EXPLORE THE ARCHIVE

Dennis M. Staley

Publications and source records attributed to Dennis M. Staley.

6 recordsLinked to original sources

USGS2026

Numerical modeling of Late Pleistocene to Holocene earthquake-induced progressive rock slope damage in the paraglacial Serpentine valley, Prince William Sound, Alaska

Landslides in deglaciating fjords pose a potential tsunami threat to nearby communities; however, processes contributing to long-term progressive rock damage and landslide conditioning remain poorly constrained in paraglacial settings. Here, we analyse the role of earthquake-induced rock mass damage over late Pleistocene to Holocene time scales, as a conditioning factor for modern landslides, using distinct element numerical modelling to assess spatial and temporal patterns of fracture propagation influenced by varying glacier thickness. Conceptualised numerical models were parameterised by in situ rock mass, glacial and topographic conditions in Serpentine valley, located in Prince William Sound, Alaska, where several large landslides are actively developing along the western valley wall. Results show that although rigid glacier buttressing reduces co-seismic rock mass damage, it does not suppress it completely, and damage occurs both above and below the glacier surface elevation. We demonstrate that topography, and especially steep slopes with topographic convexity, as well as preexisting damage of joint networks and faults inherited from tectonic and exhumation induced stresses, exert primary control on the location of new co-seismic damage. Simulations representing a simplified deglaciation sequence over the past 25 ka, with a series of 10 evenly spaced earthquakes, generated rock mass damage patterns that qualitatively match in situ landslide structural and kinematic observations at one instability in Serpentine valley. Our conceptual study helps clarify the role of repeated seismicity over glacial timescales as a long-term conditioning process for paraglacial rock slope failure, highlighting spatial and temporal patterns of progressive damage accumulation, with outcomes relevant for modern landslide hazard assessment.

Alaska↗

USGS2026

Rapid seismic and infrasound assessment of large landslides: A case study from Denali National Park and Preserve (Alaska)

Large, rapid landslides are a global hazard that can occur in remote, mountainous areas. Eyewitness reports of landslides and satellite imagery can often be limited or delayed, particularly during inclement weather. However, landslide-generated seismic and infrasound (low-frequency atmospheric sound) waves can be remotely detected in near real-time. This information can significantly expedite characterization and possible landslide response activities. Here, we highlight these capabilities using a > 4 million m³ ice–rock avalanche in Denali National Park and Preserve (Alaska). This event was detected via a landslide-specific seismic location and volume estimation algorithm deployed in Alaska, and — notably — by standard earthquake monitoring systems. Following rapid detection of this event, we combined its seismic and infrasound dataset with optical, synthetic aperture radar, and oblique aerial imagery, multitemporal digital elevation models, and a numerical flow model to reconstruct its failure timeline and dynamics. We apply array processing to infrasound signals traveling > 250 km and find that two precursory events occurred minutes prior to the main failure. We use long-period seismic signals to infer the force exerted by the landslide on the Earth and constrain the rheological parameters of our numerical flow simulation with this result and deposit morphology. The main failure produced a steeply-dipping impulsive initial downward force and reached speeds exceeding 60 m/s. This impulsive force generated relatively strong seismic body waves, which contributed to the earthquake system detection. This large, remote Alaska landslide underscores the key value of seismic and infrasound analysis for rapid landslide assessment and motivates efforts to further operationalize these approaches.

Alaska↗

USGS2025

Forecast, monitor, adapt: A multi-agency strategy to protect people from postfire debris flows

In 2020, a wildfire burned across Glenwood Canyon in Colorado, USA. A history of postfire debris flows in the region and a hazard assessment for the burn area indicated that potentially life-threatening debris flows could be triggered by rainfall within months of a wildfire. As a result, four government agencies evaluated strategies to help mitigate hazards, including the loss of human life, that may be associated with debris-flow events. After the fire, 26 large debris flows occurred in the summer of 2021 and three sediment-laden flows occurred in the summer of 2023, but there were no major injuries or fatalities reported. We found that integrating hazard assessment/ forecasting, monitoring, and adaptation scenarios was a successful strategy for reducing postfire debris-flow risks to human life (including injuries and fatalities). Weather forecasts and estimates of debris-flow triggering rainfall thresholds, likelihood, and volume were used to anticipate the timing, location, and magnitude of debris-flow events. Rainfall monitoring and detailed recordkeeping of storms that triggered debris flows were used to validate and update debris-flow warning thresholds that varied with time following the wildfire. Although the governmental agencies working in this burn area had distinct and differing agency mandates, they were able to integrate information to reduce the risk of debris-flow events to human life.

Colorado↗

USGS2025

2024 Surprise Inlet landslides: Insights from a prototype landslide‐triggered tsunami monitoring system in Prince William Sound, Alaska

Alaska's coastal communities face growing landslide hazards owing to glacier retreat and extreme weather intensified by the warming climate, yet hazard monitoring remains challenging. As part of ongoing experimental monitoring in Prince William Sound, we detected three large landslides (0.5–2.3 M m 3 ) at Surprise Inlet on 20 September 2024, within the span of an hour. These events were identified in near real-time through seismic data and later confirmed using satellite imagery, tidal records, and infrasound. The landslides generated a modest tsunami, and a 4 cm wave was recorded by a tide gauge 18 km away, marking the first recorded landslide to reach water since monitoring began in this region in 2021. Here, we examine the detection and interpretation of these landslides using multiple data sources and modeling. We demonstrate the effectiveness of this regional seismic monitoring system and show how complementary instrumentation, where available, can enhance detection capabilities.

Alaska↗

USGS2025

Uncertainty reduction for subaerial landslide-tsunami hazards

Subaerial rock slopes may generate a tsunami by rapidly moving into the water. Large uncertainty in landslide characteristics propagates into large uncertainty in tsunami hazard, making hazard assessment more difficult for land and emergency managers. Once a potentially tsunamigenic landslide is identified, it may not be clear which landslide characteristics contribute most significantly to uncertainty in the tsunami hazard. Our aim is to document the relative worth of different landslide characteristics (e.g., size, material properties) for reducing uncertainty in landslide-tsunami hazard assessments. Isolating the relative importance of specific landslide characteristics may inform prioritization of data collection and improve efficiency in understanding hazard. To accomplish this, we generated a set of 288 landslide-tsunami simulations in which we systematically varied the size and material properties of possible failure extents at the Barry Arm landslide complex in northwestern Prince William Sound, Alaska, USA. We find that for landslides smaller than the receiving waterbody, the landslide volume has the strongest effect on resulting wave characteristics and thus the highest leverage on reducing uncertainty in tsunami hazard. In contrast, for landslides substantially larger than the waterbody, the duration of rapid movement of the landslide has the highest leverage. Based on our results, we propose a classification scheme for subaerial landslides based on the relative size of the landslide and waterbody. Additionally, our results support the generation of a tsunami height transfer function between existing tide gages and a nearby coastal city. These results have direct implications for the practice of operational early warning.

Alaska↗

USGS2024

Using the horizontal-to-vertical spectral ratio method to estimate thickness of the Barry Arm landslide, Prince William Sound, Alaska

Conducting detailed investigations of large landslides is difficult, especially in the subsurface, largely due to environmental factors such as steep slopes, difficult access, and numerous objective hazards. These factors have made it challenging to accurately estimate the depth to the failure surface of the Barry Arm landslide, a large (roughly 10 8 cubic meters), deep-seated bedrock landslide in Prince William Sound, Alaska, recognized in 2019. The landslide has exhibited accelerated movement in recent years and poses a potential tsunamigenic hazard if rapid failure occurs. Failure surface depth, equivalent to landslide thickness, is a necessary metric for landslide-volume calculations and associated tsunami wave models. In this report, we used seismic noise recorded by a seismometer located on the Barry Arm landslide in Alaska to calculate the horizontal-to-vertical spectral ratio (HVSR) to investigate the site fundamental frequency ( f 0 ) and depth of the failure surface. To ensure that observed peak frequencies in the spectral ratio were related to the underlying stratigraphy (and not caused by other noise sources like nearby glaciers, topographic resonance, weather, or human activities), we also calculated HVSRs using earthquake signals, HVSRs at other seismic stations within a 2.5-kilometer radius, and a standard spectral ratio between the landslide station and other sites. We observed multiple peaks in the landslide HVSR curves at 1.5 hertz (Hz), 4–5 Hz, and 7–11 Hz. The frequencies of these peaks were consistent at the landslide site through time and across methods and were dissimilar to those identified at other seismic stations in the area, making it unlikely the peaks were caused by local noise. Directional HVSRs calculated at 15-degree intervals showed amplification of the higher frequency peaks in the direction parallel to slip, indicating two-dimensional site effects. We used the distinct frequency peaks in the seismic record to develop a 4-layer conceptual model of the landslide wherein the top of the deepest layer represents the primary failure surface, or the boundary between damaged (mobile) and undamaged material. We inverted Rayleigh wave ellipticity curves within this 4-layer configuration with constraints on S-wave velocity and layer thickness based on analogous material properties identified in the literature. This was necessary absent any site-specific subsurface S-wave velocity data. The best-fitting models indicate a mean slope-normal depth to the failure surface of 188 (±9) meters (m), with additional stratigraphic boundaries at 4 and 20 m below ground surface, potentially representing layered motion. These results agree with and improve upon ranges estimated by previous studies and can support future modeling and assessment efforts at Barry Arm.

Alaska↗