USGS2025
Geothermal energy is a clean and renewable resource that depends on the ability to move water through hot rock. In many locations, the ability to move water through rock requires the presence of extensive natural or human-made systems of fractures. However, these fracture systems are influenced by a variety of complex processes that occur at the temperature and pressure conditions found in geothermal reservoirs. To make geothermal systems more efficient, it is important to understand how these fractures evolve over time in response to these processes. This study explored how fractures in rock change under high-temperature and pressure conditions, like those found in geothermal reservoirs, through laboratory experiments and numerical simulations. In general fractures, tend to close due to pressure from the surrounding rock preventing the flow of water. One set of laboratory experiments revealed that fractures in granitic rock can weaken over time at elevated temperatures. These weak fractures can then slip slowly potentially keeping the fracture open for a longer period. This study also showed that at the highest temperature examined (250 °C) large differences between the chemical composition of the rock and the fluid moving through it could improve water flow temporarily likely due to the water dissolving parts of the rock. Flow rate predicted by models shows overall good agreement with the flow rate measured in our experiments but with some long time-scale variations that may be due to mechanical wear of the fracture surface. A second set of experiments found that, over the temperature range examined, the closure of fractures was caused by brittle failure driven by high stresses at points where fracture surfaces were in contact. This result suggests that fracture closure in geothermal reservoirs could be counteracted by maintaining high pore pressures. Additionally, we also tested a new method using electrical resistance to measure fracture closure in controlled systems with high precision.