Geology topics

Gareth J. Funning

Publications and source records attributed to Gareth J. Funning.

6 recordsLinked to original sources

USGS2024

A rockslide-generated tsunami in a Greenland fjord rang Earth for 9 days

Climate change is increasingly predisposing polar regions to large landslides. Tsunamigenic landslides have occurred recently in Greenland (Kalaallit Nunaat), but none have been reported from the eastern fjords. In September 2023, we detected the start of a 9-day-long, global 10.88-millihertz (92-second) monochromatic very-long-period (VLP) seismic signal, originating from East Greenland. In this study, we demonstrate how this event started with a glacial thinning–induced rock-ice avalanche of 25 × 106 cubic meters plunging into Dickson Fjord, triggering a 200-meter-high tsunami. Simulations show that the tsunami stabilized into a 7-meter-high long-duration seiche with a frequency (11.45 millihertz) and slow amplitude decay that were nearly identical to the seismic signal. An oscillating, fjord-transverse single force with a maximum amplitude of 5 × 1011 newtons reproduced the seismic amplitudes and their radiation pattern relative to the fjord, demonstrating how a seiche directly caused the 9-day-long seismic signal. Our findings highlight how climate change is causing cascading, hazardous feedbacks between the cryosphere, hydrosphere, and lithosphere.

Science↗

USGS2021

A geology and geodesy based model of dynamic earthquake rupture on the Rodgers Creek‐Hayward‐Calaveras Fault System, California

The Hayward fault in California's San Francisco Bay area produces large earthquakes, with the last occurring in 1868. We examine how physics‐based dynamic rupture modeling can be used to numerically simulate large earthquakes on not only the Hayward fault, but also its connected companions to the north and south, the Rodgers Creek and Calaveras faults. Equipped with a wealth of images of this fault system, including those of its 3D geology and 3D geometry, in addition to inferences about its interseismic creep‐rate pattern and rock‐friction behavior, we use a finite‐element computer code to perform 3D dynamic earthquake rupture simulations. We find that the rock properties affect the locations and amount of slip produced in our simulated large earthquakes. Crucial factors that control rupture behavior in our modeling are the earthquake nucleation locations, the fault geometry, and the data that reveal where the fault system is creeping or locked. Our findings suggest that large Rodgers Creek‐Hayward‐Calaveras‐Northern Calaveras (RC‐H‐C‐NC) fault‐system earthquakes may result from dynamic rupture that starts in a locked part of the fault system, but is then stopped by the creeping parts, leading to high‐magnitude‐6 earthquakes; or, from dynamic rupture that starts in a locked part of the fault system, then cascades through some of the creeping parts, leading to magnitude‐7 earthquakes.

California↗

USGS2020

Documentation of Surface Fault Rupture and Ground‐Deformation Features Produced by the 4 and 5 July 2019 Mw 6.4 and Mw 7.1 Ridgecrest Earthquake Sequence

The M w "> M w Mw 6.4 and M w "> M w Mw 7.1 Ridgecrest earthquake sequence occurred on 4 and 5 July 2019 within the eastern California shear zone of southern California. Both events produced extensive surface faulting and ground deformation within Indian Wells Valley and Searles Valley. In the weeks following the earthquakes, more than six dozen scientists from government, academia, and the private sector carefully documented the surface faulting and ground‐deformation features. As of December 2019, we have compiled a total of more than 6000 ground observations; approximately 1500 of these simply note the presence or absence of fault rupture or ground failure, but the remainder include detailed descriptions and other documentation, including tens of thousands of photographs. More than 1100 of these observations also include quantitative field measurements of displacement sense and magnitude. These field observations were supplemented by mapping of fault rupture and ground‐deformation features directly in the field as well as by interpreting the location and extent of surface faulting and ground deformation from optical imagery and geodetic image products. We identified greater than 68 km of fault rupture produced by both earthquakes as well as numerous sites of ground deformation resulting from liquefaction or slope failure. These observations comprise a dataset that is fundamental to understanding the processes that controlled this earthquake sequence and for improving earthquake hazard estimates in the region. This article documents the types of data collected during postearthquake field investigations, the compilation effort, and the digital data products resulting from these efforts.

California↗

USGS2018

Interseismic ground deformation and fault slip rates in the greater San Francisco Bay Area from two decades of space geodetic data

The detailed spatial variations of strain accumulation and creep on major faults in the northern San Francisco Bay Area (North Bay), which are important for seismic potential and evaluation of natural hazards, remain poorly understood. Here we combine interferometric synthetic aperture radar data from the ERS‐1/2 and Envisat satellites between 1992 and 2010 with continuous and campaign GPS data to obtain a high spatial and temporal coverage of ground deformation of the North Bay. The SAR data from both ascending and descending orbits are combined to separate horizontal and vertical components of the deformation. We jointly invert the horizontal component of the mean velocities derived from these data to infer the deep strike‐slip rates on major locked faults. We use the estimated deep rates to simulate the long‐wavelength deformation due to interseismic elastic strain accumulation along these locked faults. After removing the long‐wavelength signal from the InSAR horizontal mean velocity field, we estimate fault‐parallel surface creep rates of up to 2 mm/year along the central section of the Rodgers Creek fault and surface creep rates ranging between 2 and 4 mm/year along the Concord fault. No surface creep is geodetically resolved along the West Napa and Green Valley fault zones. We identified characteristically repeating earthquakes on the Rodgers Creek fault, the West Napa fault, the Green Valley fault, and the Concord fault. Nontectonic deformation in the Geysers geothermal field and in Late Cenozoic basins (Rohnert Park and Sonoma basins) are also observed, likely due to hydrological and sediment‐compaction processes, respectively.

Journal of Geophysical Research B: Solid Earth↗

USGS2017

Dynamic rupture modeling of the M7.2 2010 El Mayor-Cucapah earthquake: Comparison with a geodetic model

The 2010 M w 7.2 El Mayor-Cucapah earthquake is the largest event recorded in the broader Southern California-Baja California region in the last 18 years. Here we try to analyze primary features of this type of event by using dynamic rupture simulations based on a multifault interface and later compare our results with space geodetic models. Our results show that starting from homogeneous prestress conditions, slip heterogeneity can be achieved as a result of variable dip angle along strike and the modulation imposed by step over segments. We also considered effects from a topographic free surface and find that although this does not produce significant first-order effects for this earthquake, even a low topographic dome such as the Cucapah range can affect the rupture front pattern and fault slip rate. Finally, we inverted available interferometric synthetic aperture radar data, using the same geometry as the dynamic rupture model, and retrieved the space geodetic slip distribution that serves to constrain the dynamic rupture models. The one to one comparison of the final fault slip pattern generated with dynamic rupture models and the space geodetic inversion show good agreement. Our results lead us to the following conclusion: in a possible multifault rupture scenario, and if we have first-order geometry constraints, dynamic rupture models can be very efficient in predicting large-scale slip heterogeneities that are important for the correct assessment of seismic hazard and the magnitude of future events. Our work contributes to understanding the complex nature of multifault systems.

California↗

USGS2016

Spatial variations in fault friction related to lithology from rupture and afterslip of the 2014 South Napa, California, earthquake

Following earthquakes, faults are often observed to continue slipping aseismically. It has been proposed that this afterslip occurs on parts of the fault with rate-strengthening friction that are stressed by the mainshock, but our understanding has been limited by a lack of immediate, high-resolution observations. Here we show that the behavior of afterslip following the 2014 South Napa earthquake varied over distances of only a few kilometers. This variability cannot be explained by coseismic stress changes alone. We present daily positions from continuous and survey GPS sites that we re-measured within 12 hours of the mainshock, and surface displacements from the new Sentinel-1 radar mission. This unique geodetic data set constrains the distribution and evolution of coseismic and postseismic fault slip with exceptional resolution in space and time. We suggest that the observed heterogeneity in behavior is caused by lithological controls on the frictional properties of the fault plane.

California↗