USGS Science⌕ Search

Geology topics

Arthur F. McGarr

Publications and source records attributed to Arthur F. McGarr.

24 records · Page 2Linked to original sources
USGS2009

Broadband records of earthquakes in deep gold mines and a comparison with results from SAFOD, California

For one week during September 2007, we deployed a temporary network of field recorders and accelerometers at four sites within two deep, seismically active mines. The ground-motion data, recorded at 200 samples/sec, are well suited to determining source and ground-motion parameters for the mining-induced earthquakes within and adjacent to our network. Four earthquakes with magnitudes close to 2 were recorded with high signal/noise at all four sites. Analysis of seismic moments and peak velocities, in conjunction with the results of laboratory stick-slip friction experiments, were used to estimate source processes that are key to understanding source physics and to assessing underground seismic hazard. The maximum displacements on the rupture surfaces can be estimated from the parameter , where is the peak ground velocity at a given recording site, and R is the hypocentral distance. For each earthquake, the maximum slip and seismic moment can be combined with results from laboratory friction experiments to estimate the maximum slip rate within the rupture zone. Analysis of the four M 2 earthquakes recorded during our deployment and one of special interest recorded by the in-mine seismic network in 2004 revealed maximum slips ranging from 4 to 27 mm and maximum slip rates from 1.1 to 6.3 m/sec. Applying the same analyses to an M 2.1 earthquake within a cluster of repeating earthquakes near the San Andreas Fault Observatory at Depth site, California, yielded similar results for maximum slip and slip rate, 14 mm and 4.0 m/sec.

Bulletin of the Seismological Society of America↗
USGS2009

Extension of Gutenberg‐Richter distribution to MW −1.3, no lower limit in sight

With twelve years of seismic data from TauTona Gold Mine, South Africa, we show that mining‐induced earthquakes follow the Gutenberg‐Richter relation with no scale break down to the completeness level of the catalog, at moment magnitude M W −1.3. Events recorded during relatively quiet hours in 2006 indicate that catalog detection limitations, not earthquake source physics, controlled the previously reported minimum magnitude in this mine. Within the Natural Earthquake Laboratory in South African Mines (NELSAM) experiment's dense seismic array, earthquakes that exhibit shear failure at magnitudes as small as M W −3.9 are observed, but we find no evidence that M W −3.9 represents the minimum magnitude. In contrast to previous work, our results imply small nucleation zones and that earthquake processes in the mine can readily be scaled to those in either laboratory experiments or natural faults.

TauTona Mine↗
USGS2009

A deployment of broadband seismic stations in two deep gold mines, South Africa

In-mine seismic networks throughout the TauTona and Mponeng gold mines provide precise locations and seismic source parameters of earthquakes. They also support small-scale experimental projects, including NELSAM (Natural Earthquake Laboratory in South African Mines), which is intended to record, at close hand, seismic rupture of a geologic fault that traverses the project region near the deepest part of TauTona. To resolve some questions regarding the in-mine and NELSAM networks, we deployed four portable broadband seismic stations at deep sites within TauTona and Mponeng for one week during September 2007 and recorded ground acceleration. Moderately large earthquakes within our temporary network were recorded with sufficiently high signal-to-noise that we were able to integrate the acceleration to ground velocity and displacement, from which moment tensors could be determined. We resolved the questions concerning the NELSAM and in-mine networks by using these moment tensors to calculate synthetic seismograms at various network recording sites for comparison with the ground motion recorded at the same locations. We also used the peak velocity of the S wave pulse, corrected for attenuation with distance, to estimate the maximum slip within the rupture zone of an earthquake. We then combined the maximum slip and seismic moment with results from laboratory friction experiments to estimate maximum slip rates within the same high-slip patches of the rupture zone. For the four largest earthquakes recorded within our network, all with magnitudes near 2, these inferred maximum slips range from 4 to 27 mm and the corresponding maximum slip rates range from 1 to 6 m/s. These results, in conjunction with information from previous ground motion studies, indicate that underground support should be capable of withstanding peak ground velocities of at least 5 m/s.

Mponeng gold mine, TauTona gold mine↗
USGS2006

An overview of the global variability in radiated energy and apparent stress

a global study of radiated seismic energies ER and apparent stresses τ a reveals systematic patterns. earthquakes with the highest apparent stress occur in regions of intense deformation and rupture strong lithosphere. in oceanic settings, these are strike-slip earthquakes (τ a up to 27 Mpa) occurring intraplate or at evolving ends of transform faults. at subduction zones and intracontinental settings, these are strike slip earthquakes with τ a up to 7 Mpa. normal-fault earthquakes exhibit a more complex pattern. higher τ a ’s (up to5Mpa) are found for intraslab events at depths from 35 to 70 km that occur near zones of intense deformation such as a sharp slab bend or the juncture of colliding slabs. lower τ a ’s (< 1 Mpa) are found for normal-fault earthquakes at the outer rise and outer trench wall or deep in flat warm slabs. the lowest average τ a (0.3 Mpa) is found for thrust-fault earthquakes at subduction zones. the variation of average apparent stress with tectonics suggests a relationship with lithospheric strength and fault maturity. Mature faults, such as plate boundaries that have experienced large cumulative slip, appear to have low strength and tend to yield earthquakes with low apparent stresses. immature faults, in contrast, are stronger and yield high apparent stresses because either they are the result of fresh-rock fracture or at least their cumulative fault slip is quite small. these results have implications of use to the seismic engineering community because ER and its magnitude counterpart Me are reliable indicators of the potential for damaging ground motion.

Book chapter↗