USGS Science⌕ Search

Geology topics

Eli Silver

Publications and source records attributed to Eli Silver.

5 recordsLinked to original sources
USGS2022

Mega-depressions on the Cocos Ridge: Links between volcanism, faults, hydrothermal circulation, and dissolution

High-resolution bathymetry and 3D seismic data along the Cocos Ridge reveal a 245 km 2 field of ∼1 to 4 km in diameter seafloor depressions. The seafloor depressions are part of a two-tiered honeycomb pattern. The lower-tier depressions have steep faults that truncate strata with chaotic internal reflections consistent with sediment collapse into the depression. These extend into a lens shaped interval just above igneous basement. Overlying these depressions is a second broader set with rough seafloor morphology with gently dipping boundaries defined by pinch-out stratigraphic patterns. Drilling results indicate that the lens-shaped zones that host the deeper depressions represent anomalous regions of high porosity, low velocity, and low density within calcareous rich sediment. Analysis of nannofossils from IODP Site U1414 suggests the collapse structures formed during the late Miocene, whereas the younger shallower depressions likely formed between the early Pliocene and the Pliocene-Pleistocene boundary. Geochemical and petrological analysis at Site U1414 suggests that hydrothermal circulation during the late Miocene led to carbonate dissolution and collapse. Following collapse, focused fluid-flow and bottom current scouring resulted in formation of the overlying set of depressions and a honeycomb seafloor morphology. Similar sets of depressions along the Carnegie Ridge to the south support the hypothesis that two-tiered depressions formed in response to processes that occurred broadly across the Panama Basin between the late Miocene and the Pliocene-Pleistocene transition. Geochemical results at Site U1414, combined with geophysical data, suggest this two-tiered system of depressions currently guides ongoing fluid outflow.

Geochemistry, Geophysics, Geosystems↗
USGS2021

In‐situ mass balance estimates offshore Costa Rica

The Costa Rican convergent margin has been considered a type erosive margin, with erosional models suggesting average losses up to −153 km 3 /km/m.y. However, three‐dimensional (3D) seismic reflection and Integrated Ocean Drilling Program data collected offshore the Osa Peninsula images accretionary structures and vertical motions that conflict with the forearc basal erosion model. Here we integrate such data to do an in‐situ accounting of material transfer at the plate boundary across the outermost 10 km of the forearc, characterized by active and inactive megathrusts. Our in‐situ budget finds an approximate balance between sediment recycling via accretion and underplating, 0.7–2.3 km 3 /km/m.y., and basal erosion, 0.7 km 3 /km/m.y., while subducting sediment volumes, 7.8 km 3 /km/m.y., greatly outpace either material transfer volumes. These budget results differ significantly from published estimates based on simple proxies of trench axis deflection and slope subsidence. These budget results are the summation of thin incoming hemipelagic sediments that variably accrete along the deformation front, underplating of hemipelagic sediments on the upthrown‐side and basal erosion on the downthrown‐side of active plate bending faulting landward of the trench axis, and sediment subduction primarily composed of pelagic sediments.

Geochemistry, Geophysics, Geosystems↗
USGS2020

Subduction megathrust heterogeneity characterized from 3D seismic data

Megathrust roughness and structural complexity are thought to be controls on earthquake slip at subduction zones because they result in heterogeneity in shear strength and resolved stress. However, because active megathrust faults are difficult to observe, the causes and scales of complexity are largely unknown. Here we measured the in situ properties of the megathrust of the Middle America subduction zone in a three-dimensional seismic reflection volume to determine how fault properties vary. We quantify spatial variability in the megathrust roughness, overburden and rock physical properties. Heterogeneity in the megathrust roughness exists at length scales of a few kilometres because the megathrust is dissected by active lower-plate normal faults, which offset the megathrust and renewed fault roughness. Spatial variations in the rock physical properties at the plate interface are characterized by correlation length scales of hundreds of metres. Frontal prism taper, historical seismicity and the variation in earthquake stress drop values local to the megathrust are all affected by the heterogeneity at these length scales. Both geometric and rheological complexities may therefore control the mechanical behaviour of the subduction plate interface, which includes earthquake rupture characteristics.

Central America megathrust, Pacific Ocean↗
USGS2016

Origin and dynamics of depositionary subduction margins

Here we propose a new framework for forearc evolution that focuses on the potential feedbacks between subduction tectonics, sedimentation, and geomorphology that take place during an extreme event of subduction erosion. These feedbacks can lead to the creation of a “depositionary forearc,” a forearc structure that extends the traditional division of forearcs into accretionary or erosive subduction margins by demonstrating a mode of rapid basin accretion during an erosive event at a subduction margin. A depositionary mode of forearc evolution occurs when terrigenous sediments are deposited directly on the forearc while it is being removed from below by subduction erosion. In the most extreme case, an entire forearc can be removed by a single subduction erosion event followed by depositionary replacement without involving transfer of sediments from the incoming plate. We need to further recognize that subduction forearcs are often shaped by interactions between slow, long-term processes, and sudden extreme events reflecting the sudden influences of large-scale morphological variations in the incoming plate. Both types of processes contribute to the large-scale architecture of the forearc, with extreme events associated with a replacive depositionary mode that rapidly creates sections of a typical forearc margin. The persistent upward diversion of the megathrust is likely to affect its geometry, frictional nature, and hydrogeology. Therefore, the stresses along the fault and individual earthquake rupture characteristics are also expected to be more variable in these erosive systems than in systems with long-lived megathrust surfaces.

Geochemistry, Geophysics, Geosystems↗