Geology topics

E.M. Colvard

Publications and source records attributed to E.M. Colvard.

6 recordsLinked to original sources

USGS2005

Ongoing hydrothermal heat loss from the 1912 ash-flow sheet, Valley of Ten Thousand Smokes, Alaska

The June 1912 eruption of Novarupta filled nearby glacial valleys on the Alaska Peninsula with ash-flow tuff (ignimbrite), and post-eruption observations of thousands of steaming fumaroles led to the name ‘Valley of Ten Thousand Smokes’ (VTTS). By the late 1980s most fumarolic activity had ceased, but the discovery of thermal springs in mid-valley in 1987 suggested continued cooling of the ash-flow sheet. Data collected at the mid-valley springs between 1987 and 2001 show a statistically significant correlation between maximum observed chloride (Cl) concentration and temperature. These data also show a statistically significant decline in the maximum Cl concentration. The observed variation in stream chemistry across the sheet strongly implies that most solutes, including Cl, originate within the area of the VTTS occupied by the 1912 deposits. Numerous measurements of Cl flux in the Ukak River just below the ash-flow sheet suggest an ongoing heat loss of ∼250 MW. This represents one of the largest hydrothermal heat discharges in North America. Other hydrothermal discharges of comparable magnitude are related to heat obtained from silicic magma bodies at depth, and are quasi-steady on a multidecadal time scale. However, the VTTS hydrothermal flux is not obviously related to a magma body and is clearly declining. Available data provide reasonable boundary and initial conditions for simple transient modeling. Both an analytical, conduction-only model and a numerical model predict large rates of heat loss from the sheet 90 years after deposition.

Alaska↗

USGS2002

Tracing and quantifying magmatic carbon discharge in cold groundwaters: Lessons learned from Mammoth Mountain, USA

A major campaign to quantify the magmatic carbon discharge in cold groundwaters around Mammoth Mountain volcano in eastern California was carried out from 1996 to 1999. The total water flow from all sampled cold springs was ??? 1.8 ?? 107 m3/yr draining an area that receives an estimated 2.5 ?? 107 m3/yr of recharge, suggesting that sample coverage of the groundwater system was essentially complete. Some of the waters contain magmatic helium with 3He/4He ratios as high as 4.5 times the atmospheric ratio, and a magmatic component in the dissolved inorganic carbon (DIC) can be identified in virtually every feature sampled. Many waters have a 14C of 0-5 pmC, a ??13C near -5???, and contain high concentrations (20-50 mmol/1) of CO2(aq); but are otherwise dilute (specific conductance = 100-300 ??S/cm) with low pH values between 5 and 6. Such waters have previously escaped notice at Mammoth Mountain, and possibly at many other volcanoes, because CO2 is rapidly lost to the air as the water flows away from the springs, leaving neutral pH waters containing only 1-3 mmol/1 HCO-3. The total discharge of magmatic carbon in the cold groundwater system at Mammoth Mountain is ~ 20 000 t/yr (as CO2), ranging seasonally from about 30 to 90 t/day. Several types of evidence show that this high discharge of magmatic DIC arose in part because of shallow dike intrusion in 1989, but also demonstrate that a long-term discharge possibly half this magnitude (~ 10 000 t/yr) predated that intrusion. To sustain a 10 000 t/yr DIC discharge would require a magma intrusion rate of 0.057 km3 per century, assuming complete degassing of magma with 0.65 wt% CO2 and a density of 2.7 t/m3. The geochemical data also identify a small ( < 1 t/day) discharge of magmatic DIC that can be traced to the Inyo Domes area north of Mammoth Mountain and outside the associated Long Valley caldera. This research, along with recent studies at Lassen Peak and other western USA volcanoes, suggests that the amount of magmatic carbon in cold groundwaters is important to constraining rates of intrusion and edifice weathering at individual volcanoes and may even represent a significant fraction of the global carbon discharge from volcanoes. ?? 2002 Elsevier Science B.V. All rights reserved.

Journal of Volcanology and Geothermal Research↗

USGS2001

Time-variation of hydrothermal discharge at selected sites in the Western United States: Implications for monitoring

We compiled time series of hydrothermal discharge consisting of 3593 chloride- or heat-flux measurements from 24 sites in the Yellowstone region, the northern Oregon Cascades, Lassen Volcanic National Park and vicinity, and Long Valley, California. At all of these sites the hydrothermal phenomena are believed to be as yet unaffected by human activity, though much of the data collection was driven by mandates to collect environmental-baseline data in acticipation of geothermal development. The time series average 19 years in length and some of the Yellowstone sites have been monitored intermittently for over 30 years. Many sites show strong seasonality but few show clear long-term trends, and at most sites statistically significant decadal-scale trends are absent. Thus, the data provide robust estimates of advective heat flow ranging from ~130 MW in the north-central Oregon Cascades to ~6100 MW in the Yellowstone region, and also document Yellowstone hydrothermal chloride and arsenic fluxes of 1740 and 15-20 g/s, respectively. The discharge time series show little sensitivity to regional tectonic events such as earthquakes or inflation/deflation cycles. Most long-term monitoring to date has focused on high-chloride springs and low-temperature fumaroles. The relative stability of these features suggests that discharge measurements done as part of volcano-monitoring programs should focus instead on high-temperature fumaroles, which may be more immediately linked to the magmatic heat source.

Journal of Volcanology and Geothermal Research↗

USGS1999

Physical, chemical, and isotopic data for samples from the Anderson Springs area, Lake County, California, 1998-1999

Anderson Springs is located about 90 miles (145 kilometers) north of San Francisco, California, in the southwestern part of Lake County. The area was first developed in the late 1800s as a health resort, which was active until the 1930s. In the rugged hills to the south of the resort were four small mercury mines of the eastern Mayacmas quicksilver district. About 1,260 flasks of mercury were produced from these mines between 1909 and 1943. In the 1970s, the high-elevation areas surrounding Anderson Springs became part of The Geysers geothermal field. Today, several electric powerplants are located on the ridges above Anderson Springs, utilizing steam produced from a 240°C vapor-dominated reservoir. The primary purpose of this report is to provide physical, chemical, and isotopic data on samples collected in the Anderson Springs area during 1998 and 1999, in response to a Freedom of Information Act request. In July 1998, drainage from the Schwartz adit of the abandoned Anderson mercury mine increased substantially over a 2-day period, transporting a slurry of water and precipitates down a tributary and into Anderson Creek. In August 1998, J.J. Rytuba and coworkers sampled the Schwartz adit drainage and water from the Anderson Springs Hot Spring for base metal and methylmercury analysis. They measured a maximum temperature (Tm) of 85°C in the Hot Spring. Published records show that the temperature of the Anderson Springs Hot Spring (main spring) was 63°C in 1889, 42–52°C from 1974 through 1991, and 77°C in March 1995. To investigate possible changes in thermal spring activity and to collect additional samples for geochemical analysis, C.J. Janik and coworkers returned to the area in September and December 1998. They determined that a cluster of springs adjacent to the main spring had Tm=98°C, and they observed that a new area of boiling vents and small fumaroles (Tm=99.3°C) had formed in an adjacent gully about 20 meters to the north of the main spring. During August–October 1999, several field trips were conducted in the vicinity of Anderson Springs to continue monitoring and sampling the thermal manifestations. The new fumarolic area had increased in temperature and in discharge intensity since 1998, and a zone of dead trees had developed on the steep bank directly west of the fumaroles. Ground temperatures and diffuse flow of CO2 flow through soils were measured in the area surrounding the main spring and new fumaroles and in the zone of tree-kill.

California↗

USGS1997

Hydrologic investigations in the Mammoth Corridor, Yellowstone National Park and vicinity, U.S.A.

The Mammoth Corridor in and adjacent to Yellowstone National Park encompasses a N-S alignment of geothermal features that extends from the Norris Geyser Basin adjacent to the Yellowstone caldera through Mammoth Hot Springs to the Corwin Springs Known Geothermal Resources Area (KGRA). Thermal springs in this region discharge water that ranges from NaKCl, silica-depositing type to CaNaHC0 3 SO 4 , travertine-depositing type. Although only a few relatively shallow wells have been drilled in the corridor, the region is of special interest because of the environmental issues associated with potential geothermal development adjacent to Yellowstone National Park. The U.S. Geological Survey conducted an intensive hydrogeologic study of this region during 1988–1990 and continued to collect hydrologic and geophysical data until 1994. The results of these investigations document the rates of discharge of thermal water and heat within the corridor, evidence for a magmatic heat source beneath the Mammoth Hot Springs area, and evidence for separate geothermal systems associated with Mammoth Hot Springs and with thermal waters discharging in the KGRA in the vicinity of La Duke Hot Springs. These investigations also indicate that limited development of the 70°C geothermal resource in the La Duke area would not affect thermal springs in Yellowstone National Park.

Geothermics↗

USGS1994

Potential effects of the Hawaii Geothermal Project on ground-water resources on the island of Hawaii

In 1990, the State of Hawaii proposed the Hawaii Geothermal Project for the development of as much as 500 MW of electric power from the geothermal system in the East Rift Zone of Kilauea Volcano. This report uses data from 31 wells and 8 springs to describe the properties of the ground-water system in and adjacent to the East Rift Zone. Potential effects of this project on ground-water resources are also discussed. Data show differences in ground-water chemistry and heads within the study area that appear to be related to mixing of waters of different origins and ground-water impoundment by volcanic dikes. East of Pahoa, the ground-water system within the rift is highly transmissive and receives abundant recharge from precipitation; therefore, the pumping of freshwater to support geothermal development in that part of the rift zone would have a minimal effect on ground-water levels. To the southwest of Pahoa, dike impoundment reduces the transmissivity of the ground-water system to such an extent that wells might not be capable of supplying sufficient fresh water to support geothermal operations. Contamination of ground-water resources by accidental release of geothermal fluids into shallow aquifers is possible because of corrosive conditions in the geothermal wells, potential well blowouts, and high ground-water velocities in parts of the region. Hydrologic monitoring of water level, temperature, and chemistry in observation wells should continue throughout development of geothermal resources for the Hawaii Geothermal Project for early detection of leakage and migration of geothermal fluids within the groundwater system.

Water-Resources Investigations Report↗