Geology topics

F.D. Wilde

Publications and source records attributed to F.D. Wilde.

5 recordsLinked to original sources

USGS2010

Sampling protocol for post-landfall Deepwater Horizon oil release, Gulf of Mexico, 2010

The protocols and procedures described in this report are designed to be used by U.S. Geological Survey (USGS) field teams for the collection of environmental data and samples in coastal areas affected by the 2010 Deepwater Horizon oil spill in the Gulf of Mexico. This sampling protocol focuses specifically on sampling for water, sediments, benthic invertebrates, and microorganisms (ambient bacterial populations) after shoreline arrival of petroleum-associated product on beach, barrier island, and wetland environments of the Gulf of Mexico coastal states. Deployment to sampling sites, site setup, and sample collection in these environments necessitates modifications to standard USGS sampling procedures in order to address the regulatory, logistical, and legal requirements associated with samples collected in oil-impacted coastal areas. This document, therefore, has been written as an addendum to the USGS National Field Manual for the Collection of Water-Quality Data (NFM) (http://pubs.water.usgs.gov/twri9A/), which provides the basis for training personnel in the use of standard USGS sampling protocols. The topics covered in this Gulf of Mexico oil-spill sampling protocol augment NFM protocols for field-deployment preparations, health and safety precautions, sampling and quality-assurance procedures, and decontamination requirements under potentially hazardous environmental conditions. Documentation procedures and maintenance of sample integrity by use of chain-of-custody procedures also are described in this protocol.

Open-File Report↗

USGS2005

Change in field turbidity and trace element concentrations during well purging

Various physical and chemical properties were monitored sequentially in the field during well purging as indicators of stabilization of the composition of the water in the well. Turbidity was monitored on site during purging of oxic water from three wells with screened intervals open to an unconfined aquifer system in the Coastal Plain of southern New Jersey to determine if stabilization of turbidity is a reliable indicator of the optimum purge time required to collect unbiased trace element samples. Concurrent split (one filtered, one unfiltered) samples collected during purging of the wells were analyzed for concentrations of trace elements so that the relationships between trace element concentrations and turbidity could be compared. Turbidity correlated with the whole water recoverable (WWR) concentration of trace element species, such as iron (Fe), aluminum (Al), and manganese (Mn) in the oxic ground water. Turbidity appeared to be independent of other field-measured characteristics of water such as conductivity, pH, temperature, and dissolved oxygen. The WWR concentration of lead and copper, considered to be hydrophobic, correlated significantly with the sum of the WWR concentration of Fe, Al, and Mn. High values of field-measured turbidity were a key indicator of an overestimate of ambient hydrophobic trace element WWR concentrations. Stabilization of turbidity was a better indicator of stable, unfiltered trace element concentrations than were the other commonly measured field characteristics. At one well, turbidity was a better indicator of stable, filtered trace element concentrations than the other commonly measured field characteristics. As analytical methods for trace elements improve resulting in smaller MRLs (method reporting levels) and better precision, turbidity of ground water at values of less than 10 NTU (nepheiometric turbidity units) will become important in interpreting the significance of both unfiltered and filtered sample results.

New Jersey↗

USGS2005

Specific electrical conductance

Electrical conductance is a measure of the capacity of a substance to conduct an electrical current. The specific electrical conductance (conductivity) of water is a function of the types and quantities of dissolved substances it contains, normalized to a unit length and unit cross section at a specified temperature. This section of the National Field Manual (NFM) describes U.S. Geological Survey (USGS) guidance and protocols for measurement of conductivity in ground and surface waters.

Techniques of Water-Resources Investigations↗

USGS1997

Guidelines and standard procedures for studies of ground-water quality; selection and installation of wells, and supporting documentation

This is the first of a two-part report to document guidelines and standard procedures of the U.S. Geological Survey for the acquisition of data in ground-water-quality studies. This report provides guidelines and procedures for the selection and installation of wells for water-quality studies/*, and the required or recommended supporting documentation of these activities. Topics include (1) documentation needed for well files, field folders, and electronic files; (2) criteria and information needed for the selection of water-supply and observation wells, including site inventory and data collection during field reconnaissance; and (3) criteria and preparation for installation of monitoring wells, including the effects of equipment and materials on the chemistry of ground-water samples, a summary of drilling and coring methods, and information concerning well completion, development, and disposition.

Water-Resources Investigations Report↗

USGS1989

Ground-water use in the coastal plain of Maryland, 1900-1980

This report presents groundwater withdrawal data from 1900 through 1980 for Maryland counties lying with the Coastal Plain physiographic province, as well as a summary section for the total Maryland Coastal Plain. The types of water use included are domestic, military, water supplier, industrial/commercial, and irrigation. The data were obtained from state and county reports, biannual pumpage reports submitted to the Maryland Water Resources Administration, communication with individual owners, and estimates based on existing published data. The amount of groundwater withdrawn from aquifers in the Maryland Coastal Plain in 1900 was approximately 26 million gallons per day (Mgal/d) compared to nearly 134 Mgal/d in 1980. Jurisdictions withdrawing more than 10 Mgal/d for most of the 80-year period were Anne Arundel and Baltimore Counties and Baltimore City. The greatest withdrawals for most of the early part of the period were for domestic and industrial/commercial uses; however, water-supplier use dominated after 1965. Groundwater use for irrigation became important in the Coastal Plain around 1960 and increased steadily from approximately 2 Mgal/d in 1960 to nearly 12 Mgal/d in 1980. (USGS)

Open-File Report↗