USGS ScienceSearch

Geology topics

George V. Keller

Publications and source records attributed to George V. Keller.

3 recordsLinked to original sources

A deep research drill hole at the summit of an active volcano, Kilauea, Hawaii

Drilling and geophysical logging data for a 1,262 m‐deep bore hole in the area inferred to overlie the magma reservoir of Kilauea Volcano, Hawaii, support earlier interpretations based on surface geophysical surveys that a zone of brackish or saline water lies above the reservoir. Temperatures encountered within the hole are not sufficiently high to warrant commercial interest; the maximum temperature, 137°C, is at the hole bottom. However, the temperature gradient toward the bottom of the hole (approximately 160 m below sea level) increases sharply to about 370°C/km, perhaps partly reflecting the effect of decreased water circulation as suggested by the geophysical logging data. If this gradient persists or increases with depth, magmatic temperatures would be attained within 3 km from the hole bottom (i.e., approximately 4 km from ground surface)—a depth in accord with data from ground‐deformation and seismic studies.

Hawaii

Directional resistivity measurements in exploration for uranium deposits on the Colorado Plateau

A study of the electrical properties of the Morrison formation in the Uravan mineral belt of the Colorado Plateaus province indicated that there is a significant correlation between electrical resistivity and the relative favorability for occurrence of ore. The differences in resistivity were not large enough to provide a recognizable target for standard resistivity' field methods, especially where the ore-bearing sandstone member is more than a few hundred feet deep. Measurement of resistivity trends by placing one electrode in a drill hole and spreading the others out radially on the surface seemed to offer a means of exploiting the resistivity-favorability correlation. Field tests of such directional resistivity measurements were made in the Spud Patch area in San Miguel County, Colo., and the White Canyon district) San Juan County, Utah. In the Spud Patch area two methods were tried; in one a current electrode was placed in the drill. hole, and in the other, a potential electrode. The second was the more tedious but provided the more readily interpretable results. A comparison of the resistivity trends thus determined with the favorability estimated from geologic indexes indicated that directional resistivity methods could predict the location of favorable areas at distances of 600 to 1,000 feet with a high degree of success. In the White Canyon district directional resistivity measurements were made on the assumption that the conglomerate which is found in many channels filled with the Shinarump member of the Chinle formation has a high resistivity. The measurements were successful in tracing the channel conglomerate where surface conditions were favorable.

Arizona;Colorado;New Mexico;Utah