Geology topics

Brian Cardott

Publications and source records attributed to Brian Cardott.

3 recordsLinked to original sources

USGS2015

Unconventional energy resources: 2015 review. Shale gas and liquids

Introduction As the source rocks from which petroleum is generated, organic-rich shales have always been considered an important component of petroleum systems. Over the last few years, it has been realized that in some mudrocks, sufficient hydrocarbons remain in place to allow for commercial development, although advanced drilling and completion technology is typically required to access hydrocarbons from these reservoirs. Tight oil reservoirs (also referred to as continuous oil accumulations) contain hydrocarbons migrated from source rocks that are geologically/stratigraphically interbedded with or occur immediately overlying/underlying them. Migration is minimal in charging these tight oil accumulations (Gaswirth and Marra 2014 ). Companies around the world are now successfully exploiting organic-rich shales and tight rocks for contained hydrocarbons, and the search for these types of unconventional petroleum reservoirs is growing. Unconventional reservoirs range in geologic age from Ordovician to Tertiary (Silverman et al. 2005 ; EIA 2013a ).

Natural Resources Research↗

USGS2015

Standardization of reflectance measurements in dispersed organic matter: results of an exercise to improve interlaboratory agreement

Vitrinite reflectance generally is considered the most robust thermal maturity parameter available for application to hydrocarbon exploration and petroleum system evaluation. However, until 2011 there was no standardized methodology available to provide guidelines for vitrinite reflectance measurements in shale. Efforts to correct this deficiency resulted in publication of ASTM D7708: Standard test method for microscopical determination of the reflectance of vitrinite dispersed in sedimentary rocks . In 2012-2013, an interlaboratory exercise was conducted to establish precision limits for the D7708 measurement technique. Six samples, representing a wide variety of shale, were tested in duplicate by 28 analysts in 22 laboratories from 14 countries. Samples ranged from immature to overmature (0.31-1.53% R o ), from organic-lean to organic-rich (1-22 wt.% total organic carbon), and contained Type I (lacustrine), Type II (marine), and Type III (terrestrial) kerogens. Repeatability limits (maximum difference between valid repetitive results from same operator, same conditions) ranged from 0.03-0.11% absolute reflectance, whereas reproducibility limits (maximum difference between valid results obtained on same test material by different operators, different laboratories) ranged from 0.12-0.54% absolute reflectance. Repeatability and reproducibility limits degraded consistently with increasing maturity and decreasing organic content. However, samples with terrestrial kerogens (Type III) fell off this trend, showing improved levels of reproducibility due to higher vitrinite content and improved ease of identification. Operators did not consistently meet the reporting requirements of the test method, indicating that a common reporting template is required to improve data quality. The most difficult problem encountered was the petrographic distinction of solid bitumens and low-reflecting inert macerals from vitrinite when vitrinite occurred with reflectance ranges overlapping the other components. Discussion among participants suggested this problem could not be easily corrected via kerogen concentration or solvent extraction and is related to operator training and background. No statistical difference in mean reflectance was identified between participants reporting bitumen reflectance vs. vitrinite reflectance vs. a mixture of bitumen and vitrinite reflectance values, suggesting empirical conversion schemes should be treated with caution. Analysis of reproducibility limits obtained during this exercise in comparison to reproducibility limits from historical interlaboratory exercises suggests use of a common methodology (D7708) improves interlaboratory precision. Future work will investigate opportunities to improve reproducibility in high maturity, organic-lean shale varieties.

Marine and Petroleum Geology↗

USGS2014

Petrographic maturity parameters of a Devonian shale maturation series, Appalachian Basin, USA. ICCP Thermal Indices Working Group interlaboratory exercise

This paper presents results of an interlaboratory exercise on organic matter optical maturity parameters using a natural maturation series comprised by three Devonian shale samples (Huron Member, Ohio Shale) from the Appalachian Basin, USA. This work was conducted by the Thermal Indices Working Group of the International Committee for Coal and Organic Petrology (ICCP) Commission II (Geological Applications of Organic Petrology). This study aimed to compare: 1. maturation predicted by different types of petrographic parameters (vitrinite reflectance and spectral fluorescence of telalginite), 2. reproducibility of the results for these maturation parameters obtained by different laboratories, and 3. improvements in the spectral fluorescence measurement obtained using modern detection systems in comparison with the results from historical round robin exercises. Mean random vitrinite reflectance measurements presented the highest level of reproducibility (group standard deviation 0.05) for low maturity and reproducibility diminished with increasing maturation (group standard deviation 0.12). Corrected fluorescence spectra, provided by 14 participants, showed a fair to good correspondence. Standard deviation of the mean values for spectral parameters was lowest for the low maturity sample but was also fairly low for higher maturity samples. A significant improvement in the reproducibility of corrected spectral fluorescence curves was obtained in the current exercise compared to a previous investigation of Toarcian organic matter spectra in a maturation series from the Paris Basin. This improvement is demonstrated by lower values of standard deviation and is interpreted to reflect better performance of newer photo-optical measuring systems. Fluorescence parameters measured here are in good agreement with vitrinite reflectance values for the least mature shale but indicate higher maturity than shown by vitrinite reflectance for the two more mature shales. This red shift in λ max beyond 0.65% vitrinite reflectance was also observed in studies of Devonian shale in other basins, suggesting that the accepted correlation for these two petrographic thermal maturity parameters needs to be re-evaluated. A good linear correlation between λ max and T max for this maturation series was observed and λ max 600 nm corresponds to T max of 440 °C. Nevertheless if a larger set of Devonian samples is included, the correlation is polynomial with a jump in λ max ranging from 540 to 570 nm. Up to 440 °C of T max , the λ max , mostly, reaches up to 500 nm; beyond a T max of 440 °C, λ max is in the range of 580–600 nm. This relationship places the “red shift” when the onset of the oil window is reached at T max of 440 °C. Moreover, the correlation between HI and λ max (r 2 = 0.70) shows a striking inflection and decrease in HI above a λ max of 600 nm, coincident with the approximate onset of hydrocarbon generation in these rocks.

International Journal of Coal Geology↗