USGS Science⌕ Search

Geology topics

A. Schimmelmann

Publications and source records attributed to A. Schimmelmann.

26 records · Page 2Linked to original sources
USGS2006

D/H ratios and hydrogen exchangeability of type-II kerogens with increasing thermal maturity

Stable isotope ratios of non-exchangeable hydrogen (??Dn) and of carbon were measured in type-II kerogens from two suites of Late Devonian to Early Mississippian black shale, one from the New Albany Shale (Illinois Basin) and the other from the Exshaw Formation (Alberta Basin). The largely marine-derived organic matter had similar original stable isotope ratios, but today the suites of kerogens express gradients in thermal maturity that have altered their chemical and isotopic compositions. In both suites, ??D n values increase with maturation up to a vitrinite reflectance of Ro 1.5%, then level out. Increasing ??Dn values suggest isotopic exchange of organic hydrogen with water-derived deuterium and/or preferential loss of 1H-enriched chemical moieties from kerogen during maturation. The resulting changes in ??Dn values are altering the original hydrogen isotopic paleoenvironmental signal in kerogen, albeit in a systematic fashion. The specific D/H response of each kerogen suite through maturation correlates with H/C elemental ratio and can therefore be corrected to yield paleoenvironmentally relevant information for a calibrated system. With increasing thermal maturity, the abundance of hydrogen in the kerogen that is isotopically exchangeable with water hydrogen (expressed as Hex, in % of total hydrogen) first decreases to reach a minimum at Ro ??? 0.8-1.1%, followed by a substantial increase at higher thermal maturity. ?? 2005 Elsevier Ltd. All rights reserved.

Organic Geochemistry↗
USGS2005

FTIR absorption indices for thermal maturity in comparison with vitrinite reflectance R0 in type-II kerogens from Devonian black shales

FTIR absorbance signals in kerogens and macerals were evaluated as indices for thermal maturity. Two sets of naturally matured type-II kerogens from the New Albany Shale (Illinois Basin) and the Exshaw Formation (Western Canada Sedimentary Basin) and kerogens from hydrous pyrolysis artificial maturation of the New Albany Shale were characterized by FTIR. Good correlation was observed between the aromatic/aliphatic absorption ratio and vitrinite reflectance R 0. FTIR parameters are especially valuable for determining the degree of maturity of marine source rocks lacking vitrinite. With increasing maturity, FTIR spectra express four trends: (i) an increase in the absorption of aromatic bands, (ii) a decrease in the absorption of aliphatic bands, (iii) a loss of oxygenated groups (carbonyl and carboxyl), and (iv) an initial decrease in the CH2/CH3 ratio that is not apparent at higher maturity in naturally matured samples, but is observed throughout increasing R0 in artificially matured samples. The difference in the CH2/CH 3 ratio in samples from natural and artificial maturation at higher maturity indicates that short-term artificial maturation at high temperatures is not fully equivalent to slow geologic maturation at lower temperatures. With increasing R0, the (carboxyl + carbonyl)/aromatic carbon ratio generally decreases, except that kerogens from the Exshaw Formation and from hydrous pyrolysis experiments express an intermittent slight increase at medium maturity. FTIR-derived aromaticities correlate well with R0, although some uncertainty is due to the dependence of FTIR parameters on the maceral composition of kerogen whereas R0 is solely dependent on vitrinite. ?? 2005 Elsevier Ltd. All rights reserved.

Organic Geochemistry↗
USGS2005

Thermal maturity of type II kerogen from the New Albany Shale assessed by13C CP/MAS NMR

Thermal maturity of oil and gas source rocks is typically quantified in terms of vitrinite reflectance, which is based on optical properties of terrestrial woody remains. This study evaluates 13C CP/MAS NMR parameters in kerogen (i.e., the insoluble fraction of organic matter in sediments and sedimentary rocks) as proxies for thermal maturity in marine-derived source rocks where terrestrially derived vitrinite is often absent or sparse. In a suite of samples from the New Albany Shale (Middle Devonian to the Early Mississippian, Illinois Basin) the abundance of aromatic carbon in kerogen determined by 13C CP/MAS NMR correlates linearly well with vitrinite reflectance. ?? 2004 Elsevier Inc. All rights reserved.

Solid State Nuclear Magnetic Resonance↗
USGS2003

Chemical and isotopic properties of kukersites from Iowa and Estonia

Kukersite samples from Estonia and Iowa were analyzed for elemental composition, functional group distribution, and carbon and hydrogen stable isotope ratios. The elemental and hydrogen isotope values, together with other analytical data, suggest a higher thermal maturity for the Iowa kukersite. The wide carbon isotopic range of 9.3??? among kukersites, with unusually negative ??13C values reaching -33.2???, indicates isotopically variable carbon sources for production of biomass, and thus major paleoceanographic differences between the environments supporting biosynthesis. ?? 2003 Elsevier Ltd. All rights reserved.

Organic Geochemistry↗
USGS2002

Isotopically exchangeable organic hydrogen in coal relates to thermal maturity and maceral composition

Hydrogen isotopic exchangeability (Hex) and ??Dn values of non-exchangeable organic hydrogen were investigated in coal kerogens ranging in rank from lignite to graphite. The relative abundance of Hex is highest in lignite with about 18% of total hydrogen being exchangeable, and decreases to around 2.5% in coals with Ro of 1.7 to ca. 5.7%. At Still higher rank (Ro > 6%), Hex increases slightly, although the abundance of total hydrogen decreases. ??Dn is influenced by original biochemical D/H ratios and by thermal maturation in contact with water. Therefore, ??Dn does not show an overall consistent trend with maturity. ?? 2002 Elsevier Science Ltd. All rights reserved.

Organic Geochemistry↗
USGS2001

Experimental controls on D/H and 13C/12C ratios of kerogen, bitumen and oil during hydrous pyrolysis

Large isotopic transfers between water-derived hydrogen and organic hydrogen occurred during hydrous pyrolysis experiments of immature source rocks, in spite of only small changes in organic 13C/12C. Experiments at 330 ??C over 72 h using chips or powder containing kerogen types I and III identify the rock/water ratio as a main factor affecting ????D for water and organic hydrogen. Our data suggest that larger rock permeability and smaller rock grain size increase the H-isotopic transfer between water-derived hydrogen and thermally maturing organic matter. Increasing hydrostatic pressure may have a similar effect, but the evidence remains inconclusive. ?? 2001 Elsevier Science Ltd. All rights reserved.

Organic Geochemistry↗
USGS1999

D/H isotope ratios of kerogen, bitumen, oil, and water in hydrous pyrolysis of source rocks containing kerogen types I, II, IIS, and III

Immature source rock chips containing different types of kerogen (I, II, IIS, III) were artificially matured in isotopically distinct waters by hydrous pyrolysis and by pyrolysis in supercritical water. Converging isotopic trends of inorganic (water) and organic (kerogen, bitumen, oil) hydrogen with increasing time and temperature document that water-derived hydrogen is added to or exchanged with organic hydrogen, or both, during chemical reactions that take place during thermal maturation. Isotopic mass-balance calculations show that, depending on temperature (310–381°C), time (12–144 h), and source rock type, between ca. 45 and 79% of carbon-bound hydrogen in kerogen is derived from water. Estimates for bitumen and oil range slightly lower, with oil–hydrogen being least affected by water-derived hydrogen. Comparative hydrous pyrolyses of immature source rocks at 330°C for 72 h show that hydrogen in kerogen, bitumen, and expelled oil/wax ranks from most to least isotopically influenced by water-derived hydrogen in the order IIS > II ≈ III > I. Pyrolysis of source rock containing type II kerogen in supercritical water at 381°C for 12 h yields isotopic results that are similar to those from hydrous pyrolysis at 350°C for 72 h, or 330°C for 144 h. Bulk hydrogen in kerogen contains several percent of isotopically labile hydrogen that exchanges fast and reversibly with hydrogen in water vapor at 115°C. The isotopic equilibration of labile hydrogen in kerogen with isotopic standard water vapors significantly reduces the analytical uncertainty of D/H ratios when compared with simple D/H determination of bulk hydrogen in kerogen. If extrapolation of our results from hydrous pyrolysis is permitted to natural thermal maturation at lower temperatures, we suggest that organic D/H ratios of fossil fuels in contact with formation waters are typically altered during chemical reactions, but that D/H ratios of generated hydrocarbons are subsequently little or not affected by exchange with water hydrogen at typical reservoir conditions over geologic time. It will be difficult to utilize D/H ratios of thermally mature bulk or fractions of organic matter to quantitatively reconstruct isotopic aspects of paleoclimate and paleoenvironment. Hope resides in compound-specific D/H ratios of thermally stable, extractable biomarkers (“molecular fossils”) that are less susceptible to hydrogen exchange with water-derived hydrogen.

Geochimica et Cosmochimica Acta↗