Geology topics

Elizabeth Screaton

Publications and source records attributed to Elizabeth Screaton.

4 recordsLinked to original sources

USGS2011

Permeability-porosity relationships of subduction zone sediments

Permeability–porosity relationships for sediments from the northern Barbados, Costa Rica, Nankai, and Peru subduction zones were examined based on sediment type, grain size distribution, and general mechanical and chemical compaction history. Greater correlation was observed between permeability and porosity in siliciclastic sediments, diatom oozes, and nannofossil chalks than in nannofossil oozes. For siliciclastic sediments, grouping of sediments by percentage of clay-sized material yields relationships that are generally consistent with results from other marine settings and suggests decreasing permeability as percentage of clay-sized material increases. Correction of measured porosities for smectite content improved the correlation of permeability–porosity relationships for siliciclastic sediments and diatom oozes. The relationship between permeability and porosity for diatom oozes is very similar to the relationship in siliciclastic sediments, and permeabilities of both sediment types are related to the amount of clay-size particles. In contrast, nannofossil oozes have higher permeability values by 1.5 orders of magnitude than siliciclastic sediments of the same porosity and show poor correlation between permeability and porosity. More indurated calcareous sediments, nannofossil chalks, overlap siliciclastic permeabilities at the lower end of their measured permeability range, suggesting similar consolidation patterns at depth. Thus, the lack of correlation between permeability and porosity for nannofossil oozes is likely related to variations in mechanical and chemical compaction at shallow depths. This study provides the foundation for a much-needed global database with fundamental properties that relate to permeability in marine settings. Further progress in delineating controls on permeability requires additional carefully documented permeability measurements on well-characterized samples.

Marine Geology↗

USGS2005

Data report: Permeabilities of eastern equatorial Pacific and Peru margin sediments

Constant-flow permeability tests were conducted on core samples from Ocean Drilling Program Leg 201 from the eastern equatorial Pacific and the Peru margin. Eighteen whole-round core samples from Sites 1225, 1226, 1227, 1230, and 1231 were tested for vertical permeabilities. Sites 1225, 1226, and 1231 represent sediments of the open ocean, whereas Sites 1227 and 1230 represent sediments of the ocean margin. Measured vertical permeabilities vary from ~8 x 10 –19 m 2 to ~1 x 10 –16 m 2 for a porosity range of 45%–90%.

Proceedings of the Ocean Drilling Program: Scienti↗

USGS2003

Headless submarine canyons and fluid flow on the toe of the Cascadia accretionary complex

Headless submarine canyons with steep headwalls and shallowly sloping floors occur on both the second and third landward vergent anticlines on the toe of the Cascadia accretionary complex off central Oregon (45 °N, 125° 30′W). In September 1993, we carried out a series of nine deep tow camera sled runs and nine ALVIN dives to examine the relationship between fluid venting, structure and canyon formation. We studied four canyons on the second and third landward vergent anticlines, as well as the apparently unfailed intercanyon regions along strike. All evidence of fluid expulsion is associated with the canyons; we found no evidence of fluid flow between canyons. Even though all fluid seeps are related to canyons, we did not find seeps in all canyons, and the location of the seeps within the canyons differed. On the landward facing limb of the second landward vergent anticline a robust cold seep community occurs at the canyon’s inflection point. This seep is characterized by chemosynthetic vent clams, tube worms and extensive authigenic carbonate. Fluids for this seep may utilize high-permeability flow paths either parallel to bedding within the second thrust ridge or along the underlying thrust fault before leaking into the overriding section. Two seaward facing canyons on the third anticlinal ridge have vent clam communities near the canyon mouths at approximately the intersection between the anticlinal ridge and the adjacent forearc basin. No seeps were found along strike at the intersection of the slope basin and anticlinal ridge. We infer that the lack of seepage along strike and the presence of seeps in canyons may be related to fluid flow below the forearc basin/slope unconformity (overpressured by the impinging thrust fault to the west?) directed toward canyons at the surface.

Basin Research↗

USGS2003

Slope basins, headless canyons, and submarine palaeoseismology of the Cascadia accretionary complex

A combination of geomorphological, seismic reflection and geotechnical data constrains this study of sediment erosion and deposition at the toe of the Cascadia accretionary prism. We conducted a series of ALVIN dives in a region south of Astoria Canyon to examine the interrelationship of fluid flow and slope failure in a series of headless submarine canyons. Elevated head gradients at the inflection point of canyons have been inferred to assist in localized failures that feed sediment into a closed slope basin. Measured head gradients are an order of magnitude too low to cause seepage-induced slope failure alone; we therefore propose transient slope failure mechanisms. Intercanyon slopes are uniformly unscarred and smooth, although consolidation tests indicate that up to several metres of material may have been removed. A sheet-like failure would remove sediment uniformly, preserving the observed smooth intercanyon slope. Earthquake-induced liquefaction is a likely trigger for this type of sheet failure as the slope is too steep and short for sediment flow to organize itself into channels. Bathymetric and seismic reflection data suggest sediment in a trench slope basin between the second and third ridges from the prism’s deformation is derived locally. A comparison of the amounts of material removed from the slopes and that in the basin shows that the amount of material removed from the slopes may slightly exceed the amount of material in the basin, implying that a small amount of sediment has escaped the basin, perhaps when the second ridge was too low to form a sufficient dam, or through a gap in the second ridge to the south. Regardless, almost 80% of the material shed off the slopes around the basin is deposited locally, whereas the remaining 20% is redeposited on the incoming section and will be re-accreted.

Oregon↗