proximity to the water table. In locations near a seasonally oscillating water table, methanogenic conditions exist only below the lowest typical water table elevation. During 20 years since the oil spill occurred, a laterally continuous methanogenic zone has developed along a narrow horizon extending from the source area to 50–60 m downgradient. A companion paper [J. Contam. Hydrol. 53, 369–386] documents how the growth of the methanogenic zone results in expansion of the aquifer volume contaminated with the highest concentrations of benzene, toluene, ethylbenzene, and xylenes.

Journal of Contaminant Hydrology↗
USGS1998

Ground water contamination by crude oil near Bemidji, Minnesota

Ground-water contamination by crude oil, and other petroleum-based liquids, is a widespread problem. An average of 83 crude-oil spills occurred per year during 1994-96 in the United States, each spilling about 50,000 barrels of crude oil (U.S. Office of Pipeline Safety, electronic commun., 1997). An understanding of the fate of organic contaminants (such as oil and gasoline) in the subsurface is needed to design innovative and cost-effective remedial solutions at contaminated sites.

Minnesota↗
USGS1992

Determination of subsurface fluid contents at a crude-oil spill site

Measurement of the fluid-content distribution at sites contaminated by immiscible fluids, including crude oil, is needed to better understand the movement of these fluids in the subsurface and to provide data to calibrate and verify numerical models and geophysical methods. A laboratory method was used to quantify the fluid contents of 146 core sections retrieved from boreholes aligned along a 120-m longitudinal transect at a crude-oil spill site near Bemidji, Minnesota, U.S.A. The 47-mm-diameter, minimally disturbed cores spanned a 4-m vertical interval contaminated by oil. Cores were frozen on site in a dry ice-alcohol bath to prevent redistribution and loss of fluids while sectioning the cores. We gravimetrically determined oil and water contents using a two-step method: (1) samples were slurried and the oil was removed by absorption onto strips of hydrophobic porous polyethylene (PPE); and (2) the samples were oven-dried to remove the water. The resulting data show sharp vertical gradients in the water and oil contents and a clearly defined oil body. The subsurface distribution is complex and appears to be influenced by sediment heterogeneities and water-table fluctuations. The center of the oil body has depressed the water-saturated zone boundary, and the oil is migrating laterally within the capillary fringe. The oil contents are as high as 0.3cm 3 cm −3 , which indicates that oil is probably still mobile 10 years after the spill occurred. The thickness of oil measured in wells suggests that accumulated thickness in wells is a poor indicator of the actual distribution of oil in the subsurface. Several possible sources of error are identified with the field and laboratory methods. An error analysis indicates that adsorption of water and sediment into the PPE adds as much as 4% to the measured oil masses and that uncertainties in the calculated sample volume and the assumed oil density introduce an additional ±3% error when the masses are converted to fluid contents.

Journal of Contaminant Hydrology↗
USGS1986

A comparison of the coupled fresh water-salt water flow and the Ghyben-Herzberg sharp interface approaches to modeling of transient behavior in coastal aquifer systems

A quasi-three dimensional finite difference model which simulates coupled, fresh water and salt water flow, separated by a sharp interface, is used to investigate the effects of storage characteristics, transmissivity, boundary conditions and anisotropy on the transient responses of such flow systems. The magnitude and duration of the departure of aquifer response from the behavior predicted using the Ghyben-Herzberg, one-fluid approach is a function of the ease with which flow can be induced in the salt water region. In many common hydrogeologic settings short-term fresh water head responses, and transitional responses between short-term and long-term, can only be realistically reproduced by including the effects of salt water flow on the dynamics of coastal flow systems. The coupled fresh water-salt water flow modeling approach is able to reproduce the observed annual fresh water head response of the Waialae aquifer of southeastern Oahu, Hawaii.

Hawaii↗