Deniz Cukur | USGS Science

USGS2021

Deepwater debrites and linked megaturbidites in confined basins: An example from the Onnuri Basin, East Sea of Korea

We analyzed data from seven piston cores, multi-channel seismic-reflection (MCS) and chirp profiles, and multibeam echosounder (MBES) data to study the distribution, emplacement time, sedimentary facies, and depositional processes of sediment-gravity-flow deposits in the Onnuri Basin, a confined basin in the East Sea. These data reveal that debris flows have traveled ca. 30 km downslope, forming a seismic facies consisting of stacked, wedge-shaped, transparent units separated by high-amplitude continuous reflectors. Analysis of piston cores shows three distinct sedimentary units, throughout the basin. The lowest unit, I, is a debrite containing numerous mud clasts of varying size and color distributed in a mud-rich matrix; it is absent over elevated basinal highs or ridges, such as the Onnuri Ridge, suggesting that local topography controls its distribution. The debrite forms a recognizable acoustically transparent layer on subbottom chirp profiles (av. 7 m thick), covers approximately 500 km 2 , and has an estimated volume of ∼ 3.5 km 3 . The overlying unit, II, contains normally graded beds composed of massive sand, laminated and cross-laminated sand and silt, and a thick cap of structureless mud. This unit is interpreted to be a megaturbidite deposited from turbidity currents that originated from the flow transformation of debris flows on the upper continental slope. The megaturbidite covers the entire basin (at least 650 km 2 ), and has an average thickness of 2.8 m (maximum thickness of 4.35 m), and comprises a volume of 1.8 km 3 . Variations in grain size and sedimentary structures suggest that the megaturbidite was deposited by progressively waning flows that reflected off basin flanks and ridges. The thick (up to 3.65 m) structureless mud cap further indicates deposition in a confined basin. The sharp basal contact, together with the lack of hemipelagic sediments between debrite and overlying megaturbidite, suggest that both were deposited during the same flow event, likely to have originated from a single catastrophic slope failure. Collapsing slide material evolved into a debris flow, from which a turbidite formed by dilution of the debris flow. Radiocarbon dates suggest that the slope failure occurred about 13–11 ka, a time when sea level was ca. 50 m lower than at the present day. Hemipelagic sediments in the topmost unit, III-2, above the megaturbidite indicate that the basin has been stable since ca. 11 ka. We provide robust evidence that submarine slope failures evolve downslope into slides, debris flows, and finally, thick megaturbidites. This contribution highlights the importance of seafloor morphology on the distribution and stratigraphy of submarine flows in confined basins.

Onnuri Basin↗

USGS2019

Morphology and genesis of giant seafloor depressions on the southeasterncontinental shelf of the Korean Peninsula

We identify and describe five giant seafloor depressions from the southeastern continental shelf of the Korean Peninsula using multibeam bathymetry, sub-bottom profiler, and multi-channel seismic reflection data, supplemented by piston cores. Multibeam bathymetry data from the shelf show four crescent-shaped depressions (SD1 to SD4) and one near-circular depression (SD5) within a group of NW-SE trending depressions, the largest covering an area of about 7 km 2 on the seafloor. The depressions reach up to ~4.5 km in width and ~2 km in length and have asymmetric cross-sections. Some have depths as large as 40 m below the surrounding seafloor with walls as steep as 45°. The depressions are confined to water depths between 130 and 170 m and bounded on the north by a large submarine channel that was plausibly formed by fluvial or tidal processes during the Last Glacial Maximum (LGM) sea-level lowstand. Multi-channel seismic and sub-bottom profiler data reveal truncated depression walls and the presence of sediment drift deposits within the depressions, indicating that both erosion and deposition are active processes. Flaser and lenticular bedding in the cored drift deposits along with variable grain size (ranging between ~2.6 phi and ~4.3 phi) are diagnostic features of the bottom currents influenced by tidal forces. Depressions SD1 to SD4 lack evidence of fluid or gas escape. In contrast, many features of depression SD5 are characteristic of gas escapes and blowouts, including acoustic anomalies, a 20-m-high carbonate mound or carbonate-encrusted mound, and mud dikes and mud patches in cores. Based on the SD5 example, we think it is likely that the other crescent-shaped seafloor depressions formed originally as pockmarks by gas/fluid venting, and have since become inactive. The pockmarks represent zones of weakened sediment that were eroded, expanded, and merged by bottom currents to form larger seafloor depressions. Modern currents are strong enough to transport shelf sediments, and these currents were probably much stronger at lower sea levels when the Korea Strait was a more restricted passage between the East China Sea and East Sea.

Korea Strait↗