Geology topics

F. C. Chuang

Publications and source records attributed to F. C. Chuang.

5 recordsLinked to original sources

USGS2007

A closer look at water-related geologic activity on Mars

Water has supposedly marked the surface of Mars and produced characteristic landforms. To understand the history of water on Mars, we take a close look at key locations with the High-Resolution Imaging Science Experiment on board the Mars Reconnaissance Orbiter, reaching fine spatial scales of 25 to 32 centimeters per pixel. Boulders ranging up to ∼2 meters in diameter are ubiquitous in the middle to high latitudes, which include deposits previously interpreted as finegrained ocean sediments or dusty snow. Bright gully deposits identify six locations with very recent activity, but these lie on steep (20° to 35°) slopes where dry mass wasting could occur. Thus, we cannot confirm the reality of ancient oceans or water in active gullies but do see evidence of fluvial modification of geologically recent mid-latitude gullies and equatorial impact craters.

Science↗

USGS2003

Isostatic gravity map with simplified geology of the Los Angeles 30 x 60 minute quadrangle

This isostatic residual gravity map is part of the Southern California Areal Mapping Project (SCAMP) and is intended to promote further understanding of the geology in the Los Angeles 30 x 60 minute quadrangle, California, by serving as a basis for geophysical interpretations and by supporting both geological mapping and topical (especially earthquake) studies. Local spatial variations in the Earth's gravity field (after various corrections for elevation, terrain, and deep crustal structure explained below) reflect the lateral variation in density in the mid- to upper crust. Densities often can be related to rock type, and abrupt spatial changes in density commonly mark lithologic boundaries. The map shows contours of isostatic gravity overlain on a simplified geology including faults and rock types. The map is draped over shaded-relief topography to show landforms.

California↗

USGS2000

Geologic mapping of Europa

Galileo data enable the major geological units, structures, and surface features to be identified on Europa. These include five primary units (plains, chaos, band, ridge, and crater materials) and their subunits, along with various tectonic structures such as faults. Plains units are the most widespread. Ridged plains material spans a wide range of geological ages, including the oldest recognizable features on Europa, and appears to represent a style of tectonic resurfacing, rather than cryovolcanism. Smooth plains material typically embays other terrains and units, possibly as a type of fluid emplacement, and is among the youngest material units observed. At global scales, plains are typically mapped as undifferentiated plains material, although in some areas differences can be discerned in the near infrared which might be related to differences in ice grain size. Chaos material is composed of plains and other preexisting materials that have been severely disrupted by inferred internal activity; chaos is characterized by blocks of icy material set in a hummocky matrix. Band material is arrayed in linear, curvilinear, wedge-shaped, or cuspate zones with contrasting albedo and surface textures with respect to the surrounding terrain. Bilateral symmetry observed in some bands and the relationships with the surrounding units suggest that band material forms by the lithosphere fracturing, spreading apart, and infilling with material derived from the subsurface. Ridge material is mapped as a unit on local and some regional maps but shown with symbols at global scales. Ridge material includes single ridges, doublet ridges, and ridge complexes. Ridge materials are considered to represent tectonic processes, possibly accompanied by the extrusion or intrusion of subsurface materials, such as diapirs. The tectonic processes might be related to tidal flexing of the icy lithosphere on diurnal or longer timescales. Crater materials include various interior (smooth central, rough inner, and annular massif) and exterior (continuous ejecta) subunits. Structural features and landforms are shown with conventional symbols. Type localities for the units are identified, along with suggestions for portraying the features on geological maps, including colors and letter abbreviations for material units. Implementing these suggestions by the planetary mapping community would facilitate comparisons of maps for different parts of Europa and contribute to an eventual global synthesis of its complex geology. On the basis of initial mapping results, a stratigraphic sequence is suggested in which ridged plains form the oldest unit on Europa, followed by development of band material and individual ridges. Band materials tend to be somewhat older than ridges, but in many areas the two units formed simultaneously. Similarly, the formation of most chaos follows the development of ridged plains; although chaos is among the youngest materials on Europa, some chaos units might have formed contemporaneously with ridged plains. Smooth plains generally embay all other units and are late-stage in the evolution of the surface. C1 craters are superposed on ridged plains but are crosscut by other materials, including bands and ridges. Most c2 craters postdate all other units, but a few c2 craters are cut by ridge material. C3 craters constitute the youngest recognizable material on Europa. Copyright 2000 by the American Geophysical Union.

Journal of Geophysical Research E: Planets↗

USGS1998

Mountains and Calderas on Io: Possible Implications for Lithosphere Structure and Magma Generation

The combination of Voyager images and newly acquired Galileo images with low illumination and resolutions ranging from 2 to 6 km/pixel now allows determination of the global distribution of mountains and volcanic centers on Io. The mountains generally do not have characteristics typical of terrestrial volcanic landforms, they are evenly distributed across the surface and show no obvious correlation with known hot spots or plumes. Relative elevations, determined by shadow measurements and stereoscopy, indicate that mountains in the newly imaged area range in elevation up to at least 7.6 km. The origin of the mountains remains uncertain. Some appear to be multitiered volcanic constructs; others enclosing the partial remains of large circular depressions appear to be remnants of old volcanoes; yet others show extensive tectonic disruption. Volcanic centers also appear to be distributed evenly across the surface except for an apparently somewhat lower density at high latitudes. The low latitudes have one volcanic center per 7 ?? 104km2, and, on average, the centers are spaced roughly 250 km apart. The global distribution of high mountains suggests that the lithosphere over most of Io is thick. Although the thickness cannot be calculated, the previously suggested 30 km appears reasonable as a lower limit. The high rates of resurfacing combined with the likely dissipation of most of the tidal energy in the asthenosphere and underlying mantle implies a very low temperature gradient in the upper part of the lithosphere and steep gradients in the lower lithosphere. The slow rate of separation of melt from host rock in the magma source regions as a consequence of the low gravity on Io, coupled with the high rate of magma production, will likely result in larger melt fractions than is typical for source regions on Earth. The variety of volcanic landforms suggests that volcanic products with a range of compositions are deposited on the surface. This mixture will be carried downward through the lithosphere as a consequence of the 0.5-1.5 cm/yr resurfacing rates. During descent, the more volatile components will tend to be driven off early, but complete or near-complete melting at the base of the lithosphere may result in rehomogenization of the silicate mixture that remains. ?? 1998 Academic Press.

Icarus↗

USGS1997

Martian drainage densities

Drainage densities on Mars range from zero over large areas of volcanic plains to 0.3–0.5 km −1 locally on some volcanoes. These values refer to geologic units, not to drainage basins, as is normal for terrestrial drainage densities. The highest values are close to the lowest terrestrial values derived by similar techniques. Drainage densities were determined for every geologic unit portrayed on the 1:15,000,000 geologic map of Mars. Except for volcanoes the geologic unit with the highest drainage density is the dissected Noachian plains with a drainage density of 0.0074 km −1 . The average drainage density for Noachian units is 0.0032 km −1 , for Hesperian units is 0.00047 km −1 , and for Amazonian units is 0.00007 km −1 , excluding the volcanoes. These values are 2–3 orders of magnitude lower than typical terrestrial densities as determined by similar techniques from Landsat images. The low drainage densities, despite a cumulative record that spans billions of years, indicate that compared with the Earth, the channel-forming processes have been very inefficient or have operated only rarely or that the surface is extremely permeable. The high drainage density on volcanoes is attributed to a local cause, such as hydrothermal activity, rather than to a global cause such as climate change.

Journal of Geophysical Research E: Planets↗