USGS ScienceSearch

Geology topics

Blaza Toman

Publications and source records attributed to Blaza Toman.

2 recordsLinked to original sources

USGS44, a new high-purity calcium carbonate reference material for δ13C measurements

Rationale The stable carbon isotopic ( δ 13 C) reference material (RM) LSVEC Li 2 CO 3 has been found to be unsuitable for δ 13 C standardization work because its δ 13 C value increases with exposure to atmospheric CO 2 . A new CaCO 3 RM, USGS44, has been prepared to alleviate this situation. Methods USGS44 was prepared from 8 kg of Merck high-purity CaCO 3 . Two sets of δ 13 C values of USGS44 were determined. The first set of values was determined by online combustion, continuous-flow (CF) isotope-ratio mass spectrometry (IRMS) of NBS 19 CaCO 3 ( δ 13 C VPDB = +1.95 milliurey (mUr) exactly, where mUr = 0.001 = 1‰), and LSVEC Li 2 CO 3 ( δ 13 C VPDB = −46.6 mUr exactly), and normalized to the two-anchor δ 13 C VPDB-LSVEC isotope-delta scale. The second set of values was obtained by dual-inlet (DI)-IRMS of CO 2 evolved by reaction of H 3 PO 4 with carbonates, corrected for cross contamination, and normalized to the single-anchor δ 13 C VPDB scale. Results USGS44 is stable and isotopically homogeneous to within 0.02 mUr in 100-μg amounts. It has a δ 13 C VPDB-LSVEC value of −42.21 ± 0.05 mUr. Single-anchor δ 13 C VPDB values of −42.08 ± 0.01 and −41.99 ± 0.02 mUr were determined by DI-IRMS with corrections for cross contamination. Conclusions The new high-purity, well-homogenized calcium carbonate isotopic reference material USGS44 is stable and has a δ 13 C VPDB-LSVEC value of −42.21 ± 0.05 mUr for both EA/IRMS and DI-IRMS measurements. As a carbonate relatively depleted in 13 C, it is intended for daily use as a secondary isotopic reference material to normalize stable carbon isotope delta measurements to the δ 13 C VPDB-LSVEC scale. It is useful in quantifying drift with time, determining mass-dependent isotopic fractionation (linearity correction), and adjusting isotope-ratio-scale contraction. Due to its fine grain size (smaller than 63 μm), it is not suitable as a δ 18 O reference material. A δ 13 C VPDB-LSVEC value of −29.99 ± 0.05 mUr was determined for NBS 22 oil.

Rapid Communications in Mass Spectrometry

New organic reference materials for hydrogen, carbon, and nitrogen stable isotope-ratio measurements: caffeines, n-alkanes, fatty acid methyl esters, glycines, L-valines, polyethylenes, and oils

An international project developed, quality-tested, and determined isotope−δ values of 19 new organic reference materials (RMs) for hydrogen, carbon, and nitrogen stable isotope-ratio measurements, in addition to analyzing pre-existing RMs NBS 22 (oil), IAEA-CH-7 (polyethylene foil), and IAEA-600 (caffeine). These new RMs enable users to normalize measurements of samples to isotope−δ scales. The RMs span a range of δ 2 H VSMOW-SLAP values from −210.8 to +397.0 mUr or ‰, for δ 13 C VPDB-LSVEC from −40.81 to +0.49 mUr and for δ 15 N Air from −5.21 to +61.53 mUr. Many of the new RMs are amenable to gas and liquid chromatography. The RMs include triads of isotopically contrasting caffeines, C 16 n -alkanes, n -C 20 -fatty acid methyl esters (FAMEs), glycines, and l -valines, together with polyethylene powder and string, one n -C 17 -FAME, a vacuum oil (NBS 22a) to replace NBS 22 oil, and a 2 H-enriched vacuum oil. A total of 11 laboratories from 7 countries used multiple analytical approaches and instrumentation for 2-point isotopic normalization against international primary measurement standards. The use of reference waters in silver tubes allowed direct normalization of δ 2 H values of organic materials against isotopic reference waters following the principle of identical treatment. Bayesian statistical analysis yielded the mean values reported here. New RMs are numbered from USGS61 through USGS78, in addition to NBS 22a. Because of exchangeable hydrogen, amino acid RMs currently are recommended only for carbon- and nitrogen-isotope measurements. Some amino acids contain 13 C and carbon-bound organic 2 H-enrichments at different molecular sites to provide RMs for potential site-specific isotopic analysis in future studies.

Analytical Chemistry