USGS Science⌕ Search

Geology topics

D.M. Stephens

Publications and source records attributed to D.M. Stephens.

5 recordsLinked to original sources
USGS1988

Water levels in periodically measured wells in the Yucca Mountain area, Nye County, Nevada, 1981-87

This report contains data on groundwater levels beneath Yucca Mountain and adjacent areas, Nye County, Nevada. In addition to new data collected since 1983, the report contains data that has been updated from previous reports, including added explanations of the data. The data was collected in cooperation with the U.S. Department of Energy to help that agency evaluate the suitability of the area of storing high-level nuclear waste. The water table in the Yucca Mountain area occurs in ash-flow and air-fall tuff of Tertiary age. West of the crest of Yucca Mountain, water level altitudes are about 775 m above sea level. Along the eastern edge and southern end of Yucca Mountain, the potentiometric surface generally is nearly flat, ranging from about 730 to 728 m above sea level. (USGS)

Open-File Report↗
USGS1987

Comparison of irrigation pumpage with change in ground-water storage in the High Plains aquifer in Chase, Dundy, and Perkins counties, Nebraska, 1975-83

The relation between pumpage and change in storage was evaluated for most of a three-county area in southwestern Nebraska from 1975 through 1983. Initial comparison of the 1975-83 pumpage with change in storage in the study area indicated that the 1 ,042,300 acre-ft of change in storage was only about 30% of the 3,425,000 acre-ft of pumpage. An evaluation of the data used to calculate pumpage and change in storage indicated that there was a relatively large potential for error in estimates of specific yield. As a result, minimum and maximum values of specific yield were estimated and used to recalculate change in storage. Estimates also were derived for the minimum and maximum amounts of recharge that could occur as a result of cultivation practices. The minimum and maximum estimates for specific yield and for recharge from cultivation practices were used to compute a range of values for the potential amount of additional recharge that occurred as a result of irrigation. The minimum and maximum amounts of recharge that could be caused by irrigation in the study area were 953,200 acre-ft (28% of pumpage) and 2,611,200 acre-ft (76% of pumpage), respectively. These values indicate that a substantial percentage of the water pumped from the aquifer is resupplied to storage in the aquifer as a result of a combination of irrigation return flow and enhanced recharge from precipitation that results from cultivation and irrigation practices. (Author 's abstract)

Water-Resources Investigations Report↗
USGS1986

Evaluation of sampling methods used to estimate irrigation pumpage in Chase, Dundy, and Perkins counties, Nebraska

Combining estimates of applied irrigation water, determined for selected sample sites, with information on irrigated acreage provides one alternative for developing areal estimates of groundwater pumpage for irrigation. The reliability of this approach was evaluated by comparing estimated pumpage with metered pumpage for two years for a three-county area in southwestern Nebraska. Meters on all irrigation wells in the three counties provided a complete data set for evaluation of equipment and comparison with pumpage estimates. Regression analyses were conducted on discharge, time-of-operation, and pumpage data collected at 52 irrigation sites in 1983 and at 57 irrigation sites in 1984 using data from inline flowmeters as the independent variable. The standard error of the estimate for regression analysis of discharge measurements made using a portable flowmeter was 6.8% of the mean discharge metered by inline flowmeters. The standard error of the estimate for regression analysis of time of operation determined from electric meters was 8.1% of the mean time of operation determined from in-line and 15.1% for engine-hour meters. Sampled pumpage, calculated by multiplying the average discharge obtained from the portable flowmeter by the time of operation obtained from energy or hour meters, was compared with metered pumpage from in-line flowmeters at sample sites. The standard error of the estimate for the regression analysis of sampled pumpage was 10.3% of the mean of the metered pumpage for 1983 and 1984 combined. The difference in the mean of the sampled pumpage and the mean of the metered pumpage was only 1.8% for 1983 and 2.3% for 1984. Estimated pumpage, for each county and for the study area, was calculated by multiplying application (sampled pumpage divided by irrigated acreages at sample sites) by irrigated acreage compiled from Landsat (Land satellite) imagery. Estimated pumpage was compared with total metered pumpage for each county and the study area. Estimated pumpage by county varied from 9% less, to 20% more, than metered pumpage in 1983 and from 0 to 15% more than metered pumpage in 1984. Estimated pumpage for the study area was 11 % more than metered pumpage in 1983 and 5% more than metered pumpage in 1984. (Author 's abstract)

Water-Resources Investigations Report↗
USGS1984

Irrigation data from Chase, Dundy, and Perkins Counties, southwestern Nebraska, 1983

This report summarizes data collected by the U.S. Geological Survey in Chase, Dundy, and Perkins Counties, southwest Nebraska. It includes data collected from 52 randomly selected wells that were monitored during the 1983 irrigation season to obtain measurements of discharge and the rate of energy consumption. The data were collected as part of a study to better define the relationship between pumpage and return flow from applied water. (USGS)

Open-File Report↗